TRENDnet TW100-S4W1CA User manual

FCC Warning

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a commercial environment.

This equipment generates, uses and radiates radio frequency energy. If not

installed and used in accordance with the instructions, it may cause

harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference. In

this case the user will be required to correct the interference at their own

expense.

CE Mark Warning

This is a Class B product. In a domestic environment, this product may

cause radio interference, in which case the user may be required to take

adequate measures.

VCCI Warning

P/N: Rev.A1-01

TABLE OF CONTENTS

About This Guide...............................................................................................................1

Purpose..........................................................................................................................1

Overview of this User’s Guide......................................................................................1

Introduction ........................................................................................................................3

Applications: .................................................................................................................3

Features: ........................................................................................................................4

Unpacking and Setup .........................................................................................................5

Unpacking .....................................................................................................................5

Setup..............................................................................................................................5

Hardware Installation.........................................................................................................7

Front Panel ....................................................................................................................7

Rear Panel......................................................................................................................8

Hardware connections...................................................................................................9

Connect the Internet Broadband Router ..................................................................9

Check the installation.............................................................................................10

PC Network TCP/IP Setting.............................................................................................11

Windows 95/98/ME ....................................................................................................11

Windows XP/2000 ......................................................................................................13

Windows NT4.0 ..........................................................................................................14

Internet Broadband Router Configuration .......................................................................15

Quick Setup.................................................................................................................16

Advanced Setup...........................................................................................................19

Technical Specifications ..................................................................................................34

LIMITED WARRANTY .................................................................................................35

ABOUT THIS GUIDE

Congratulations on your purchase of this Cable/DSL 4-port Broadband

Router. This device integrates 100Mbps Fast Ethernet and 10Mbps

Ethernet network capabilities. This router is a complete solution for

sharing the Internet and other office resources.

Purpose

This manual discusses how to install the 4-port Broadband Router.

Overview of this User’s Guide

Introduction. Describes the Broadband Router and its features.

Unpacking and Setup. Helps you get started with the basic installation of

the Router.

Identifying External Components. Describes the front panel, rear panel,

and LED indicators of the Router.

Connecting the Router. Explains how you connect the Router to your

xDSL/Cable Modem.

Technical Specifications. Lists the technical (general, physical and

environmental, performance and Routers settings) specifications of the

Broadband Router.

INTRODUCTION

With the explosive growth of the Internet, accessing information and

services at any time, day or night, has become standard fare for most

people. The era of the standalone PC is waning. Networking technology is

moving out of the exclusive domain of corporations and into homes with

at least two computers.

Broadband network access is also gaining ground. Allowing more than

two computers to access the Internet at the same time, however, has

typically entailed significantly higher costs. Thus, there is a great demand

for technology that enables users to share a single Internet connection.

Employing a router to share an Internet connection solves the problem of

high network access costs. Using such a device, each networked computer

is able to make full use of broadband capabilities.

This device not only comes equipped with a wide range of features but

also can be installed and configured right out of the box. This device

supports a simple local area network and Internet access sharing.

A local area network connects home computers and enables users to

access the Internet, share resources, and play online games – the essentials

of the family computing lifestyle.

Applications:

Broadband Internet access sharing:

Enable several computers to share a single high-speed broadband Internet

connection (LAN and WAN-Internet).

Resource sharing:

Share printers, scanners, and other peripherals.

File sharing:

Exchange data, messages, and files -- thus making good use of hard disk

space.

Online gaming:

Your local area network allows you to play online games and use e-

commerce services.

Firewall:

A built-in firewall function protects against hackers.

Features:

¾High speed data transfer rate, FTP up to 40Mbps

¾Supports NAT (sharing one IP address with all LAN users)

¾Supports PPPoE and PPTP protocol for Dial-Up ADSL

¾Supports DHCP Server / Client

¾Supports UPnP (Universal Plug and Play)

¾Supports virtual server mapping

¾Supports packet filtering

¾Simple Firewall protection

¾Upgradeable firmware for future functions

¾Easy configuration via Web Browser.

UNPACKING AND SETUP

This chapter provides unpacking and setup information for the Broadband

Router.

