Super Circuits PC164C Series User manual

PC164C / PC165 Series Back Focus Procedure

Step 1- Remove Lens Cover

Step 2- If using a C-Mount lenses it can be applied to the camera at this time

Step 3- Most current lenses are CS-Mount and require removal of the C/CS ring

Step 4- To remove the C/CS ring loosen but do not remove completely the two set screws and then remove the C/CS ring.

Step 5- Screw on the CS-Mount lens until a good picture is obtained and tighten the set screws

Step 6- Use the focus ring on the lens to obtain a finer focusing.

Note- If a C-Mount lens was applied and focus could not be obtained, please try the following:

●Ensure that the lens is in fact a C-Mount and not a CS-Mount

●Check the focus adjust on the lens

●If need be loosen the set screws and adjust the position of the lens and C/CS ring as one unit until a good focus is obtained.

WARNING

TO REDUCE THERISK OFFIRE OR ELECTRIC SHOCK,

DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE

CAUTION

RISK

ELECTRIC SHOCK

AWA

CAUTION

TO REDUCE THE RISK OFELECTRIC SHOCK,

DO NOT REMOVE COVER(0R BACK),

NO USER

SERVICEABLE PATRS INSIDE.

REFER SERVICINGTO QUALIFIED SERVICE PERSONNEL

TABLE OF CONTENTS

A. PRECAUTIONS

B. SPECIAL FEATURES

C. APPEARANCE

D. INSTALLATION

E. SPECIFICATION

Do not attempt to disassemble the camera.

There are no user serviceable parts inside. Ask a qualified

service person for servicing.

Handle the camera with care.

Do not abuse the camera. Avoid striking, shaking, etc. Improper

handlingor storagecoulddamage the camera.

Do not expose the camera to rain or moisture, or try to

operate it in wet areas.

Turn the power off immediately and ask

qualified service

person for servicing. Moisturecan damage the camera.

Do not use strong or abrasive detergents when cleaning

the camera body.

Use a dry cloth to clean the camera when dirty. In case the

dirt is hard to remove, use a mild detergent and wipe gently.

Afterwards, wipe off the remained part of the detergent in it

with a dry cloth.

Clean the CCD faceplate with care.

Do not clean the CCD with strong or abrasive detergents.

Use lens tissue or a cotton tipped applicator and ethanol.

Never face the camera towards the sun.

Do not aim the camera at bright objects. Whether the camera

is in use or not, never aim it at the sun or other extremely bright

objects. Otherwise, blooming or smear may be caused.

notoperate the camerabeyond the specitiedtemperature,

humidity or power source ratings.

Use the camera under conditions where temperature is

between

-10°C-+40"C,

and humidity is below

80%.

SPECIAL FEATURES

The following functions are built in.

(1)Auto Light Control (ALC)/Electronic Light Control(E/S)

(2)Automatic Gain control (AGC)

(3)Automatic White Balance(AWB)

ConspicuousLow Lux Sensitivityand extremely clear vision.

3. Signal-to-noise ratio of 45dB for colour

50dB for B/W

(Equivalent to AGC Off)

4. Horizontal resolution of 380TV lines

420

TV lines for Standard

resolution and 480TV lines

600

TV lines for High resolution.

Built-in electronic shutter (Auto iris function) and blooming-

free circuit

Built in auto iris functionenablesit to view againststrong light

and add the outlineclearerwith blooming free circuit

OLPF

Built-in for colour version

Unlike usual cameras, this camera filters unnecessary noise

signals in dark view and feedback them with more clear

picture signals.

This makes it possible to eliminate disturbing dark noises in

low lux condition and ensure it to produce an extraordinary

clear picture at any light condition.

BiW

Version

Colour

Version

INSTALLATION

Mounting

Lens

View of angle and focus adjustment for built in

varifocal lens.

imur

screw

Horizontal

Verltcal

33.4"

a,rlance

rcreh

Please adjust focus

d~stancewith the screws on

the varifocal lens

Cable Connection

Operating Controls and Functions

Colour Version

BIW

Version

HOW

INSTALL

THE

AUTO-IRIS LENSCONNECTOR

@I.

Cut off the iris control cable at the edgeof lensconnector and then cut off the

outer cable cover as shown in the diagram.

