Sharp PN-HS501 User manual
PN-HS501 Dismantle Instruction
1
Dismantle Instruction
LCD MONITOR
MODEL
PN-HS501
701
PN-HS501 Dismantle Instruction
2
Table of contents
1. Scope.................................................................................................................. 3
2. Tools for dismantling............................................................................................... 3
3. Dismantle Procedure .............................................................................................. 3
4. Back covers .......................................................................................................... 4
5. Printed circuit boards ............................................................................................. 5
6. Battery................................................................................................................ 5
7. LCD Module .......................................................................................................... 6
8. Capacitors............................................................................................................ 7
9. Parts List ............................................................................................................. 7
PN-HS501 Dismantle Instruction
3
1. Scope
This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU.
2. Tools for dismantling
Below tools are required to dismantle this product.
- Screw Driver
- Nipper
3. Dismantle Procedure
This product can be dismantled by below steps.
1. Remove Back covers (section 4)
2. Remove Printed circuit boards (section 5)
3. Remove Battery (section 6)
4. Dismantle LCD (section 7)
5. Remove Electrolyte Capacitors (section 8)
PN-HS501 Dismantle Instruction
4
4. Back covers
Back cover can be removed by screw driver.
PN-HS501 Dismantle Instruction
5
5. Printed circuit boards
All PWBs can be removed by screw driver.
Main I/F PWB (1pcs) Power PWB (1pcs)
0
T-CON PWB (1pcs)
6. Battery
This model uses only AAA battery for remote control.
Battery can easily be removed.
PN-HS501 Dismantle Instruction
6
7. LCD Module
- LCD Dismantle procedure
1. Remove Rear cover
2. Remove PWBs
3. Remove the Cables
LCD
PN-HS501 Dismantle Instruction
7
8. Capacitors
Electrolyte Capacitors which diameter/height is larger than 25mm is installed on Power PWB.
These capacitors can be removed by using nipper to cut the leads.
On Power PWB
9. Parts List
Parts described in Annex VII of directive 2012/19/EU are as below.
Parts
Note
LCD
50inch LCD module
Printed Circuit Boards
Main I/F PWB
Power PWB
T-CON PWB
Battery
AAA battery
Electrolyte capacitors
(height >25mm, diameter >25mm)
On Power PWB
External electric cables
2 kinds of Power Cord
- for EU
- for UK
Other manuals for PN-HS501
1
Table of contents
Other Sharp Monitor manuals
Sharp
Sharp PN-R606 User manual
Sharp
Sharp LC-15M4E User manual
Sharp
Sharp PN-70HC1E User guide
Sharp
Sharp PN-L862B User guide
Sharp
Sharp LCD MONITOR User manual
Sharp
Sharp PN-K321H User guide
Sharp
Sharp PN-V701 Instruction sheet
Sharp
Sharp PN-325 User manual
Sharp
Sharp PN-V551 User manual
Sharp
Sharp PN-A601 User guide
Sharp
Sharp PN-HS431 User manual
Sharp
Sharp LCD MONITOR User manual
Sharp
Sharp LL-T2020 User manual
Sharp
Sharp PN-R903 User manual
Sharp
Sharp PN-Y325 User guide
Sharp
Sharp LC-20VM2 User manual
Sharp
Sharp PN-T321 User guide
Sharp
Sharp LL-T1815 User manual
Sharp
Sharp PN-425 User manual
Sharp
Sharp PN-T322B User manual
