SOLE F80 User manual
OWNER’S MANUAL
PLEASE CAREFULLY READ THIS ENTIRE MANUAL BEFORE OPERATING
YOUR NEW TREADMILL!
-2-
Important Safety Instructions……………………………………………………..………3
Portant Electeical Instructions……………………………………………..……..………4
Important Operation Instructions ………………..………………………..……..………5
Introduction…………………………………………………………………………………6
Specifications……………………………………………………………………………....6
Assembly Pack Check List …..………………………………………………………......7
Assembly Instructions……………………………………………………………………..8
Folding Instructions……………………………………………………………………….11
Operation of Your Treadmill…………………………………………………….....…….12
Programmable Features…………………………………………………………….……16
General Maintenance………………………………………………………………..…....23
Service Checklist-Diagnosis Guide…………………………………….…………….….26
Exploded View Diagram…………………………………………....……………………..27
Parts List….………………………………..……………………………………………….28
ST300-YT42CE_1107A
Table of Conten
ts
-3-
WARNING - Read all instructions before using this appliance.
DANGER - To reduce the risk of electric shock disconnect your treadmill from the electrical outlet prior
to cleaning and/or service work.
WARNING-To reduce the risk of burns, fire, electric shock, or injury to persons, install the treadmill on a
flat level surface with access to a 220~240-volt, 10-amp grounded outlet with only the treadmill plugged
into the circuit.
DO N
O
T USE AN E
X
TENSION
CORD UNLESS IT IS A 14
A
W
G OR B
E
T
TER,
WITH ON
L
Y ONE
OUTL
E
T ON
THE END: DO N
O
T
A
T
TEMPT
T
O DISABLE
THE G
R
OUNDED P
L
UG
B
Y USING
IMP
R
OPER A
D
APTERS, OR IN A
N
Y
W
AY MODIFY
THE
C
ORD S
E
T
.
A serious shock or fire hazard may result along with computer malfunctions. See Grounding lnstructions
Do not operate treadmill on deeply padded, plush or shag carpet. Damage to both carpet and
treadmill may result.
Do not block the rear of the treadmill. Provide a minimum of 3 1/2 feet clearance between the rear of
the treadmill and any fixed object.
Keep children away from the treadmill. There are obvious pinch points and other caution areas that
can cause harm.
Keep hands away from all moving parts.
Never operate the treadmill if it has a damaged cord or plug. If the treadmill is not working properly,
call your dealer.
Keep the cord away from heated surfaces.
Do not operate where aerosol spray products are being used or where oxygen is being administered.
Sparks from the motor may ignite a highly gaseous environment.
Never drop or insert any object into any openings.
Do not use outdoors.
To disconnect, turn all controls to the off position, remove tether cord, then remove the plug from the
outlet.
Do not attempt to use your treadmill for any purpose other than for the purpose it is intended.
The pulse sensors are not medical devices. Various factors, including the user’s movement, may
affect the accuracy of heart rate readings. The pulse sensors are intended only as exercise aids in
determining heart rate trends in general.
Use handrails provided; they are for your safety.
Wear proper shoes. High heels, dress shoes, sandals or bare feet are not suitable for use on your
treadmill. Quality athletic shoes are recommended to avoid leg fatigue.
Rem
o
v
e
t
ether
c
o
r
d a
f
t
er use
t
o p
r
e
v
e
n
t unauthori
z
ed t
r
eadmill o
p
e
r
a
tion.
S
A
VE
THESE INST
RU
C
TIONS -
THINK SAF
E
T
Y!
IMPORTANT SAFETY INSTRUCTIONS
-4-
W
ARNING!
NEVER use a ground fault circuit interrupt (GFCI) wall outlet with this treadmill. As with any ap- pliance with a
large motor, the GFCI will trip often. Route the power cord away from any moving part of the treadmill
including the elevation mechanism and transport wheels.
NEVER remove any cover without first disconnecting AC power.
If voltage varies by ten percent (10%) or more, the performance of your treadmill may be af- fected. Such
conditions are not covered under your warranty. If you suspect the voltage is low, contact your local power
company or a licensed electrician for proper testing.
