www.signwarehouse.com •SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020
•Toll Free Phone: 1-800-699-5512 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834
To properly abort a job while printing you should first disconnect the
USB cord from the back of the printer. Leave the USB cord unplugged
and right-click on your job in the Queue and select Abort. Now it is
safe to plug the USB cord back into the back of the printer.
To begin printing again go to your Queue drop down menu and Select
Manage Queues. Make certain that your USB port has not been updat-
ed since you unplugged the USB cord. Close out of the Manage Queue
dialog box and you are now ready to print again.
Note: If you are going to be printing the same file you will need to right-
click and clear the error before printing.
To remove your roll prints, press the
roll media button to feed the media
forward, then cut off your printed
17
images straight across the media at the cutting guideline.
To continue printing on media, press the roll media button again
to return the media to printing position.
If the button is not pressed the next print will NOT print even though
the green light is solid.
If you are finished printing and want to remove the roll, press the roll
media button for three seconds to feed the media backwards and
out of the printer. If it does not feed all the way out, press the roll
media button again.
Press the trash button to stop the orange light from flashing.
The trash can button is used for clearing paper feed errors (ejecting
vinyl out of the back of the printer, or printing without vinyl loaded in
the printer).
Removing Roll Prints and Rolls
REFER TO YOUR USER GUIDE TO INSTALL THE SOFTWARE BEFORE PROCEEDING
18
Aborting a Job
