SOLIDMATION HPA-2161 User manual
Automation made simple. lwww.solidmation.com
Connection diagram “A”
Electrical Installation:
Electrical installation shall be done by an authorized
electrical technician or a qualified professional.
Specifications
HPA-2161 allows controlling up to three individual
sets of monochrome LEDs, driving a different LED
channel with each module input.
HPA-2161 complies with electromagnetic emission
standards, thus ensuring no interference with
other devices. The operation of this equipment is
not affected by the interference of other equipment
complying with the electromagnetic emission
standards.
LED controller
HPA-2161: Monochrome LED controller
Dimmable three-channel switch to control monochrome
LEDs.
Installation manual
The LED Controller equipment from the Home
Automation series is designed to be installed
in any position, over roofs or suitable cabinets
according to their size.
Electrical connection diagram “A” shows an
example of an installation.
In case of failure or defects, please contact
authorized technical support.
Technical characteristics
lVoltage: 6-24 VDC
lQuantity of independent channels: 3
lMaximum section of cables for installation: 1.5 mm2
lEquipment power consumption: <100 mA
lType of Load: Monochrome LEDs
lMaximum torque for terminals (screw clamps): 0.5 Nm
Push-buttons
channels:
1 ,2 and 3
Power supply
6-24 VDC
+
+
+
Solidmation-MA-HPA-2161_V3-Installation_Manual-00-EN
Power supply
6-24 VDC
l• www.solidmation.com | [email protected]om
lwww.solidmation.com | inf[email protected]om
lwww.solidmation.com | info@solidmation.com
1. Turn off power and dismantle the box where the
push-button will be installed.
2. Dismantle the box containing the push-button
controlling the LEDs.
Wiring:
3. Connect the LED power supply to the “+” and “-”
terminals of the module.
4. Connect push-buttons to the input channel: input
channel 1 between terminals “C” and “1”; input
channel 2 between terminals “C” and “2”; input
channel 3 between terminals “C” and “3”.
Note: the interconnection between the push buttons
and “C” terminal is done outside the module.
5. Connect monochrome LED at the outputs “R” in
“Channel 1”, “G” in “Channel 2”, “B” in “Channel 3”.
6. Connect the anode of the monochrome LEDs to
“+”.
7. Note: the three anodes must be interconnected
outside the module.
8. Check that connections are done according to
Diagram “A”.
9. Mount the switch frame and cover.
10. Run Habeetat Planner software and follow the
instructions for proper conguration of your device.
Procedure for proper installation
Congratulations, your equipment is now ready to be
congured using Habeetat Planner software.
Solidmation S.A. | All rights reserved. Subject to changes without prior notice.
++ +
Other SOLIDMATION Controllers manuals
Popular Controllers manuals by other brands
Digiplex
Digiplex DGP-848 Programming guide
YASKAWA
YASKAWA SGM series user manual
Sinope
Sinope Calypso RM3500ZB installation guide
Isimet
Isimet DLA Series Style 2 Installation, Operations, Start-up and Maintenance Instructions
LSIS
LSIS sv-ip5a user manual
Rockwell Automation
Rockwell Automation 1769-L31 installation instructions
