Seagate HAWK 2LP Family User manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

HAWK 2LP Family:

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

(Wide bus)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

ST32430W/WD/WC

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

ST32430DC

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

ST31230W/WD/WC

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

ST31230DC

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Installation Guide

Contents

Introduction........................................................... 1

Electromagneticinterference ................................ 1

Before you begin .................................................. 3

Installation overview ............................................. 8

Product Repair...................................................... 10

Shipping ......................................................... 11

Product Repair and return information ........... 11

Technical support services................................... 12

Hawk 2LP (wide) product information ................... 15

Initial setup information......................................... 16

Drive configuration................................................ 22

Drive installation ................................................... 33

Publication Number: 77767478, Revision A.

September 1994

Seagate®,SeagateTechnology®andtheSeagatelogo

areregisteredtrademarksofSeagateTechnology,Inc.

HawkTM, SeaFAXTM, SeaFoneTM, SeaTDDTM and

SeaBOARDTM aretrademarksofSeagateTechnology,

Inc.Otherproductnamesareregisteredtrademarksor

trademarks of their own.

Seagate reserves the right to change, without notice,

product offerings or specifications. No part of this

publication may be reproduced in any form without

written permission of Seagate Technology, Inc.

Hawk 2LP (Wide) Installation Guide, Rev. A 1

Introduction

Thismanualisorganizedtoassistyouintheinstallation

and operation of your Seagate Hawk 2LP (wide bus)

family disc drive. Family models are listed in the Prod-

uct Information section. It also provides information to

aid in obtaining service for the drive. The Hawk 2LP

(wide) family drives have a 16 bit data interface.

Beforeattemptinganyinstallation,pleasereadthrough

all applicable sections of this document, including all

warnings and cautions.

Warning.

This equipment generates,uses,andcanradiateradio

frequency energy and if not installed and used in

accordance with these instructions, may cause inter-

ference to radio communications.

Electromagnetic interference (EMI) con-

siderations

The drive(s) described herein, as delivered, are de-

signed for system integration and installation into a

suitable enclosure prior to use. As such, the drive(s)

described herein are supplied as a subassembly and

arenotsubjecttoSubpartJofPart15oftheFCCRules

2 Hawk 2LP (Wide) Installation Guide, Rev. A

and Regulations nor the Radio Interference Regula-

tionsoftheCanadianDepartmentofCommunications.

However,theunithasbeentestedusingpropershield-

ing and grounding and found to be compliant with the

ClassAlimitsoftheFCCRulesandtheRegulationsof

the Canadian Department of Communications.

The physical design characteristics of the drive(s)

described herein, serve to minimize EMI radiation

when installed in an enclosure that provides reason-

able shielding. As such, the drive(s) are capable of

meeting the Class B limits of the FCC Rules and the

RegulationsoftheCanadianDepartmentofCommuni-

cations.

Note. Itistheendusers'responsibilitytoassurethat

the drive(s)describedhereinmeetthe appro-

priate EMI requirements of their system.

Shielded I/O cables may be required if the

enclosure does not provide adequate shield-

ing.IfI/Ocablesare externaltotheenclosure,

shieldedcablesshouldbeused,withtheshields

grounded to the enclosure and to the host

controller.

Hawk 2LP (Wide) Installation Guide, Rev. A 3

Before you begin

Verify that the system is switched off and discon-

nected from main power before any installation is

attempted.

Protect yourself, the drive, and your valuable pro-

grams and data by reading the following cautions

and warnings.

•Donottamper withsealedtopcover.Doing sovoids

your warranty. The drive contains no user service-

able components. See Product Repair section for

more information.

•Visually inspect the shipping container for any obvi-

ous damage.

•Verifyallpartslistedonshippingbillarereceivedwith

theequipment.Discrepancies or damage should be

reported to the shipping company.

•Inspectdriveforpossibleshippingdamage.Allclaims

of this type should be filed promptly with the trans-

porterinvolved.Saveoriginalpackingmaterialstobe

used when reshipping.

