10 DS1183-013A
BUTTON FUNCTIONS
State
Button
STAND-BY
WAITING
FOR PICK-UP
(RECEIVING
CALL)
DURING AUDIO OPERATION
STAND-BY
AND BUTTON
PRESSED
STATE OF
PROGRAMMING*
(ONLY WITH
DOOR PHONE IN
STAND-BY)
Open
pedestrian
door
Open
pedestrian
door Open pedestrian door Open
pedestrian
door
Connect / disconnect the
automatic door opening
system
--- Audio
activation
If pressed in the operating mode:
A) “Hands Free” ends the
conversation;
B) in “Push to talk”:
if pressed a long time, it
enables the audio of the door
unit;
if short pressed it activates or
terminates the conversation.
—
—
---
Call volume adjustment
for door and floor level
calls (the possible volume
adjustments are, in this
order, HIGH, LOW, MUTE)
Special
function
(default: 7)
Special
function
(default: 7) Special function (default: 7)
Programmable
intercom call
2 (Default: not
programmed)
Floor call ring tone
selection (5 different ring
tones)
Garage door
opener Garage door
opener Garage door opener
Programmable
intercom call 1
(Default: call to
switchboard)
Door phone call ring tone
(5 different ring tones)
(*) To enter and exit programming state, hold button pressed for longer than 5 seconds. The yellow LED
will blink slowly to indicate that programming mode is selected. Programming mode will shut down in all
cases after the 10 minute timeout.
INDICATOR LEDS
6. Multicolour indicator LED
PRIORITY FUNCTIONS
1 Fast flashing red: muted ring tones
2 Green blinking: automatic door opener on
3 Red on steady: main calling station door open
4 Slowly blinking red: secondary calling station door open
5 Slowly blinking yellow: programming state on
To save the programming, remember to exit from the same by pressing the button for more
then 5 seconds; in any case, after 10 minutes the device exists the programming state and saves
the parameters changed. Refer to the system booklet for how to program intercom calls.
9. Green LED under the button
On steady: call in progress
On blinking: conversation ongoing
11. Green LED under the button
On steady: possibility of a door opening
RESET
To restore default parameters of the device after entering programming mode, hold button pressed for
longer than 5 seconds, press the and buttons together for longer than 3 seconds. The system will
emit 2 long beeps to confirm and exit the programming state.