NEVER expose this treadmill to rain or moisture. This product is NOT designed for use outdoors, near a
pool or spa, or in any other high humidity environment. The maximum operating temperature specification is
40 degrees c, and humidity is 95% non-condensing (no water drops forming on surfaces).
Circuit Breakers: Some circuit breakers used in homes are not rated for high inrush currents that can occur
when a treadmill is first turned on or even during use. lf your treadmill is tripping the house circuit breaker
(even though it is the proper current rating) but the circuit breaker on the treadmill itself does not trip, you will
need to replace the home breaker with a high inrush type. This is not a warranty defect. This is a condition
we as a manufacture have no ability to control. This part is available through most electrical supply stores.
Examples: Grainger part # 1D237, or available online at www.squared.com part # QO120HM.
This product must be grounded. If the treadmill should malfunction or breakdown, grounding provides a
path of least resistance for electric current, reducing the risk of electric shock. This product is equipped with
a cord having an equipment-grounding plug. The plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local codes and ordinances.
DANGER - Improper connection of the equipment-grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the product
is properly grounded. Do not modify the plug provided with the product if it will not fit the outlet;
have a proper outlet installed by aqualified electrician.
This product is for use on a nominal 220~240-volt circuit, and has a grounding plug that looks like the plug
illustrated below. A temporary adapter that looks like the adapter illustrated below may be used to connect
this plug to a 2-pole receptacle as shown below if a properly grounded outlet is not available. The temporary
adapter should be used only until a properly grounded outlet, (shown below) can be installed by a qualified
electrician. The green colored rigid earlug, or the like, extending from the adapter, must be connected to a
permanent ground such as a properly grounded outlet box cover. Whenever the adapter is used, it must be
held in place by a metal screw.
IMPORTANT ELECTRICAL INSTRUCTIONS
GROUNDING INSTRUCTIONS
-5-
NEVER operate this treadmill without reading and completely understanding the results of
any operational change you request from the computer.
Understand that changes in speed and incline do not occur immediately. Set your desired
speed on the computer console and release the adjustment key. The computer will obey the
command gradually.
NEVER use your treadmill during an electrical storm. Surges may occur in your household
power supply that could damage treadmill components. Unplug the treadmill during an
electrical storm as a precaution.
Use caution while participating in other activities while walking on your treadmill; such as
watching television, reading, etc. These distractions may cause you to lose balance or stray
from walking in the center of the belt; which may result in serious injury.
NEVER mount or dismount the treadmill while the belt is moving. treadmills start at a very
low speed and it is unnecessary to straddle the belt during start up. Simply standing on the
belt during slow acceleration is proper after you have learned to operate the unit.
Always hold on to a handrail or hand bar while making control changes (incline, speed,
etc.).
Do not use excessive pressure on console control keys. They are precision set to function
properly with little finger pressure. If you feel the buttons are not functioning properly with
normal pressure contact your dealer.
A safety tether cord is provided with this unit. It is a simple magnetic design that should be
used at all times. It is for your safety should you fall or move too far back on the tread-belt.
Pulling this safety tether cord will stop tread-belt movement.
To Use:
1. Place the magnet into position on the red portion of the console control head between
the Start and Stop keys. Your treadmill will not start and operate without this.
Removing the magnet also secures the treadmill from unauthorized use.
2.
Fasten the plastic clip onto your clothing securely to assure good holding power. Note:
The magnet has strong enough power to minimize accidental, unexpected stopping. The
clip should be attached securely to make certain it does not come off. Be familiar with its
function and limitations. The treadmill will stop, depending on speed, with a one to two
step coast anytime the magnet is pulled off the console. Use the red Stop / Pause switch
in normal operation.
IMPORTANT OPERATION INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
-6-
The treadmill has been designed and constructed to provide trouble free usage and enjoyable
exercise.
You can greatly improve your understanding and benefits of exercising by carefully reading the
instructions given in this manual. Please familiarize yourself with the maintenance advice provided
for you.
