TRENDnet TEW-510APB User manual
Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
TRENDnet
TRENDware, USA
What's Next in Networking
TEW-510APB
Version 05.19.2005
Super A+G Access Point Quick Installation Guide
Point d'accès Super A+G Guide d'installation rapide
Super A+G Access Point Kurzanleitung zur Installation
Punto de Acceso Súper A+G Guía de instalación rápida
Точка доступа Super A+G Руководство по быстрой установке
Table of Contents
English ......................................................................................................
Troubleshooting...........................................................................................
1
1
2
3
5
8
1. Prepare for Installation ......................................................................
2. Install Hardware ................................................................................
3. Configure TCP/IP Settings ................................................................
4. Configure the Access Point ...............................................................
Thank you for purchasing TRENDnet's TEW-510APB Super A+G Access Point
This guide will help you set-up your Access Point quickly and easily. Just follow
the step-by-step instructions below, and enjoy the benefits of accessing the
Internet without ever being tied down to wires! If you run into problems, please
refer to the Troubleshooting section. If you need further technical support,
please visit www.TRENDNET.com or call technical support by phone.
Verify Equipment
Before setting up the Access Point, you should have:
1. A Computer with a Wired (Rj45) or Wireless network card.
2. TCP/IP protocol installed on the Computer.
3. A Web Browser such as Internet Explorer (5.0 or higher) or
Netscape Navigator (4.7 or higher).
4. A Hub or Switch connecting your existing wired network.
5. An RJ-45 Network Cable for connecting the Access Point to your
network Switch.
Verify Package Contents
Please make sure you have everything in the box:
1
External Power Adapter 1.5M RJ45 cable
CD-ROM (User’s Guide)
Quick Installation Guide
TEW-510APB
1. Prepare for Installation
English QIG
English
Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
TRENDnet
TRENDware, USA
What's Next in Networking
TEW-510APB
Version 05.19.2005
Super A+G Access Point Quick Installation Guide
Point d'accès Super A+G Guide d'installation rapide
Super A+G Access Point Kurzanleitung zur Installation
Punto de Acceso Súper A+G Guía de instalación rápida
Точка доступа Super A+G Руководство по быстрой установке
2
1. Locate an optimum location for the Access Point. The best place for the
Access Point is usually at the center of your wireless network.
2. Connect the RJ-45 network cable to the Access Point, then connect the
other end of the network cable to a Switch or Hub. The Access Point is now
connected to your 10/100Mbps network.
3. Connect the power adapter to the Access Point. Make sure you use the
power adapter supplied with the Access Point; using a different power
adapter may damage the unit.
2. Install Hardware
Check to make sure the following Access Point front panel lights are on: Power,
LAN, WLAN.
Verify Hardware Installation
NOTE: If you are using a wired computer to configure the Access Point,
please connect this computer to the same Switch or Hub the
TEW-510APB is connected to.
POWER LAN
WLAN
2
TEW-510APB
English
3
3
3. Configure TCP/IP Settings
Before the Access Point can be accessed and configured, the computer's
TCP/IP settings need to be changed. (That includes your wireless card's IP
address, too.)
English
Windows 2000/XP
1. Find the Start button located on the Desktop.
2. Click Start, and click on Control Panel. For Windows 2000, click Start,
highlight Settings, and click Control Panel.
3. Double-Click the Network Connection icon.
4. Right-Click on the Local Area Connection icon, then click on Properties.
The Local Area Connection Properties box will appear.
4
6. Click on Use the following IP address. Enter 192.168.1.50 for IP
address and 255.255.255.0 for Subnet, then click OK.
7. Click OK.
8. Your computer is now ready to access and configure the Access Point.
5. Under the General tab, locate and select Internet Protocol TCP/IP and
then click Properties. The Internet Protocol (TCP/IP) Properties box will
appear.
English
5
4. Configure the Access Point
From a Wired Computer
1. Open a web browser (Internet Explorer or Netscape) and enter
http://192.168.1.250 at the address bar, then press the Enter key. Leave the
username field blank, and type admin for your password.
