Sharp PN -HY431 User manual
PN-HY431 Dismantle Instruction
1
Dismantle Instruction
LCD MONITOR
MODEL
PN-HY431
701
PN-HY431 Dismantle Instruction
2
Table of contents
1. Scope.................................................................................................................. 3
2. Tools for dismantling............................................................................................... 3
3. Dismantle Procedure .............................................................................................. 3
4. Back covers .......................................................................................................... 4
5. Printed circuit boards ............................................................................................. 5
6. Battery................................................................................................................ 5
7. LCD Module .......................................................................................................... 6
8. Capacitors............................................................................................................ 7
9. Parts List ............................................................................................................. 7
PN-HY431 Dismantle Instruction
3
1. Scope
This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU.
2. Tools for dismantling
Below tools are required to dismantle this product.
- Screw Driver
- Nipper
3. Dismantle Procedure
This product can be dismantled by below steps.
1. Remove Back covers (section 4)
2. Remove Printed circuit boards (section 5)
3. Remove Battery (section 6)
4. Dismantle LCD (section 7)
5. Remove Electrolyte Capacitors (section 8)
PN-HY431 Dismantle Instruction
4
4. Back covers
Back cover can be removed by screw driver.
PN-HY431 Dismantle Instruction
5
5. Printed circuit boards
All PWBs can be removed by screw driver.
Main I/F PWB (1pcs) Power PWB (1pcs)
T-CON PWB (1pcs)
6. Battery
This model uses only AAA battery for remote control.
Battery can easily be removed.
PN-HY431 Dismantle Instruction
6
7. LCD Module
- LCD Dismantle procedure
1. Remove Rear cover
2. Remove PWBs
3. Remove the Cables
LCD
PN-HY431 Dismantle Instruction
7
8. Capacitors
Electrolyte Capacitors which diameter/height is larger than 25mm is installed on Power PWB.
These capacitors can be removed by using nipper to cut the leads.
On Power PWB
9. Parts List
Parts described in Annex VII of directive 2012/19/EU are as below.
Parts
Note
LCD
43inch LCD module
Printed Circuit Boards
Main I/F PWB
Power PWB
T-CON PWB
Battery
AAA battery
Electrolyte capacitors
(height >25mm, diameter >25mm)
On Power PWB
External electric cables
2 kinds of Power Cord
- for EU
- for UK
Table of contents
Other Sharp Monitor manuals
Sharp
Sharp LL-T1811W User manual
Sharp
Sharp PN-R706 User manual
Sharp
Sharp PN-V550A User guide
Sharp
Sharp PN-E803 User guide
Sharp
Sharp PN-65TH1 User guide
Sharp
Sharp PN-V701 Instruction sheet
Sharp
Sharp AQUOS 4T-C65DL1X Manual
Sharp
Sharp LL-T15V1 User manual
Sharp
Sharp PN-HS551 User manual
Sharp
Sharp BIG PAD PN-65HC1 User guide
Sharp
Sharp PN-L603W User manual
Sharp
Sharp PN-Y326 User manual
Sharp
Sharp PN-E703 User manual
Sharp
Sharp 60005523 User manual
Sharp
Sharp PN -70TH5 User manual
Sharp
Sharp PN-Q901 User manual
Sharp
Sharp PN-L803C User manual
Sharp
Sharp PN-K321H User manual
Sharp
Sharp Smart Board Service manual
Sharp
Sharp LL-T15G4-H - 15" LCD Monitor User manual
