SRT SRT326i User manual
www.srt.se
Quick guide SRT326i
Personal alarm
SRT3260500A19_QG_EN_STD
Call button
On/Off button
Enable/disable Timer alarm
Enable/disable Man down alarm
Charging port
SIM card
Sending an alarm
Press and hold the
alarm button until the
device vibrates.
The device will emit a
second, shorter
vibration when the
alarm has been sent.
On/off
Press and hold the on/
off button for 5 seconds.
The device will start
vibrating and initiate the
turning on/off sequence.
Acoustic warning
If the SIM card is out of
place the device will emit
an audible signal. Shut
the device off, extract
and reinsert the SIM
card and turn the device
on again.
www.srt.se
Status LEDs
GSM status
Blinking (red)
Searching for GSM
network
Blinking (green) slowly
GSM network found
Blinking (green) quickly
Call in progress.
No light
The device is either
turned off or in idle mode.
Charge level (PWR)
(charger disconnected)
Blinking three times
every 15 seconds
The device is turned on
and is signaling the battery
level with the three blinks:
green green green
Very good
greengreen red
Good
green redred
Low
redredred
Critical
Blinking interchanging
green and red
The device is turning off.
Charge level (PWR)
(charger connected)
Blinking every other
second (green)
The device is turned on
and charging.
Blinking every other
second (red)
The device is turned off
and charging.
Solid light (green)
The device is turned on
and fully charged.
Solid light (red)
The device is turned off
and fully charged.
Blinking interchanging
green and red
The device is turning off.
Charging
(Desktop charger)
Charging (USB)
Lift the rubber ap on
the side of the device
and insert the charger
cable into the mini usb
connector.
Place the unit in the desk-
top charger
Charging times
Before using your alarm
device the rst time, or
whenever the battery is
fully discharged, it should
be charged for at least 4
hours. The device should
be charged every day.
MD status
No light
Man down function is
disabled.
Blinking (yellow)
Man down function is
enabled
TMR/RF status
No light
No contact with any RF
tags. Timer alarm is
disabled.
Blinking (green)
Device is in contact
with RF tag.
Blinking (yellow)
Timer alarm is enabled.
Blinking (green/yellow)
The device is in contact
with RF tag. Timer alarm
is enabled.
Other SRT Security System manuals
Popular Security System manuals by other brands
EDM
EDM Solution 6+6 Wireless-AE installation manual
Highway Safety Group
Highway Safety Group EA401 user manual
Siren
Siren LED GSM operating manual
Detection Systems
Detection Systems 7090i Installation and programming manual
Se-Kure Controls
Se-Kure Controls MicroMini SK-4841 instructions
Siemens
Siemens FDM273 manual