If you are configuring the TEW-510APB through a wired computer, follow steps
1-3. If you are configuring the TEW-510APB through a wireless computer,
follow steps 4-7.
English
2. Click Wireless. Enter any AP Name for your Access Point. Create a SSID
that your wireless network will be using, and select a channel. (For example:
Wireless AP, Home AP, or Office AP). Scroll down to the bottom of the page
and click Apply.
6
3. Click Setup. If your current network belongs to a different network segment
(i.e. 192.168.0.1~254), please type an IP address, Subnet Mask, and a
Default Gateway (i.e. Router's IP Address). Click Apply. If you are content
with the TEW-510APB's current settings, please proceed to the next section.
English
From a Wireless Computer
(using TRENDnet's TEW-501PC as example in this section)
The default settings of the Access Point are:
SSID wlan-a
Channel - 6
4. On your wireless computer, open up your Wireless Utility Program.
5. Click AP List, select wlan-a, and click Connect.
7English
6. Click Link Information and verify that your wireless PC is communicating
with the TEW-510APB.
7. Go to the beginning of section 4. Configure the Access Point and follow
steps 1-3.
8
Troubleshooting
Q1:
A1:
Q2:
A2:
Q3.
A3:
Q4.
A4:
I specified the IP address http://192.168.1.100 in my internet
browser's address bar, but error message says "The page cannot be
displayed". How can I get into the TEW-510APB's web configuration
page?
Please check your hardware and TCP/IP settings again by following
the instructions sections 1~3, make sure the Power, WAN, WLAN on the
Access Point's front panel are on and the TCP/IP configurations are correct.
then try accessing http://192.168.1.100 again.
If my network's IP is different than the Access Point's range, what
should I do?
You should still configure the access point first. After all the settings
are applied, go to the Access Point's configuration page, click on TCP/IP
settings and change an IP address for the Access Point to match your
network's IP.
After I successfully configured the Access Point to meet my network
settings, I cannot connecting to my network using wireless computers.
If you have a DHCP server in your network, you need to go into TCP/IP
settings again and re-select "Obtain an IP automatically" for
Windows 98/ME and "Obtain an IP Address automatically" for Windows
2000/XP to allow the PC to regain an IP address from your DHCP server.
All the settings are set correct, but I still can't use the Access Point,
what should I do?
You can find additional information in the User's Guide. If you still have
Problems, contact our Technical Support by email or phone.
Certifications
This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received.
Including interference that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE
EQUIPMENT.
Other manuals for TEW-510APB
3
Other TRENDnet Wireless Access Point manuals
TRENDnet
TRENDnet TEW-636APB User manual
TRENDnet
TRENDnet TEW-815DAP User manual
TRENDnet
TRENDnet TEW-610APB User manual
TRENDnet
TRENDnet TEW-AP100 User manual
TRENDnet
TRENDnet TEW-410APBplus User manual
TRENDnet
TRENDnet TEW-650AP User manual
TRENDnet
TRENDnet TEW-630APB - Wireless Access Point User manual
TRENDnet
TRENDnet TEW-455APBO - 9dBi High Power Wireless Outdoor PoE Access... User manual
TRENDnet
TRENDnet TEW-653AP User manual
TRENDnet
TRENDnet TEW-825DAP(V1) User manual
TRENDnet
TRENDnet TEW-210APB User manual
TRENDnet
TRENDnet TEW-410APB User manual
TRENDnet
TRENDnet TEW-455APBO - 9dBi High Power Wireless Outdoor PoE Access... User manual
TRENDnet
TRENDnet TPL-110AP - 125Mbps 802.11g Wireless Powerline Access... User manual
TRENDnet
TRENDnet TPL-410AP User manual
TRENDnet
TRENDnet TEW-740APBO User manual
TRENDnet
TRENDnet TEW-435BRM - 54MBPS 802.11G Adsl Firewall M User manual
TRENDnet
TRENDnet TEW-410APBplus User manual
TRENDnet
TRENDnet TEW-676APBO User manual
TRENDnet
TRENDnet TEW-412APBO User manual
