Quantum DLTtape DLT1 User manual

DLT™ TAPE UNIT INSTALLATION

HP® 9000 Series 700 System

HP-UX® 9.X

Installation

The system must have the appropriate SCSI interface for DLT drive to attach to, i.e., a SCSI single-ended

DLT drive can be attached only to a SCSI single-ended interface. The same is true for SCSI differential

attachment. The hardware attachment simply requires the DLT tape peripheral to be attached to the

interface while the system is powered down. After the DLT tape peripheral has been attached, you will

need to perform certain system operations that will allow DLT device system recognition.

Perform the installation as follows:

1. Shutdown the system and remove ac power from the system. Install the DLT tape

peripheral and connect it to its SCSI controller. Refer to the following manual for

switch and jumper settings and SCSI bus termination:

• DLT1/DLT7 Install and Operations Guide Set the DLT SCSI device address to an

unassigned ID.

1. Power up the system. During the power-up, the process allows you to stop the

sequence by pressing the ESC key. By doing so, you can verify drive attachment

by issuing a search for boot device selection. This will display all attached SCSI

devices including the DLT tape drive. The boot process can continue by selecting

the appropriate boot disk.

2. Log on as root and change directory to /dev/rmt

In the next step, you will create a set of device files that will allow DLT device access. These device files

allow certain DLT device modes of operation.

1. Enter the following commands:

mknod 1m c 54 0x201402

mknod 1mn c

54 0x201403

mknod 1c c 54 0x2014c2

mknod 1cn c 54 0x2014c3

The device files created are for an installed DLT device with a SCSI ID of 4 and are shown below along

with their corresponding operating characteristics:

1m - drive 1, rewind on close

1mn-d

rive 1, no rewind on close

1c - drive 1, compressed, rewind on close

1cn - drive 1, compressed, no rewind on close

Associating the device files to a DLT device with a SCSI ID other than

requires that the number "4" in the minor number of the

mknod command be changed to the new ID.

DLT Mini-Library Usage

The HP-UX operating system does not support SCSI-2 media changer device commands. Therefore, an

installed DLT7 mini-library can not be utilized in random access mode and can only be accessed in

sequential mode. Refer to the DLT1/DLT7 Install and Operations Guide for detailed description of these

access modes.

Other manuals for DLTtape DLT1

This manual suits for next models

Table of contents

Other Quantum Storage manuals

Quantum

Quantum A-Series FTP User manual

Quantum

Quantum StorNext QD7000 User manual

Quantum

Quantum Quantum Bigfoot CY User manual

Quantum

Quantum DXi3500 User manual

Quantum

Quantum DXi4500 User manual

Quantum

Quantum Scalar i500 User manual

Quantum

Quantum DXi3500 Technical manual

Quantum

Quantum LTO 2U Instruction sheet

Quantum

Quantum Scalar i500 User manual

Quantum

Quantum Quantum Fireball SE User manual

Quantum

Quantum F2000 User manual

Quantum

Quantum StorNext M330 Installation instructions

Quantum

Quantum StorNext QD7000 Installation and operation manual

Quantum

Quantum LTO3 A-Series User manual

Quantum

Quantum ATL M-Series User manual

Quantum

Quantum Scalar 50 User manual

Quantum

Quantum DLTtape SDLT 600 User manual

Quantum

Quantum Scalar i40 User manual

Quantum

Quantum QXS-424 User manual

Quantum

Quantum StorNext AEL500 User manual

Quantum

Quantum ATL M1500 User manual

Quantum

Quantum Scalar i6000 User manual

Quantum

Quantum DLT-S4 User manual

Quantum

Quantum PX502 User manual

Popular Storage manuals by other brands

QNAP

QNAP TS 32PXU Series user guide

LaCie

LaCie RUGGED RAID user manual

Freecom

Freecom CLS DOCK Quick install guide

PNY

PNY Attache P-FD64MBATT3 install guide

HP StorageWorks MSL2024 Getting started

OLT

OLT 6x6 Maximizer Assembly manual

Transcend

Transcend JetFlash 160 Specifications

LaCie

LaCie RUGGED MINI user manual

Thunderbolt

Thunderbolt 600 user manual

Panasonic

Panasonic LB-DH8 series Operator's guide

Intel

Intel RAID High Availability user guide

LaCie

LaCie 12big Thunderbolt 3 Quick install guide

Spectra Logic

Spectra Logic T-Series Spectra T50e quick start guide

Panasonic

Panasonic LKM-F931-1 instruction manual

Tabernus

Tabernus Enterprise Erase E2400 user guide

Rocstor

Rocstor COMMANDER 3F series user manual

HP P9000 user guide

Western Digital

Western Digital Ultrastar Data60 installation guide