Sharp AY-XM09BE User manual

AY-XM09BE

MULTI SPLIT TYPE

ROOM AIR CONDITIONER

INDOOR UNIT

OPERATION MANUAL

OUTDOOR UNIT

AY-XM

09BE

AE-XM18BE

CONTENTS

• PRECAUTIONS .................................................2

• ADDITIONAL NOTES ON OPERATION ...........4

• TIPS ON SAVING ENERGY..............................5

• PART NAMES....................................................6

• USING THE REMOTE CONTROL ....................8

• BASIC OPERATION ........................................10

• ADJUSTING THE AIR FLOW DIRECTION .....12

• ONE-HOUR OFF TIMER .................................13

• FULL POWER OPERATION ...........................13

• TIMER OPERATION........................................14

• SAVE OPERATION .........................................16

• AUXILIARY MODE ..........................................16

• MAINTENANCE...............................................17

• BEFORE CALLING FOR SERVICE ................18

• OPTION KIT ....................................................19

Thank you for purchasing a SHARP air con-

ditioner. Please read this manual carefully

before operating the product.

AY-XM09BEp/m 01.4.16, 3:45 PM1

PRECAUTIONS

WARNINGS FOR USE

1Do not pull or deform the power supply cable. Pulling and misuse of the power supply

cable can result in damage to the unit and cause electrical shock.

2Be careful not to expose your body directly to the outlet air for a long time. It may affect

your physical conditions.

3Whenusingtheairconditionerforinfants,children,elderly,bedridden,ordisabledpeople

make sure the room temperature is suitable for those in the room.

4Never insert objects into the unit. Inserting objects can result in injury due to the high

speed rotation of internal fans.

5Ground the air conditioner without fail. Do not connect the grounding wire to gas pipe,

waterpipe,lightningrodortelephonegroundingwire. Incompletegroundingmaycause

electric shock.

6If anything is abnormal with the air conditioner (ex. a burning smell), stop the operation

immediately and turn the circuit breaker OFF.

7Follow local rules and regulations for power supply cabling. Improper cable connection

can cause the power supply cable and the electrical outlet to overheat and cause fire.

8Use only the manufacture recommended power supply cable for replacement.

Replacement should be performed by a qualified technician or a service person.

WARNINGS FOR INSTALLATION / REMOVAL / REPAIR

• Donotattempttoinstall/remove/repairtheunitbyyourself.Incorrectworkwillcauseelectric

shock, water leak, fire etc. Consult your dealer or other qualified service personnel for the

installation/removal/repair of the unit.

This equipment complies with the requirements of Directives 89/336/EEC and 73/23/

EEC as amended by 93/68/EEC.

AY-XM09BEp/m 01.4.16, 3:45 PM2

CAUTIONS FOR USE

1Open a window or door periodically to ventilate the room, especially when using gas

appliances. Insufficient ventilation may cause oxygen shortage.

2Do not operate the buttons with wet hand. It may cause electric shock.

3For safety, turn the circuit breaker off when not using the unit for an extended period of

time.

4Check the outdoor unit mounting rack periodically for wear and to make sure it is firmly

in place.

5Do not put anything on the outdoor unit nor step on it. The object or the person may fall

down or drop, causing injury.

6This unit is designed for residential use. Do not use for other applications such as in a

kennel or greenhouse to raise animals or grow plants.

7Do not place a vessel with water on the unit. If water penetrates into the unit, electrical

insulations may deteriorate and cause electric shock.

8Do not block the air inlets nor outlets of the unit. It may cause insufficient performance

or troubles.

9Be sure to stop the operation and turn the circuit breaker off before performing any

maintenance or cleaning. A fan is rotating inside the unit and you may get injured.

Do not splash or pour water directly on the unit. Water can cause electrical shock or

equipment damage.

This appliance is not intended for use by young children or infirm persons without

supervision.

Young children should be supervised to ensure that they do not play with the appliance.

CAUTIONS FOR LOCATION / INSTALLATION

• Make sure to connect the air conditioner to power supply of the rated voltage and

frequency.

Use of a power supply with improper voltage and frequency can result in equipment

damage and possible fire.

• Do not install the unit in a place where inflammable gas may leak. It may cause fire.

Install the unit in a place with minimal dust, fumes and moisture in the air.

• Arrangethedrainhosetoensuresmoothdrainage. Insufficientdrainagemaycausewetting

of the room, furniture etc.

• Make sure a leak breaker or a circuit breaker is installed, depending on the installation

location, to avoid electrical shock.