Ins Control Cable Lens Connector S/l6"(Approx1mately8mm)

Iris Control Cable

Cut off inner cable covers of the iris control cable

shown

the diagram.

li4"(Approximatly6mm)

Put the heat shnnkable tubes oreauivalenttubes on the innercables

the iriscontmlcable.

Solderthe inner cablesof the iriscontrol cableat the piin-plug block according to

the

following

piassignmentand coverthe heat shrinkabletubes or equivalenttubes over the solderedma

and heat on the tubes to shrink them.

Signal for Video-iris lens

Signal for DC-iris lens

]:Power source:t9V DC,

50mA

Max. Pin I:DAMP-

2:N.C(Not used)

2:DAMP+

Pin 3:Video Signal:0.7Vp-p/lOKohms.

3:DRVt

4:Shield, ground Pin 4:DRV-(GND)

Rlb

When Auto-iris lens

used. please select

Pln3

EIS.

BLC.ALC switch to ALC posltion

p'n'

Pl"4

Pl"2

Both the connector cover and connector should

properly iterlocked

Shrinkable

Tubes

Connector

Note Cut off the

on the connector

Cover

When the lrrs control cable 1s too

thsk, connector cover

and

connector

can not

interlocked

@Automatic Light Conhol/Electronic Light Control Selector (ALC, E/S)

Let you selectthemode

accnrding

the

lens

type

used.

ALC:Select

this

modewhen

auto

ins

lens(AU31ens)ii

used

with

this

camera

E8:Select

this

mode

when

atixed

iris

lensor

ODC

V/D

1)C.Fc.lc.t.t

~f!ou

;ue

u,t~igthe .tlito

In,

Itn, that

require*

D€

dn\zugndl

\'11)1'0 Select

\'in

li!ou orc u.tn:thc

.IUIO

In,

Ism that rcqutrc,

\tdcodn\c

\ty.tl

DCLevel

DCAuto Iris lens level adjustment

This manual suits for next models

Table of contents

Other Super Circuits Security Camera manuals

Super Circuits

Super Circuits PC816VFAC User manual

Super Circuits

Super Circuits CD50WR User manual

Super Circuits

Super Circuits CD21 User manual

Super Circuits

Super Circuits PC88WR Installation manual

Super Circuits

Super Circuits PC813IR User manual

Super Circuits

Super Circuits 940-GSM4 User manual

Super Circuits

Super Circuits CD33-2 User manual

Super Circuits

Super Circuits CD33-2 User manual

Super Circuits

Super Circuits PC335GDVR User manual

Super Circuits

Super Circuits XTR-KEY1 Safety guide

Super Circuits

Super Circuits SYRF04 User manual

Super Circuits

Super Circuits PC940IR User manual

Super Circuits

Super Circuits PC33C5G User manual

Super Circuits

Super Circuits 940-GSM6 User manual

Super Circuits

Super Circuits 940-GSM User manual

Super Circuits

Super Circuits CD50 User manual

Super Circuits

Super Circuits N6076 User manual

Super Circuits

Super Circuits PC508-IR2 User manual

Super Circuits

Super Circuits MVL24KIT Parts list manual

Super Circuits

Super Circuits CCR-1 User manual

Super Circuits

Super Circuits CD23VF User manual

Super Circuits

Super Circuits CD25IP User manual

Super Circuits

Super Circuits wl-ic4d User manual

Super Circuits

Super Circuits PC243C5G User manual

Popular Security Camera manuals by other brands

Okina USA

Okina USA SIR36-870VF650LP user manual

Divio

Divio NDR155PA user manual

Canon

Canon VB-C500D Specifications

Easy Access

Easy Access EasyGuard user manual

Vivotek

Vivotek FD9389-EHV-v2 Quick installation guide

TUYA

TUYA COSMO W2 manual

Eusso

Eusso UNC7500-IR Advanced installation guide

urmet domus

urmet domus 1096/204 user manual

VC VC20 series operating manual

Axis

Axis Q1614 installation guide

ieGeek

ieGeek DD201 manual

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Installation and user guide

Vicon

Vicon V662-D-1 Installation and operation guide

Grundig

Grundig GCH-K0274P owner's manual

Lorex

Lorex VANTAGE LBC7032 quick start guide

4xem

4xem WPT Specifications

Samsung

Samsung SCV-3082 Specifications

Vitek

Vitek VTC-C544 Specifications