Samsung SiPTel C01 User manual

SiPTelC01 IP Phone User Manual

SiPTel C01

IP Phone

5.2E version

User Manual 3.1.00

SiPTelC01 IP Phone User Manual

SAFETY INFORMATION

Meticulous care had been devoted to ensure the highest safety standards in manufacturing of your SiPTel

IP Phone. Safety is the major factor in designs of every set. But, safety is your responsibility too.

Use only the power chord that comes with your SiPTel IP Phone. (Output: DC 5V/1.5A)

To reduce the risk of electric shock, do not disassemble this product. There are no user serviceable parts.

Opening or removing covers may expose you to hazardous voltages. Incorrect reassembly can cause

electric shock when this product is subsequently used.

Never push objects of any kind into the equipment through housing slots since they may touch hazardous

voltage points or short out parts that could result in a risk of electric shock. Never spill liquid of any kind on

the product. If liquid is spilled, however, refer servicing to proper service personnel.

Use only Unshielded Twisted Pair (UTP) Category 5 Ethernet cable for RJ-45 port of the SiPTel IP Phone.

SiPTelC01 IP Phone User Manual

TABLE OF CONTENTS

1. INTRODUCTION

1.1. Overview

1.2. Features

1.3. Specification

1.4. Structure of SiPTel IP Phone

1.4.1.Keypad

1.4.2.LCD Display

1.4.3.LED Display

1.4.4.Port Structure

2. PRE-INSTALLATION CHECK LIST

2.1. Power Requirements

2.2. Component Check List

2.3. User Requirements

3. INSTALLATION & INSTRUCTIONS

3.1. Connecting Cables

3.2. Booting Up process

3.3. Keying Instructions

4. GETTING STARTED WITH MENU

4.1. Call Log

4.1.1.Received Calls

4.1.2.Dialed Calls, Missed Calls, Tx / Rx Calls

4.1.3.Delete All

4.2. Phone Book

4.2.1.Find Number

4.2.2.Add

4.2.3.Memory Dial

4.2.4.Delete All

4.3. Ring/Volume

4.3.1.Ring Selection

4.3.2.Ringing tone Volume

4.4. Setup

4.4.1.My Phone

4.4.2.Network

SiPTelC01 IP Phone User Manual

4.4.3.Call Setup

4.4.4.Modem

4.4.4.1. Call Options

4.4.5.Time

4.4.6.PSTN

4.4.7.HTTP PROXY

4.5. Information

4.5.1.Network

4.5.2.Version

4.6. BALANCE

4.7. Reboot

5. USING SIPTEL IP PHONE

5.1. Connecting IP Phone to Internet

5.1.1.Using in Dialup Mode

5.1.2.Using with Broadband Cable

5.2. Making a VoIP Call

5.2.1.In On-Hook mode (Pre-dial)

5.2.2.In Off Hook mode

5.3. Making a PSTN Call

5.4. Making a call in Phone Book mode

5.5. Making a call from Call Log mode

5.6. Memory Dial

5.7. Web Access

SiPTelC01 IP Phone User Manual

1. INTRODUCTION

1.1. Overview

The SiPTel IP Phone is a single user VoIP (Voice over Internet Protocol) phone for the home or small-

medium size businesses. The SiPTel IP Phone supports ITU-T H.323 protocol for voice communication on

data lines. It is a stand-alone device, which means no PC connection is required to use it. The SiPTel IP

Phone allows user to make long distance call or international call at low cost. Using the standard protocol,

SiPTel IP Phone can interoperate with most Internet devices for communication over the Internet.

1.2. Features

• Easy to use, simple to activate

• VAD (Voice Activity Detection)

• Volume control separate for both PSTN and VoIP calls

• Three Speed Dialing keys

•100 numbers storage Phone book

• Last number redial for both PSTN and VoIP

• 4 line Graphic LCD display

• Call Mute

• Silence Suppression

• Echo Cancellation

• Excellent voice quality DSP technology

• Network management with SNMP-based NMS

• Software updates/upgrades via remote access

• Configurable phone number assignment to match dial plan

• Remote management via SNMP, Telnet and HTTP

1.3. Specification

LAN Interface Standards

IEEE 802.3

Supports Static, DHCP, PPPoE

Dial-up Interface

• Data Rates from 300 bps to 56k bps.