•Drive Motor: 3.0 hp
•Speed Range: 1 – 18 kmph
•Running Surface: 510 m/m x 1525 m/m
•Incline Level: 0-15 Levels
•
Folding Design: YES
INTRODUCTION
SPECIFICATIONS
Handrail
Running Belt
Main Frame
Wheel
Safety Key
Console
Handgrip Tube
Speaker
Speed Adjustment Switch
Incline Adjustment Switch
Fan
Beverage Holder
MAX.USER WEIGHT 150 KGS
-7-
Assembly Pack Check List
#130. 5/16" × 1/2"
Button Head Socket Bolt (8 pcs)
#75.Ellipse Safety Key (1 pc) #30.Lubricant (1 pc)
#132.M6 Allen Wrench (1 pc)
#131. Combination M5 Allen Wrench
& Phillips Head Screw Driver(1 pc)
#134. M5 × 10 m/m
Phillips Head Screw (8 pcs)
#133. 3/8" × 1-3/4"
Button Head Socket Bolt (4 pcs)
#128. M5
Speed Nut Clip (6 pcs)
#113. Ø10
Split Washer (4 pcs)
#122. 3.5 × 12 m/m
Sheet Metal Screw (4 pcs)
#120. 5 × 16 m/m
Tapping Screw (6 pcs)
#151. 5/16" × 3/4"
Button Head Socket Bolt (4 pcs)
-8-
Step 1.
Take out the treadmill from the carton and lay it aside on the smooth ground.
Step 2.
Locate 6 pcs of M5 Speed Nut Clips(128), which are included in the hardware kit, at the front and
each side of the unit as shown below and guide Right and left Uprights (4) and (5) go through
Frame Base Cover (L) and (R), (61) and (62), respectively, as shown further below. Connect
Computer Cable (Lower) (49) with Computer Cable (50).
Step 3.
Insert Right and Left Uprights (4) and (5) into the Frame Base (2) and use Combination M5 Allen
Wrench & Phillips Head Screw Drive (131) to tighten 8 pcs of 5/16” × 1/2” Button Head Socket Bolts
(130).
Assembly Instructions
-9-
Step 4.
Install Frame Base Cover (L) and (R),(61) and (62), on the Frame Base (2) and secure with 6 pcs of
5 × 16mm Tapping Screws (120) by using Combination M5 Allen Wrench & Phillips Head Screw
Drive (131).
Step 5.
Connect the Speed Adjustment Switch W/Cable (54) and Speed Cable (Upper)(37).
Connect the Incline Adjustment S2witch W/Cable (55) and Incline Cable (Upper)(38).
Connect the Computer Cable (Middle)(50) and Computer Cable (Lower/Upper)(48).
Step 6.
Insert Console Assembly (52) into right and left Uprights (4) and (5) and secure with 4 pcs of 3/8” ×
1- 3/4” Button Head Socket Bolts (133) with 4 pcs of Ø10 × 2T Split Washers (113) by using
M6_Allen Wrench (132).
-10-
Step 7.
Install Left Handgrip Side Cap (L), (63), Left Handgrip Side Cap (R), (65), Right Handgrip Side Cap
(L), (66) and Right Handgrip Side Cap (R), (67) on left and right Uprights (5), (4) and Console
Support (6), respectively. Then secure with 8 pcs of M5 × 10m/m Phillips Head Screws (134) and 4
pcs of 3.5 × 12m/m Sheet Metal Screws (122) by using Combination M5 Allen Wrench & Phillips
Head Screw Driver (131).
Step 8.
Install Handrail Support (15) between left and right Uprights (4) and (5) and use Combination M5
Allen Wrench & Phillips Head Screw Driver (131) to tighten 4 pcs of 5/16” × 3/4” Button Head
Socket Bolts (151). Put Beverage Holder (150) on the Handrail Support.
NOTE: Please Tighten All Screws After All Components Assembly Complete.
Other manuals for F80
4
Table of contents
Other SOLE Treadmill manuals
Popular Treadmill manuals by other brands
Smooth Fitness
Smooth Fitness EVO 3i user manual
NordicTrack
NordicTrack NETL81810.0 user manual
Schwinn
Schwinn 830/Journey 8.0 Assembly manual / owner's manual
Keys Fitness
Keys Fitness HealthTrainer HT-740T owner's manual
Spirit
Spirit XT8 Service manual
NordicTrack
NordicTrack T 14.0 Treadmill Manuel de l'utilisateur