AY-XM09BEp/m 01.4.16, 3:45 PM3

INDOOR TEMP. OUTDOOR TEMP.

COOLING upper limit 32˚C D.B. 43˚C D.B.

23˚C W.B. -

lower limit 21˚C D.B. 21˚C D.B.

15˚C W.B. -

HEATING upper limit 27˚C D.B. 24˚C D.B.

- 18˚C W.B.

lower limit 20˚C D.B. -8.5˚C D.B.

- -9.5˚C W.B.

ADDITIONAL NOTES ON OPERATION

OPERATING TEMPERATURE RANGE • The built-in protective

device may prevent the

unit from operating when

used out of this range.

• Condensation may form

on the air outlet if the

unit operates continu-

ously in the COOL or

DRY mode when humid-

ity is over 80 percent.

D.B. = Dry-bulb W.B. = Wet-bulb

WHEN POWER FAILURE OCCURS

This air conditioner has a memory function to store settings when a power failure occurs.

After power recovery, the unit will automatically re-start in the same settings which were

active before the power failure, except for timer settings.

If the timers were set before a power failure, they will need to be re-set after power recovery.

PREHEATING FUNCTION

In the HEAT operation, the indoor fan may not start for two to five minutes after the unit is

turned on to prevent cold air from blowing out of the unit.

DE-ICING FUNCTION

• When ice forms on the heat exchanger in the outdoor unit during the HEAT operation, an

automatic de-icer provides heat for about 5 to 10 minutes to remove the ice. During de-

icing, the inside and outside fans stop operating.

• After de-icing is completed, the unit automatically resumes operation in the HEAT mode.

HEATING EFFICIENCY

• The unit employs a heat pump that draws heat from the outside air and releases it into the

room. The outside air temperature therefore greatly affects the heating efficiency.

• If the heating efficiency is reduced due to low outside temperatures, use an additional

heater.

• It takes time to warm up and heat the entire room because of the forced air circulation

system.

AY-XM09BEp/m 01.4.16, 3:45 PM4

TIPS ON SAVING ENERGY

Below are some simple ways to save energy when you use your air conditioner.

SET THE CORRECT TEMPERATURE

• Setting the thermostat 1°C higher than the desired temperature in the COOL mode and

2°C lower in the HEAT mode will save approximately 10 percent in power consumption.

• Setting the temperature lower than necessary during cooling operation will result in

increased power consumption.

BLOCK DIRECT SUNLIGHT AND PREVENT DRAFTS

• Blocking direct sunlight during cooling operation will reduce power consumption.

• Close the windows and doors during cooling and heating operation .

SET PROPER AIR FLOW DIRECTION TO OBTAIN THE BEST AIR

CIRCULATION

KEEP FILTER CLEAN TO ENSURE THE MOST EFFICIENT OPERATION

MAKE MOST OF THE TIMER OFF FUNCTION

TURN OFF THE CIRCUIT BREAKER WHEN THE UNIT IS NOT USED FOR AN

EXTENDED PERIOD OF TIME

The indoor unit still consumes a small amount of power when it is not operating.

AY-XM09BEp/m 01.4.16, 3:45 PM5

PART NAMES

INDOOR UNIT 1Inlet (Air)

2Open Panel

3Operation panel

4Air Filters

5Indicator Panel

6Vertical Adjustment

Louvre

7Horizontal Adjustment

Louvres

8Outlet (Air)

9Remote Control

To open the panel, hold the bot-

tom corners of the open panel

and gently pull outwards.

0AUX. Button

qSIGNAL RECEIVER

Window

wOPERATION Lamp

(Red)

eTIMER Lamp (Yellow)

OUTDOOR UNIT rInlet (Air)

tRefrigerant Tube and

Interconnecting Cord

yOutlet (Air)

NOTES:

1. Actual units may vary slightly from those shown above.

2. AE-XM18BE is a multi-type outdoor unit and is connected to two indoor units. See the Installation

Manual for detail installation instructions.

AUX.

AY-XM09BEp/m 01.4.16, 3:45 PM6

REMOTE CONTROL

1TRANSMITTER

2DISPLAY (Liquid Crystal Display)

3ON/OFF Button

4THERMO. (Thermostat) Button

5SAVE Button

6MODE Button

7TIMER ON Button (for setting the timer)

8ONE-HOUR OFF TIMER Button

9TIMER OFF Button (for setting the timer)

0FAN Button

qTIMER CANCEL Button

wSWING Button

eFULL POWER Button

L.C.D. REMOTE CONTROL DISPLAY

rMODE SYMBOLS

:AUTO :HEAT

:COOL :DRY

tFAN SPEED SYMBOLS

:AUTO :Manual setting

yFULL POWER SYMBOL

uSAVE SYMBOL

iTEMPERATURE AND TIMER COUNT

DOWN INDICATOR

oTRANSMITTING SYMBOL

pTIMER ON/TIMER OFF INDICATOR

Indicates when timer on or timer off is set.