4 Hawk 2LP (Wide) Installation Guide, Rev. A

•When transporting or shipping a drive or system,

please ensure that they are correctly packed in

original Seagate approved (or equivalent) container

and shipped via an air-ride carrier experienced in

handling computer equipment.

•Donotunpack drivefromitsstaticshielded baguntil

you are ready to install it in the system.

•Always handle the drive by the frame or casting.

•Donot touch PrintedCircuit Board (PCB) or theI/O

connector pins.

•Never apply pressure to the PCB or to the drive top

cover

Hawk 2LP (Wide) Installation Guide, Rev. A 5

Caution. Thecircuitassembliesandcomponentscon-

tained in this equipment can be degraded or

destroyedbyElectrostaticOverstress(EOS)

or by Electrostatic Discharge (ESD).

Static electrical charges can accumulate

quickly on personnel, clothing and synthetic

materials.Theelectrostaticfieldsduetothese

charges when brought in close proximity to

susceptible circuit assemblies and compo-

nents, can result in degraded reliability or

immediatefailureoftheaffected component

or assembly.

Toinsureoptimumreliableequipmentopera-

tion, it is required that technical support per-

sonnel discharge themselves by wearing a

grounding strap around the wrist and be

connectedtoagroundingterminalwhilework-

inginthevicinityof,andwhilehandlingEOS/

ESDsusceptibleassemblies/parts.Ifunavail-

able,groundyourself frequently by touching

the metal chassis of the system before han-

dling any components (this helps only if the

system is connected to a ground).

Avoid

static-inducing carpeted areas.

This proce-

dure is especially important when handling

printed circuit boards (PCB's).

Safety instructions

1. The disc drive(s) are to be installed in a customer

suppliedenclosurewherethesurroundingairdoes

not exceed 50oC.

2. Four (4) 6-32 UNC-2A screws are required for

installation. Maximum screw length into side of

drive is 0.15 inches (3.81 mm). Maximum screw

lengthintobottomis0.20in.(5.08mm).Maximum

screw tightening torque is 6.0 in-lb (.675 NM) with

minimumthreadengagementof0.12in(3.05mm).

3. ThepowerrequirementsareshownintheProduct

Informationsection.

4. The power supply must satisfy the safety require-

ments for SELV (Safety Extra Low Voltage) cir-

cuits.

5. Service is to be provided by trained Seagate ser-

vice personnel.

6. The incorporation of the disc drives listed in this

guide into a customer enclosure must meet the

appropriate safety requirements of the country in

which it is used (e.g. UL 1950, CAN/CSA-C22.2

No.950-M89,DINVDE0805:1993andEN60950:

1992 (IEC 950).

Note. Power must be off when connecting or discon-

necting.

6 Hawk 2LP (Wide) Installation Guide, Rev. A

Sicherheitsanleitung

1. DäsGerätisteinEinbaugerät,vorgesehenfüreine

maximale Umgebungstemperatur von 50oC.

2. Zur Befestigung des Drives werden 4 Schrauben

benötigt (6-32 UNC-2A). Die maximale Länge der

Schrauben in der unteren Seite des Chassis darf

nicht mehr als 0.20 in (5.08 mm) betragen, die in

der oberen 0.15 in (3.81 mm). Maximalle

Schraubenanziehung von 6.0 in-lb (.675 NM) mit

minimalemGewindeansperuch0.12in(3.05mm).

3. DieVersorgungsspannungenwerdeninderSektion

Produkt Information gezeigt.

4. Die Versorgungsspannung muss SELV entspre-

chen.

5. AlleArbeitendürfennurvonausgebildetemSeagate

Service-Personal durchgefürhrt werden.

6. Der Einbau des Drives muss den Anforderungen

gemässDINVDE0805:1993oderEN60950:1992

(IEC 950).

Vorsicht

ÁnsehlussoderEntfernungolerGeräteverbindungnur

beiabgeschalteterVersorgungsspannungvornehmen.