Unpacking

The box should contain the following items:

One 4-port High Speed Broadband Router

One external power adapter (5V DC, 800mA)

One CD-ROM with User’s Guide

Quick Installation Guide

If any item is found missing or damaged, please contact your local reseller

for replacement.

Setup

The setup of the Broadband Router can be performed using the following

steps:

The power outlet should be within 1.82 meters (6 feet) of the

Broadband Router.

Visually inspect the DC power jack and make sure that it is

connected securely to the power adapter.

Make sure that there is proper heat dissipation from and adequate

ventilation around the Broadband Router. Do not place heavy

objects on the Broadband Router.

HARDWARE INSTALLATION

Front Panel

The figure below shows the front panel of the Broadband Router.

4-Port 10/100Mbps Ethernet Broadband Router Front Panel

POWER

This indicator lights green when the hub is receiving power. Otherwise, it

is off.

STATUS

This indicator blinks red when the Internet Broadband Router is

successfully working. If the indicator is either always on or off, the

Internet Broadband Router is not working properly.

WAN

This indicator lights green when the WAN port is connected to an

xDSL/Cable modem successfully.

This indicator blinks green while the WAN port is transmitting data to or

receiving data from the xDSL/Cable modem.

LAN (Link/ACT)

The port 1 - 4 indicators light green when they’re connected to a 100Mbps

Fast Ethernet station. If the indicator blinks green, the corresponding LAN

port is transmitting or receiving data.

Rear Panel

The figure below shows the rear panel of the Broadband Router.

4 Port 10/100Mbps Ethernet Broadband Router Rear Panel

WAN

On the 4 port broadband router, there is an RJ-45 10/100Mbps Auto-

MDIX WAN port. This port connects to your xDSL/Cable modem.

LAN (1-4)

Four RJ-45 10/100Mbps Auto-MDIX ports for connecting to either

10Mbps or 100Mbps Ethernet connections.

RESET

Use a pin-shaped object to reset this device to factory default settings.

Resetting the device will also reset the login password to the default.

Hardware connections

Connect the Internet Broadband Router

1. Connect one end of the network cable to the WAN port of the 4-port

Internet Broadband Router.

2. Connect the other end of the network cable to the Ethernet port of the

xDSL or Cable modem.

3. Connect one end of another network cable to the computer’s Ethernet

card and the other end of the cable to one of the Router’s LAN ports.

Since the Internet Broadband Router has four ports, you can connect

up to four computers directly to the unit. You do not have to buy a

switch to connect these computers since the Internet Broadband

Router functions as both an Internet connection-sharing unit and as a

switch.

Check the installation

The LEDs of the Internet Broadband Router are clearly visible and the

status of the network link can be seen immediately:

1. Once the device is connected to the broadband modem and the Power

is connected, the Power, System, LAN and WAN port link LEDs of

the Internet Broadband Router will light up.

2. If the WAN port is linked to the ADSL/Cable modem, the WAN

port’s Link/ACT LED will light up.

3. If the LAN port is linked to the computer system, the LAN port’s

Link/ACT LED will light up.

PC NETWORK TCP/IP SETTING

The network TCP/IP settings differ based on the computer’s operating

system (Win95/98/ME/NT/2000/XP) and are as follows.

Windows 95/98/ME

1. Right click on the “Network neighborhood” icon and select

properties.

2. Select the TCP/IP for your Ethernet adapter and then click properties.

3. Select “Obtain an IP address automatically” in the “IP Address”

tab.

4. Click on the DNS configuration tab and select “Disable DNS”.

5. Click on the Gateway tab. If there are any Installed gateways,

select the gateway and click Remove.

6. Click OK.

Windows XP/2000

1. Right click My Network Places and select Properties

2. Double-click on the Local Area Connection icon and click

Properties.

3. Click on Internet Protocol (TCP/IP) and select Properties.

4. Select Obtain an IP Address Automatically.

5. Select Obtain DNS Server Address Automatically.

6. Click OK.

Windows NT4.0

Click on the “Start” button located on the lower left corner of the menu

bar.

Select “Settings” and then “Control panel.”

In the “Control panel” window, select “Network” to enter the TCP/IP

settings window.