SiPTelC01 IP Phone User Manual

• Data Modulation Standards V.90, V.34, V.432bis, V.22bis, V.22, V.23, V.21 and V.23 reversible

(Minitel), Bell 212, Bell 103 Dialup Modem V.42 Error Control

• Country Code support

• V.42 Error Control

• V.42bis Compression

• Protected Against Surge and Over voltage on the Telephone Line

Configuration Management

Telnet, RS-232, Http, LCD display

Protocol & Codec Specifications

Protocol : ITU H.323 v4, H.225, H.245

Codec : ITU G.711, G.729.A, G.723.1

Power

5VDC, 2A

Dimensions

14cm W × 4.3cm H × 17.5cm D

Weight

0.73kg

Operating Temperature

32oF to 131oF(0oC to 55oC)

Operating Humidity

10% to 85% no condensing.

Storage Temperature

32oF to 149oF(0oC to 65oC)

Storage Humidity

5% to 90% non condensing

SiPTelC01 IP Phone User Manual

1.4. Structure of SiPTel IP Phone

1.4.1. Keypad

Figure 1) Keypad Structure of SiPTel IP Phone

The description for each key is as follows.

Key name

Description

Menu ŸUsedto initiate the menu on LCD

ŸUsedto change between preferences when entering characters (English-

capital and lowercase / numerical / special characters).

M1~M3 ŸMemory dial

DEL ŸUsedto delete the characters in Pre-dial and Phone Book mode.

•ŸUsedto move up the cursor to select menu.

‚ŸUsed to move down the cursor to select menu.

„Call Log ŸUsedto move the cursor to the right in Phone Book mode.

ŸUsedto initiate the Call Log menu in off hook mode.

SiPTelC01 IP Phone User Manual

ƒP-Book ŸUsedto move the cursor to the left in Phone Book mode.

ŸUsedto initiate the Phone Book menu.

OK ŸUsedto complete the input in Phone Book menu.

ŸUsedto confirm the entered or selected settings.

Cancel ŸUsedto cancel the selected menu, entered data, or etc.

PSTN ŸUsedto place the PSTN call.

MUTE ŸUsedto make the voice not to be heard from the counterpart.

@ISP ŸUsed to connect to dial-up ISP. (Option).

VOL + / -ŸUsedto adjust the volume of the handset

FLASH ŸUsedto place another call by droping the current call while dialing or in

the middle of a connected call. (Available only in PSTN mode).

REDIAL ŸUsedto redial the number last dialed

Speaker ŸUsedto carry on the call without picking up the handset. Press again to

turn off the speaker phone

1.4.2. LCD Display

The LCD screen shows the current status of the SiPTel IP Phone, menu options on the LCD screen,

Telephone number dialed or received etc. (4x15)

First Line Status display –displays the present state of the IP Phone.

Second Line Name display –displays the name entered by the user.

Third Line Telephone number display –displays number entered using keypad.

Fourth Line Current time display

The following are icons used to display the present state of the IP Phone

Icon Name Function

DNS Status Displays the DNS status.

Flashing : Finding the DNS server

Constant : Could reach the IP Address of the DNS

Gatekeeper Displays the G/K registration status.

SIPTEL

10100-1000 A12:00

SiPTelC01 IP Phone User Manual

Status Flashing :Trying to find the Gatekeeper.

Constant :Registered with Gatekeeper successfully.

Call status

display : Displayed when the call is connected successfully.

: Displayed when the call isn’t connected.

Kinds of

connection

: Static IP

: DHCP

: PPPoE

Mute ŸDisplayed when using Mute function.

Flash save

display ŸDisplayed when data is being saved in memory

Ethernet ŸDisplayed when the SiPTel IP Phone is connected to the Internet

thru Ethernet cable.

Modem ŸDisplayed when the SiPTel IP Phone is connected to Internet thru

the Modem.

Summer Time ŸDisplayed when the summer time is applied.

Entry mode

ŸDisplays the input mode.

: Symbols

: English Lower Case

: English Capital

: Numeric

Navigation key ŸDisplayed only when the navigation key is available for menu

selection.