Hawk 2LP (Wide) Installation Guide, Rev. A 7

Installation Overview

Installation of the drive can be divided into distinct

phases. Some of these may not be applicable to all

system installation requirements. Refer to the indi-

vidualdriveinstallationsectionsforspecificinformation

on your drive model.

•Drive configuration: Select those drive features

thatareappropriatetoinstallthedriveinthesystem.

In"W/WD"modelsthisisdonebyinstallingorremov-

ing user configuration jumpers found on the drive

PCB. For "WC/DC" models, some of the configura-

tionparameters canbe setover the80 pininterface.

•Mechanical installation: After setting up the drive

configuration the drive must be mechanically in-

stalled into the host system and the power and I/O

cables attached. Previously mentioned precautions

should be observed.

•CMOS configuration: SCSI drives should not be

definedintheCMOS.TheSCSIhostadapterusesits

own BIOS to handle the Input/Output procedures.

TheCMOS settingfor SCSIdriveis eitherdrive type

zero, or the no drive installed option.

8 Hawk 2LP (Wide) Installation Guide, Rev. A

This manual suits for next models

Table of contents

Other Seagate Storage manuals

Seagate

Seagate GoFlex Turbo User manual

Seagate

Seagate STM303004N1AAA-RK - Maxtor Basics 300 GB Hard... User manual

Seagate

Seagate ST34371N - Barracuda 4.3 GB Hard Drive User manual

Seagate

Seagate ST1000LX000 User manual

Seagate

Seagate ST3160812AV User manual

Seagate

Seagate ST31000520AS - Barracuda LP 1 TB Hard Drive User manual

Seagate

Seagate Momentus ST9160824AS User manual

Seagate

Seagate Savvio 15K.1 FC ST973451FC User manual

Seagate

Seagate Medalist Pro 2160N User manual

Seagate

Seagate Momentus ST160LT003 - 9YG141 User manual

Seagate

Seagate Barracuda 18LP FC User manual

Seagate

Seagate ST3600002FC - Cheetah 600 GB Hard Drive Operating and safety instructions

Seagate

Seagate ST31000528AS - Barracuda 7200.12 1 TB 7200RPM SATA 3 GB/s 32 MB Cache Hard... User manual

Seagate

Seagate ST8000NM0065 User manual

Seagate

Seagate ST6000NM0075 User manual

Seagate

Seagate ST318404LW User manual

Seagate

Seagate MARATHON 810 User manual

Seagate

Seagate Momentus 5400.1 Cruise ST93012A-AM User manual

Seagate

Seagate BARRACUDA 4FC User manual

Seagate

Seagate Spinpoint M8U Installation guide

Seagate

Seagate ST9160511NS - Constellation 7200 160 GB Hard... User manual

Seagate

Seagate Barracuda Series User manual

Seagate

Seagate IRONWOLF PRO NAS ST16000NE000 User manual

Seagate

Seagate Momentus ST250LT003 - 9YG14C User manual

Popular Storage manuals by other brands

QNAP

QNAP TS 32PXU Series user guide

LaCie

LaCie RUGGED RAID user manual

Freecom

Freecom CLS DOCK Quick install guide

PNY

PNY Attache P-FD64MBATT3 install guide

HP StorageWorks MSL2024 Getting started

OLT

OLT 6x6 Maximizer Assembly manual

Transcend

Transcend JetFlash 160 Specifications

LaCie

LaCie RUGGED MINI user manual

Thunderbolt

Thunderbolt 600 user manual

Panasonic

Panasonic LB-DH8 series Operator's guide

Intel

Intel RAID High Availability user guide

LaCie

LaCie 12big Thunderbolt 3 Quick install guide

Spectra Logic

Spectra Logic T-Series Spectra T50e quick start guide

Panasonic

Panasonic LKM-F931-1 instruction manual

Tabernus

Tabernus Enterprise Erase E2400 user guide

Rocstor

Rocstor COMMANDER 3F series user manual

HP P9000 user guide

Western Digital

Western Digital Ultrastar Data60 installation guide