Sebart MYTHO S 30E User manual
SebArt professional line
Mytho S 30E
ARF
ASSEMBLY MANUAL
The new Mytho S 30E ARF was designed by Italy aerobatic pilot
Sebastiano Silvestri, it is the replica o his 2 meter size F3A
competition airplane, winner o the FAI F3A World Cup.
This pro essional ARF kit is the result o Sebastiano’s 25 years
experience in F3A world and his research in best F3A
per ormances. This innovative design combined with the
extremely lightweight structure all wood air rame and large
control sur aces give at Mytho S 30E ARF an impressive
agility, precision and smoothness at any airspeed and light
condition.
The Mytho S 30E ARF will be your mini F3A and 3D practice
dream plane!
.....the only aerobatic limit is your fantasy!
Specifications: Recommended Set Up:
Wingspan:.….........1280 mm Radio: 4+ ch. With 4 MG sub-micro servos
Length:…......……1350 mm Motor: ...Hacker A30-10XL+Jeti Master Basic 70A
Wing Area:..….32 dm² + top wing Prop: …………....................APC 14x10E
Weight:......... 1.450 g. Motor battery: …..…2500-3S or 3300-3S
(RTF less motor battery)
Required radio, motor and battery
Radio equipment:
•
Minimum 4-channel radio system
• 4
digital micro servo 17g.
•
2 servo extensions 400mm, or elevator and rudder servos
Recommended electric motor for best performance:
•
Hacker A30-10XL + Jeti Master Basic 70A SBec + APC 14 x 10E
•
Battery pack Top Fuel 2500-3S or 3300-3S
Additional required item
, tools and adhesives
Tools:
•
Drill
•
Drill bits: 1,5mm; 2mm; 2,5mm; 3mm
•
Phillips screwdriver
•
Hobby kni e
•
Masking tape
•
Paper towels
•
Rubbing alcohol
•
Sand paper
•
Soldering iron
•
synthetic oil
Adhesives:
•
5-minute epoxy
•
thin CA
•
medium CA
Warning
This RC aircra t is not a toy!
I misused, it can cause serious bodily harm and damage to property.
Fly only in open areas, pre erably in o icial lying sites, ollowing all instructions included with
your radio and motor.
This plane is a compromise between Aerobatics and 3D lying, and not a pylon racer.
It is built with a very light structure and or this reason we hardly recommend:
→ Do
NOT
fly
your
airplane
at
h i gh
speed s
, be ause this may ause stru tural
failures or flutter due to the extremely large ontrol surfa es.
Before st a rting assembly
Be ore starting the assembly o your Mytho S 30E, remove each part rom its bag and protection
or a prior inspection. Closely inspect the uselage, wing panels, rudder, and stabilizer or damage. I
you ind any damage or missing parts, contact the place o purchase.
I you ind any wrinkles in the covering, use a heat gun or covering iron to remove them. Use
caution while working around areas where the covering material overlap to prevent separating the
covers.
Warranty information
SebArt garantees this kit to be ree rom de ects in both material and workmanship at the date o
purchase.
This warranty does not cover any parts damage by use or modi ication, and in no case shall
SebArt’s liability exceed the original cost o the purchased kit.
Further, SebArt reserve the right to change or modi y this warranty without notice.
In that SebArt has no control over the inal assembly or material used or the inal assembly, no
liability shall be assumed or accepted or any damage o the inal user-assembled product. By the
act o using the product, the user accepts all resulting liability.
I the buyer is not prepared to accept the liability associated with the use o this product, the buyer
is advised to return this kit immediately in new and unused condition to the place o purchase.
Control throws
Please, ollow the recommended linkage setups:
For the AILERONS we recommend the ollowing throws:
High rate: 45° left & right
Normal flight: D/R: 30% Expo: 20%
Snap: D/R: 100% Expo: 90%
Spin & 3D: D/R: 100% Expo: 90%
For the ELEVATOR we recommend the ollowing throws:
High rate: 45° up & do n
Normal flight: D/R: 30% Expo: 30%
Snap: D/R: 40% Expo: 50%
Spin & 3D: D/R: 100% Expo: 95%
For the RUDDER we recommend the ollowing throws:
High rate: 45° left & right
Normal flight: D/R: 40% Expo: 60%
Snap: D/R: 50% Expo: 70%
Spin & 3D: D/R: 100% Expo: 90%
Note: the Expo is (+) or JR systems, and (–) or Futaba systems.
Mixing
For best per ormance, we recommend a linear-mix*:
Rudder → Elevator UP
When you give ull rudder to the right or le t side, the elevator have to go up (positive) approx. 2%
* i you have a programmable computer radio.
Re omme n ded CG
The recommended Center of Gravity location is 130mm behind the leading edge o the wing
against the uselage, that is good or pattern lying.
140mm is good or 3D lying.
You can use the battery pack, moving it orward or backward, to achieve the correct balance.
Range test your radio
Be ore ly, be sure to range check your radio as manu acturer’s instruction manual o you
radio-system recommend.
Double-check all controls (aileron, elevator, rudder and throttle) move in the correct
direction.
Be sure that your batteries are ully charged, as per the instructions included with your
batteries and that your radio is ully charged as per its instructions.
….good
flights!
SEBART International S.r.l.
Via L. Tabellione, 1
47891 Rovereta
Repubblica di San Marino (RSM)
Web site: www.sebart.it
Table of contents
Other Sebart Toy manuals
Sebart
Sebart KatanaS 30E User manual
Sebart
Sebart Aermacchi MB339 XS User manual
Sebart
Sebart KatanaS 50E User manual
Sebart
Sebart Avanti S XXL User manual
Sebart
Sebart MC-72 50E ARF scale Programming manual
Sebart
Sebart Katana S 50E V.2 User manual
Sebart
Sebart F3A-70E User manual
Sebart
Sebart Mini Avanti 1.4m ARF User manual
Sebart
Sebart KatanaS 120 ARF User manual
Sebart
Sebart Wind S 110 ARF User manual
Sebart
Sebart EDGE S 50E User manual
Sebart
Sebart Sukhoi 29S 50E ARF User manual
Sebart
Sebart Mytho S 125E ARF User manual
Sebart
Sebart Stev S 30E User manual
Sebart
Sebart PrometheuS 50E ARF User manual
Sebart
Sebart Professional KatanaS 30E User manual
Sebart
Sebart EDGE 540S 50E User manual
Sebart
Sebart PrometheuS 50E ARF User manual
Sebart
Sebart Cessna S 30-50E ARF User manual
Sebart
Sebart Mini Avanti User manual
