StarTech.com SATDOCK4U2E User manual

SATA Hard Drive Docking

Station

4-Bay eSATA, USB 2.0 to SATA

Hard Drive Docking Station

for 2.5”/3.5” Drives

SATDOCK4U2E

SATDOCK4U3E

Instruction Manual

Manual Revision:04/05/2011

For the most up-to-date information, please visit www.startech.com

4-Bay eSATA, USB 3.0 to SATA

Hard Drive Docking Station

for 2.5”/3.5” Drives

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols

This manual may make reference to trademarks, registered trademarks, and other

protected names and/or symbols of third-party companies not related in any way to

StarTech.com. Where they occur these references are for illustrative purposes only

and do not represent an endorsement of a product or service by StarTech.com, or an

endorsement of the product(s) to which this manual applies by the third-party company

in question. Regardless of any direct acknowledgement elsewhere in the body of

this document, StarTech.com hereby acknowledges that all trademarks, registered

trademarks, service marks, and other protected names and/or symbols contained in this

manual and related documents are the property of their respective holders.

Table of Contents

Introduction ..................................................................... 1

Packaging Contents.....................................................................1

System Requirements .................................................................1

SATDOCK4U2E - Top View .........................................................2

SATDOCK4U2E - Rear View .......................................................2

SATDOCK4U3E - Top View .........................................................3

SATDOCK4U3E - Rear View .......................................................3

Installation ....................................................................... 4

Hardware Installation ...................................................................4

Driver Installation .........................................................................5

Using the Storage Device ............................................... 5

Speciﬁcations .................................................................. 7

Technical Support ........................................................... 8

Warranty Information ...................................................... 8

SATDOCK4U3E: Pressing the power button to turn off a

hard drive will momentarily restart the other drive bays.

Ensure the other drives are not being accessed when

powering off any of the drives.

Introduction

The SATDOCK4U2E and SATDOCK4U3E Quad SATA Docking Stations for 2.5in

and 3.5in hard drives (HDD) and solid state drives (SSD) allows for up to four

drives to be conveniently and quickly accessed from a single device.

The SATDOCK4U2E allows four SATA drives to be paired and connected over

USB 2.0, with data transfer rates up to 480Mbps, with two USB connections or

each drive can be connected individually over a dedicated eSATA connection at

up to 3Gbps, allowing for multiple computers to simultaneously interface with a

single docking station to access only a speciﬁc drive(s).

The SATDOCK4U3E features SuperSpeed USB 3.0 connectivity (also compatible

with USB 2.0) with data transfer rates up to 5Gbps (10x faster than USB 2.0)

or eSATA with Port Multiplier connectivity up to 3Gbps. This docking station

provides fast connectivity to all 4 drives simultaneously from a single connection.

Packaging Contents

SATDOCK4U2E SATDOCK4U3E

• 1 x 4-Bay SATA Docking Station • 1 x 4-Bay SATA Docking Station

• 2 x USB 2.0 cable • 1 x USB 3.0 cable

• 4 x eSATA cable • 1 x eSATA cable

• 1 x Universal Power Adapter • 1 x Universal Power Adapter

• 3 x Power Cord (NA/UK/EU) • 3 x Power Cord (NA/UK/EU)

• 1 x Instruction Manual • 1 x Instruction Manual

System Requirements

• Available USB and/or eSATA* port(s) on computer system

*eSATA port requires Port Multiplier support for SATDOCK4U3E

• Available AC power outlet

• Microsoft® Windows® 2000/XP/Server 2003/Vista/Server 2008 R2/7

(32/64-bit) or Apple® Mac OS® X (SATDOCK4U2E only) or Linux®

SATDOCK4U2E - Top View

SATDOCK4U2E - Rear View

SATDOCK4U3E - Top View

SATDOCK4U3E - Rear View

Installation

WARNING! Hard drives require careful handling, especially when

being transported. If you are not careful, lost data may result. Always

handle hard drives and storage devices with caution.

Hardware Installation

1. Connect the external power adapter from the hard drive docking

station to an AC power outlet.

2. Insert 2.5” or 3.5” hard drive(s) into the top loading slot(s). Make sure

that the connectors on the hard drive are facing the same corner

of the slot that has a cutout in the door. The label on the hard drive

should face the front of the SATA docking station.

3. SATDOCK4U2E: Connect the HDD1/2 bays using either a single

USB cable (USB1) or separate eSATA cables (eSATA1/2) to a

computer(s). Connect the HDD3/4 bays using either a single USB

cable (USB2) or separate eSATA cables (eSATA3/4) to the same or

different computer(s).

SATDOCK4U3E: Connect the included USB cable or eSATA cable

from the hard drive docking station to an available USB or eSATA

port on the computer system. The computer can be on or off.

NOTE: If using eSATA, please note that the eSATA port on the host

computer system must provide Port Multiplier support. If the eSATA

port does not offer Port Multiplier support, only one of the installed

SATA drives will be accessible.

4. Press the power buttons on the top of the hard drive docking station

for each of the bays that contain a hard drive. The Power LED

around the power buttons should light up.

5. To remove the hard drive, make sure it is currently not being

accessed by the computer and the Activity LED is not ﬂashing, then

unmount or uninstall the disk drive from the operating system (see

documentation for your operating system). Press the appropriate

power button to turn off the hard drive and wait for the drive to power

down. Press the drive ejection button on the top of the hard drive

dock to the release the drive, then pull the drive from the slot.

