Soundsphere Q-8 User manual
Q-8 | OWNER’S MANUAL
R e v 7.11. 2 018
Q-8 | OWNER’S MANUAL
Please read the following instructions carefully before installing your Soundsphere®speaker. If you have any questions regarding
installation that are not answered in the following directions, please contact your local sound contractor or the Soundsphere®/
MSE Audio®technical support team. Contact information can be found on the back of the manual.
General Information
Maximum Amplier Power 100 Watts RMS
Nominal Impendance 8 ohms
Wiring
Amplier connection is via ying leads. Connect the positive (+) amplier lead to the RED input wire. Connect the negative (-)
amplier lead to the BLACK wire. Secure connections using wire nuts, etc.
Mounting
Hanging Kit
Mount using one of the following methods:
a) Properly secured wire rope with a minimum breaking strength of 225 lbs. (for a 10:1 safety factor).
b) Beam clamp with proper load rating.
It is recommended to use a secondary wire rope support around one of the Q-8 legs. Do not use rope for mounting. The
use of chain is not recommended unless rated for suspension of loads greater than or equal to 225 lbs (for a 10:1 safety factor).
Surface Mount Bracket
Secure the bracket to the hard surface using proper hardware. Secure the Q-8 to the bracket using the washers and nylon
locknuts provided. It is recommended to use a secondary wire rope support around one of the Q-8 legs and through an
unused bracket hole.
Warranty
Soundsphere loudspeakers carry a 5 year limited warranty. See warranty sheet for details and limitations.
Replacement Parts
8” 100 Watt coaxial loudspeaker driver with crossover. Order Model Number CX-8
Always check local requirements for overhead suspension of loudspeakers.
Soundsphere®by MSE Audio®| 6400 Youngerman Circle | Jacksonville, FL 32244
913-663-5600 or 855-663-5600 | www.soundsphere.com
Table of contents
Other Soundsphere Speakers manuals