1. Set “IP address” to “Obtain an IP address automatically.”

2. Set “DNS” to “Disable DNS.”

INTERNET BROADBAND ROUTER CONFIGURATION

First, make sure that the network connections are functioning normally.

This Internet Broadband Router can be configured using Internet Explorer

5.0 or later.

1. Open Internet Explorer 5.0 or higher.

2. Enter http://192.168.0.1 (the factory-default IP address setting) in

the address bar.

3. When the following dialog box appears, type in admin for the user

name. Leave the password field blank, (by default, there is no

password) and click LOGIN.

Note: If you need to set a password, refer to the Administrator Settings

in Advanced Setup.

4. Two setup options appear: Quick Setup or Advanced Setup. It is

recommended that you use Quick Setup if you are a beginner. It will

lead you through the configuration step-by-step.

Quick Setup

On the main webpage, select “Quick Setup” to specify the Time Zone and

the WAN connection type.

1-1 Time Zone

Select the appropriate time zone so your system clock can synchronize

itself through the SNTP Server.

1-2 WAN Connection Type

To select the WAN connection-type, click Dynamic IP (Cable Modem),

Static IP (Fixed-IP), PPPoE (Dial-up xDSL) or PPTP

Other manuals for TW100-S4W1CA

Table of contents

Other TRENDnet Network Router manuals

TRENDnet

TRENDnet TW100-BRV204 SHEETS User manual

TRENDnet

TRENDnet TPL-202E - Powerline Fast EN Bridge User manual

TRENDnet

TRENDnet TWG-BRF114 User manual

TRENDnet

TRENDnet TE100-S5Pplus Quick start guide

TRENDnet

TRENDnet TEW-WLC100 User manual

TRENDnet

TRENDnet TEW-829DRU User manual

TRENDnet

TRENDnet TE100-S2424V User manual

TRENDnet

TRENDnet TE100-S16R User manual

TRENDnet

TRENDnet TEG-S16R - DATA SHEETS User manual

TRENDnet

TRENDnet TW100-BRM504 User manual

TRENDnet

TRENDnet TW-200 User manual

TRENDnet

TRENDnet TW100-BRF114 User manual

TRENDnet

TRENDnet GREENnet TEW-639GR User manual

TRENDnet

TRENDnet TEW-435BRM - 54MBPS 802.11G Adsl Firewall M User manual

TRENDnet

TRENDnet TW-100 User manual

TRENDnet

TRENDnet TW100-BRV204 - VPN Firewall Router Parts list manual

TRENDnet

TRENDnet TEW-840APBO User manual

TRENDnet

TRENDnet TW100 TW100-BRV304 Installation and operation manual

TRENDnet

TRENDnet TW100-BRF114 Instruction Manual

TRENDnet

TRENDnet TEW-658BRM User manual

TRENDnet

TRENDnet GREENnet TEW-639GR User manual

TRENDnet

TRENDnet TW100-BRF114U Installation guide

TRENDnet

TRENDnet TEW-816DRM User manual

TRENDnet

TRENDnet TW100-BRV204 SHEETS User manual

Popular Network Router manuals by other brands

Allnet

Allnet ALL0333AU user guide

HomeSeer

HomeSeer HT-SEL Getting started guide

Sercomm

Sercomm Genesis OC3505D Quick installation guide

Billion

Billion BIPAC 5102 Series user manual

TP-Link

TP-Link TD-8817 QIG

Motorola

Motorola MR1900 user guide

Digi

Digi IX14 user guide

Cisco

Cisco NCS 540 Hardware installation guide

XAVi

XAVi X8821e user manual

BEC

BEC 6200WZL Quick installation guide

MikroTik

MikroTik hAP ac3 Series quick start

Korenix

Korenix JetNet 5428G Series user manual

NETGEAR

NETGEAR FS526T - Switch installation guide

Korenix

Korenix JetNet 5710G Series user manual

Automated Logic

Automated Logic ZN551 Technical instructions

Cisco

Cisco ASR 1000 Series Installation and configuration guide

EnGenius

EnGenius ESR-9710 quick start guide

Cisco

Cisco 805 Series Product overview