QuietCool IT-AC-KIT User manual

Rev 1.0

Page 1 of 2

Air Control

Installation Guide

IT-AC-KIT which includes (IT-AC-HUB-01) and (IT-AC-SCREEN)

Overview

This document summarizes introductions for operating hub IT-AC-HUB-01. The IT-AC-HUB-01 can remotely control the QuietCool Whole House Fans

of QC Manufacturing Inc at up to 3 different speeds.

Key Specifications

IT-AC-HUB-01(Hub):

Voltage: 120V

Frequency: 60Hz

Motor load: 1HP, 735W(Max)

Warning:

- Disconnect power at the circuit breaker

before installing or servicing

- Use wires rated at least 105*C – copper

only

- Installation/wiring must be in accordance

with national and local code regulations

- Keep the enclosure cover closed at all

times when not servicing.

- Cover all unused wires with a wire

connector

FCC Regulations:

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the

equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more

of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Rev 1.0

Page 2 of 2

Fig. 1 Dip Switch for Fan Speed Configuration

1 speed fan: Dial 1 to "ON”; and

2 speed fan: Dial 2 to "ON”; and

3 speed fan: Dial 3 to "ON”

Fig. 2 Connection Wires of IT-AC-HUB-01

Input wires:

Black: Line voltage,

ACL

White: Neutral, CAN

Output wires:

Red: Low speed

Yellow: Medium speed

Blue: High speed

Installation

IT-AC-HUB-01:

(Please switch off main power before wiring. The installation should be done byqualified personnel

only)

The hub (with a curved bottom) should be attached to the cylindrical fan housing and is wired to the

fan motor.

Remove the screw that holds down the hub cover and flip it up. Once the cover isopen, a three digit

dip switch is available for fan speed configuration, as shown in Fig. 1.

Once wiring is completed, close the hub cover and tighten the screw.

Operation

1. Power on the Hub:

Switch on power to the hub, the Power indicator on the hub will be on, and other three indicators will stay off. Press the “Test” button to change fan speed,

the fan will run in the following cycles:

1 speed fan: on -> off -> on -> off,