Riso Comcolor X1 Series User manual
Riso ComColor FW/GD/X1 Pre-Check
Before using your Riso ComColor after a long period of non-use
•Turn machine ON
•Wait until machine is finished warming up and in idle mode.
•Press the round [Home button] located on the lower left-hand corner [GD/FW] [ Mode button] upper left-hand
corner [X1] of the control panel to return to home screen.
•On FW/GD Perform machine Strong Head cleaning. From the home screen press [Maintenance] follow by [Head
Cleaning] select [Strong Cleaning]and press OK
•On X1 select [Functions] [Head Cleaning] and choose [Normal cleaning] or [Strong cleaning] and [OK]
•Test machine by running live jobs
If image output is not satisfactory on the FW/GD continue to next step. (not available
on X1)
FW/GD
FW/GD
X1
FW/GD
FW/GD
FW/GD/X1
X1
X1
Riso ComColor FW/GD/X1 Pre-Check
FW/GD Only
CAUTION: Certify that the ink cartridges are not near empty
•From the Home Screen, enter machine Test Mode area, using numeral keypad, press and hold [ * ] [ 8 ] [ #] until
passcode is requested. Enter (3214) as passcode and press OK.
•Using keypad, enter TM 09-3-068 press [start] key then [start] again to initiate Ink Circulation
This Test Mode will take approximately 10 minutes to complete
•Once the TM09-3-068 has completed, exit machine Test Mode area by pressing [STOP- red round button] followed
by the [Round Home button].
•Test machine by running live jobs
Other manuals for Comcolor X1 Series
3
This manual suits for next models
2
Table of contents
Other Riso Printer manuals
Riso
Riso GOCCOPRO QS200 User manual
Riso
Riso CZ180 Series User manual
Riso
Riso MiScreen Manual
Riso
Riso HC5500 User manual
Riso
Riso Comcolor Series User manual
Riso
Riso ComColor FW5230 User manual
Riso
Riso KZ30 User manual
Riso
Riso SF Series User manual
Riso
Riso ComColor GD9630 User manual
Riso
Riso SF EII Series User guide