Driver Installation

No driver installation is required for the supported operating systems,

as this hard drive dock is natively supported, so the drivers are already

installed.

Using the Storage Device

Windows 2000/XP/Vista/7

If you are using a brand new hard drive that does not contain any data,

then you will ﬁrst need to prepare the hard drive for use. From the

main desktop, right-click on “My Computer” (“Computer” in Vista/7),

then select Manage. In the new Computer Management window, select

Disk Management from the left window panel.

The New Partition Wizard will appear. Follow the instructions in the

wizard to complete setting up the drive. Once complete, the Disk

should show up as “Healthy” with a drive letter assigned (i.e. E:). This

drive letter should now appear within My Computer.

If you are installing a hard drive that already has data on it, then after

plugging it in, the drive should automatically show up with a drive letter

assigned within My Computer.

Locate the Disk that says it is “Unallocated” (check hard drive capacity

to conﬁrm it’s the correct hard drive) and then right-click in the section

that says “Unallocated” and select “New Partition”.

Specications

SATDOCK4U2E SATDOCK4U3E

Number of Drives 4

Bus Interface USB 2.0

SATA revision 2.x

USB 3.0

SATA revision 2.x

Chipset ID Initio INIC1610P JMicron JM321 +

JM539

External Connectors 2 x USB type A female

4 x eSATA female

1 x USB 3.0 type B

female

1 x eSATA female

LEDs 4 x Drive Power

4 x Drive Activity

Fans 2 x 60mm

Maximum Data Transfer

Rate

USB 2.0: 480Mbps

eSATA: 3Gbps

USB 3.0: 5Gbps

eSATA: 3Gbps

Hard Drive Compatibility 2.5”/3.5” SATA 1.5/3.0/6.0 Gbps compatible

drives, tested up to 2.0TB in capacity

Insertion Rating 15, 000 cycles

Power Adapter 12VDC, 6500mA

Operating Temperature 5°C ~ 80°C (41°F ~ 176°F)

Storage Temperature -40°C ~ 70°C (-40°F ~ 158°F)

Humidity 8% ~ 90% RH

Dimensions 290.5mm x 172.7mm x 94.7mm

Weight 1054g 1020g

Compatible Operating

Systems

Windows 2000/XP/Vista/Server 2003/Server

2008 R2/7 (32/64-bit),

Mac OS X (SATDOCK4U2E only), Linux

Other manuals for SATDOCK4U2E

This manual suits for next models

Table of contents

Other StarTech.com Docking Station manuals

StarTech.com

StarTech.com Thunderbolt 3 TB3DKM2DPL User manual

StarTech.com

StarTech.com 101N-USBC-DOCK User manual

StarTech.com

StarTech.com TB3DK2DPW User manual

StarTech.com

StarTech.com SDOCKU313E User manual

StarTech.com

StarTech.com DK31C3MNCR User manual

StarTech.com

StarTech.com USBA2DPGB User manual

StarTech.com

StarTech.com DK30CHHPD User manual

StarTech.com

StarTech.com DK30C2DPPD User manual

StarTech.com

StarTech.com TBDOCKHDPBC User manual

StarTech.com

StarTech.com DKT31CHDVCM User manual

StarTech.com

StarTech.com SDOCK2ERU33 User manual

StarTech.com

StarTech.com UNIDOCK3U User manual

StarTech.com

StarTech.com USBVGADOCK2 User manual

StarTech.com

StarTech.com SATDOCKU3SEF User manual

StarTech.com

StarTech.com Thunderbolt TB3CDOCKDP User manual

StarTech.com

StarTech.com SATDOCKU3E User manual

StarTech.com

StarTech.com USB6N1DOCK User manual

StarTech.com

StarTech.com 8STSATDOCKU3S User manual

StarTech.com

StarTech.com SDOCK1EU3P User manual

StarTech.com

StarTech.com TB3DKDPMAW User manual

StarTech.com

StarTech.com DK30CHDPD User manual

StarTech.com

StarTech.com USBVGADOCK User manual

StarTech.com

StarTech.com TB3DK2DPWUE User manual

StarTech.com

StarTech.com SATDOCK22RE User manual

Popular Docking Station manuals by other brands

Sony

Sony Dream Machine XDR-DS12iP user manual

Acer

Acer USB Type-C Dock II user manual

ATEN

ATEN UC-2000 user manual

Xcellon

Xcellon HDD-202 user manual

Dok

Dok CR09 user guide

Philips

Philips BTM630/12 quick start guide

IOGear

IOGear Travel Pro GUD3C09 quick start guide

RKI

RKI SDM-E2 Operator's manual

iHome

iHome iP15 instruction manual

VITURE ONE

VITURE ONE MOBILE DOCK quick start guide

Lindy

Lindy 42984 user manual

CipherLab

CipherLab 8001 quick guide

Pyle

Pyle PIPDSP2 owner's manual

Avol

Avol AS2350 user manual

Datalogic

Datalogic JoyaTouch quick start guide

Philips

Philips DC190/79 user manual

Targus

Targus DOCK315EUZ user guide

Akasa

Akasa DuoDockX3 AK-DK08U3-BK user manual