MODE

SAVE MODE

FAN1H

SWING

FULL POWER

CANCEL

TEMP.

FAN TIMER

AY-XM09BEp/m 01.4.16, 3:45 PM7

1Remove the battery cover at the

back of the remote control.

2Insert batteries in the compart-

ment, making sure the ±and

—polarities are correctly

aligned.

• Lines will be indicated on the

display when batteries are

properly installed.

3Reinstall the battery cover.

NOTES:

• The battery life is approximately one year in normal use.

• When you replace the batteries, always change both batteries, and make sure

they are the same type.

• If the remote control does not operate properly after replacing the batteries, take

out the batteries and reinstall them again after 30 seconds.

• If you will not be using the unit for a long time, remove the batteries from the

remote control.

Point the remote control towards the

unit’s signal receiver window and press

the desired button. The unit generates a

beep when it receives the signal.

• Make sure there is no curtain or other

object between the remote control and the

unit.

• The remote control can send signals from

up to 7 metres away.

USING THE REMOTE CONTROL

INSTALLING BATTERIES Use two size-AAA (R03) batteries.

HOW TO USE THE REMOTE CONTROL

Battery cover

AY-XM09BEp/m 01.4.16, 3:45 PM8

CAUTION

• Do not allow the signal receiver window to receive strong direct sunlight, since it can

adversely affect its operation. If the signal receiver window is exposed to direct sunlight,

close a curtain to block the light.

• Using a fluorescent lamp with a quick starter in the same room may interfere with

transmission of the signal.

• The unit can be affected by signals transmitted from the remote control of a television,

VCR or other equipment used in the same room.

• Do not leave the remote control in direct sunlight or near a heater. Also, protect the unit

and remote control from moisture and shock which can discolour or damage them.

AY-XM09BEp/m 01.4.16, 3:45 PM9

Press the MODE button to select the opera-

tion mode.

AUTO HEAT COOL DRY

BASIC OPERATION

2Press the ON/OFF button to start operation.

• The red OPERATION lamp on the unit will light

up.

3Press the THERMO. button to set the de-

sired temperature.

5• The temperature can

be changed in 1°C in-

crements within the

range of 2°C higher to

2°C lower from the

temperature automati-

cally determined by the

air conditioner.

AUTO SOFT LOW HIGH

Press the FAN button to set the desired fan

speed.

• In the DRY mode, the fan speed is preset to

AUTO and cannot be changed.

To turn off the unit, press the ON/OFF button

again.

• The red OPERATION lamp on the unit will turn

off.

MODE

SAVE MODE

FAN1H

SWING

FULL POWER

CANCEL

TEMP.

FAN TIMER

AUTO / DRY MODE

HEAT / COOL MODE

• The temperature can

be set within the range

of 18°C to 32 °C.

AY-XM09BEp/m 01.4.16, 3:45 PM10

This manual suits for next models

Table of contents

Other Sharp Air Conditioner manuals

Popular Air Conditioner manuals by other brands

Spheros

Spheros CC 355 instructions

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE owner's manual

Panasonic

Panasonic CS-E12HKEW operating instructions

nedis

nedis ACMB1WT7 quick start guide

Samsung

Samsung AR KV Series User & installation manual

Daikin

Daikin FCFV50A Operation manual

Fujitsu

Fujitsu Inverter ASBA30JFC operating manual

Toshiba

Toshiba RAS-M10SMUV-E installation manual

Daikin

Daikin FXLQ20MAVE Operation manual

Hitachi

Hitachi RAS-E24CAK instruction manual

CIAT

CIAT Magister 2 Series Installation, Operation, Commissioning, Maintenance

Bestron

Bestron AAC6000 instruction manual

Hisense

Hisense 7K Use and Installation Instructions

Frigidaire

Frigidaire FFRE0533S1E0 Use & care guide

Samsung

Samsung AS09HM3N user manual

Frigidaire

Frigidaire CRA073PU11 use & care

Soleus Air

Soleus Air GB-PAC-08E4 operating instructions

McQuay

McQuay MCK020A Technical manual