4(10)
Soneco Oy
Quick Guide:
i. Turn on the Soneco MC2 by pressing the function button until the yellow
indicator lamp begins to blink.
(Unless you want to program numbers into the device, go directly to step iv.)
ii. If no numbers have been programmed into the Soneco MC2, it will
automatically enter the number programming mode. If you want to change
previously programmed numbers, press the function button once when the
blinking yellow lamp turns green.
iii. Program the phone numbers (see Programming Mode) and press the function
button once.
iv.Wait for the green lamp to begin blinking once every two seconds to indicate
that the Soneco MC2 is ready for use.
v. Send an SOS alarm by SMS message by briefly pressing the function button.
vi.Turn off the Soneco MC2 by pressing the function button until all three indicator
lamps light at the same time. Then release the function button.
vii. Remember to charge the battery according to the instructions.
Charging the Battery:
Charge the battery by connecting the plug of the charger into the charging
connector of the Soneco MC2. If the Soneco MC2 is turned on, the yellow indicator
lamp blinks once every two seconds while the battery is being charged. If the
Soneco MC2 is turned off, the lamp blinks once every four seconds. The yellow
indicator lamp will begin blinking twice every two seconds when the battery is fully
charged. An empty battery normally requires two hours to become fully charged.
The battery can be charged during all the operating modes of the device, but the
indicator lamp does not blink to indicate charging during phone number
programming or startup.
You can charge the battery overnight, since overcharging is prevented.
NOTE! If the battery becomes fully discharged, it usually needs to be pre-
charged. Pre-charging of a fully discharged battery automatically begins when you
connect the charger to the Soneco MC2. The yellow indicator lamp blinks once
every four seconds during pre-charging. Pre-charging takes about an hour, after
which normal charging will automatically begin. If normal charging does not begin
after about an hour, disconnect the charger and then reconnect it to the Soneco
