visit www.simplisafe.com or call 1-888-95-SIMPLI (957-4675) for additional assistance
4
1. Install your system
Remove the battery activation strip.•
Plug the Base Station into a power outlet using the•
included power cord.
Tip: Locate the Base Station in the same room as your
main entrance to make it easier to hear voice prompts
while using the system.
Optional• : If you have a landline and plan to subscribe to
the Emergency Dispatch Service, you may plug the Base
Station into a telephone jack to provide an alternative to
your wireless connection to the Dispatch Service.
Tip: If you have a DSL Internet connection, you will need
to place a filter on this line, just like any other phone.
A. Plug in the Base Station
(optional)
Remove the battery activation strip.•
Adhere the Keypad to the wall by your main entrance.•
Tip: Adhesive tape has already been installed on the back
of the Keypad – just peel and stick. If you make a mistake,
see “How do I move a sensor?” on page 10.
B. Install the Keypad by your door
Remove the battery activation strip.•
Adhere the Panic Button to a wall.•
C. Install the Panic Button
Remove the battery activation strip.•
Place the Motion Sensor on a shelf or adhere it to a wall,•
approximately 4 to 5 feet off the ground.
Avoid placing the Sensor near a heater, air conditioner,
or in direct sunlight. If you have pets, put the Sensor at
least 5 feet off the ground, out of their reach. The Motion
Sensor will not detect most small pets, if the pet cannot get
within 5 feet of it. If you have larger pets, please contact
SimpliSafe for assistance.
D. Install the Motion Sensor