1.4.3. LED Display

PSTN ŸGlows when using PSTN mode.

@ISP ŸGlows when using Dial-up connection.

1.4.4. Port Structure

POWER §Use to connect to the power adapter.

ETHERNET §Use to connect to Internet leased line, cable modem, ADSL Modem, or etc. for

internet connection.

LINE §Use to connect to the regular telephone line.

Figure 2) SiPTel IP Phone Rear Panel

SiPTelC01 IP Phone User Manual

2. PRE-INSTALLATION CHECK LIST

2.1. Power Requirements

§AC Voltage : External power adapter (100V-240V, 50/60Hz).

§Please use only the power adapter provided with the SiPTel IP Phone.

§For additional power adapter, please ask your product provider.

Safety

Should liquid or solid object get into the cabinet, unplug the unit and have it checked by the

qualified personnel before operating it any further.

To disconnect the cord, pull it out by the plug. Never pull the cord itself.

Do not place the unit in surfaces (rugs, blankets, etc.) or near materials (curtains, draperies)

that may block the ventilation holes.

Installation

Do not install the unit in an extremely hot or humid place or in a place subject to excessive dust

or mechanical vibration. The unit is not designed to be waterproof. Exposure to rain or water

may damage the unit.

Cleaning

Clean the unit with a slightly damp soft cloth. Use a mild household detergent. Never use

strong solvents such s thinner or benzene as they might damage the finish of the unit.

2.2. Component Check List

Open the box of SiPTel IP Phone and make sure all the components are included in the box. The

following is the pictures of SiPTel IP Phone components. The picture can be different with the actually

models of SiPTel IP Phone.

SiPTel IP Phone -1

Handset -1

Coiled Cord -1

Power adaptor -1 User Manual -1

Table of contents

Other Samsung IP Phone manuals

Samsung

Samsung SGH-e317 User manual

Samsung

Samsung OfficeServ ITP-5012L User manual

Samsung

Samsung SMT-i6011 User manual

Samsung

Samsung GA68-60747A User manual

Samsung

Samsung SMT-I3105 User manual

Samsung

Samsung SMT-i5264 Service manual

Samsung

Samsung SMT-I3105 User manual

Samsung

Samsung OfficeServ ITP-5121D User manual

Samsung

Samsung OFFICESERV 100 Series User manual

Samsung

Samsung SMT-i6021 User manual

Samsung

Samsung SMT-5100 User manual

Samsung

Samsung OfficeServ ITP-5112L User manual

Samsung

Samsung SGH-P716 User manual

Samsung

Samsung OfficeServ SMT-I5220 User manual

Samsung

Samsung SMT-i6020 User manual

Samsung

Samsung OfficeServ DS-5038S User manual

Samsung

Samsung OfficeServ SOHO SIT200EM User manual

Samsung

Samsung SMT-i5343 User manual

Samsung

Samsung OfficeServ 7000's User manual

Samsung

Samsung OFFICESERV 100 Series Specification sheet

Samsung

Samsung SMT-i5210 User manual

Samsung

Samsung OfficeServ ITP-5012L User manual

Samsung

Samsung ITP-5100V User manual

Samsung

Samsung SCH-n330 Series User manual

Popular IP Phone manuals by other brands

Alcatel

Alcatel 4028 manual

Polycom

Polycom Polycom VVX 600 quick reference

Polycom

Polycom SoundPoint IP 450 datasheet

Cisco

Cisco SPA-500 Series user guide

Polycom

Polycom SoundPoint IP 650 user guide

Proximus

Proximus Maestro 3016 IP quick start guide

Fanvil

Fanvil X4 user manual

Cisco

Cisco 7962 user guide

Snom

Snom 320 quick start guide

Yealink

Yealink Yealink SIP-T46G Guide

Avaya

Avaya 4625SW user guide

Yealink

Yealink SIP-T52S quick start guide

Nortel

Nortel 1140E Getting started

Nexotek

Nexotek NT-P500 user manual

Avaya

Avaya Integral 5 R3.0 user guide

GE 28320EE2 - Dect 6.0 InfoLink 2 user guide

Avaya

Avaya 4600 Series Administrator's guide

Mitel

Mitel MIVOICE OFFICE 400 6940 SIP user guide