206-3 -- Wireless
Entry/Exit Signal Kit
Instruction Sheet
Troubleshooting
PHONE: (203) 730-1756
FAX: (203) 730-1781
2 PARKLAWN DR. STE F, BETHEL, CT 06801
www.trineonline.com
NOTE: This unit is NOT compatible with 206-3
units sold before December, 2014
For swinging doors
align the transmitter
arrow to the bottom
of the magnet
as shown.
V. 16.0504
• Transmitter
communicates with the
chime wirelessly.
• Can be used with swinging
or sliding doors
• Chime plugs into a
standard electric outlet
• Includes a Door Magnet
Spacer and all the
mounting screws
• Transmitter range: 100’
• Three High Quality Chime
tunes
• (1) 12V A23 Battery is
included
A. Problem: Chime does not ring one time
and stop.
1a. Possible Cause: Sensor battery is not
installed properly.
1b. Fix: Make sure battery is installed
according to the diagram inside sensor.
2a. Possible Cause: Sensor battery is dead.
2b. Fix: Replace sensor battery.
3a. Possible Cause: Chime is not receiving
power
3b. Fix: Make sure the plug-in chime has
power
4a. Possible Cause: Sensor & Chime are not
synced
4b. Fix: Re-try syncing process
- Unplug chime
- Ensure switch 1 on both chime and
sensor is set to OFF
- Wait 30 Seconds
- Press and hold the “TEST” button
inside the sensor within 20 seconds after
plugging in chime. When the “Ding-dong”
tune is played, the sensor is synced with
the chime.
B. Problem: Battery seems okay but the chime
does not work after installation.
1a. Possible Cause: Chime or Transmitter is
mounted on metal or near metal studs.
(metal reduces range of unit)
1b. Fix: Use a 1/4” to 1/2” wooden shim to to
move Transmitter away from metal surface.
Move Chime to another wall outlet.
2a. Possible Cause: Chime or Transmitter is
mounted near concrete. (concrete reduces
range of unit)
2b. Fix: Move away from concrete
3a. Possible Cause: Chime & Transmitter are
installed too far apart (over 100 feet)
3b. Fix: relocate pieces closer to one another.
C. Problem: Chime sounds when not intended.
1. Possible Cause: Chime or Transmitter is
receiving interference
2. Fix: Follow A. Problem - 4b. Fix to Unsync the
unit
- Follow A. Problem - 4b. Fix Again to
Resync the units
- If problem persists move Chime or
Transmitter to another location to reduce
interference.
FEATURES:
NOTE: This unit is NOT
compatible with 206-3
units sold before
December, 2014
