Prorack K947 User manual
K947
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 4 x 4 x 4 x 1
x 4 x 8
Revision No: 3C 1
Fitting Kit K947
MAX kgs (lbs)
W/P WHD
Peugeot
Bipper, 5dr Van 08-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Fiat
Fiorino, 5dr Van 08-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Fiorino, 5dr Van 08-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
Citroen
Nemo, 5dr Van 08-13 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
2
Fitting Kit K947
X
A B C 1 2 3
Bipper, 5dr Van 08-+ (EU) -250mm 510mm - 1010mm 957mm -
-9 -13/16ths" 20 1/16ths" - 39 3/4ths" 37 11/16ths" -
Fiorino, 5dr Van 08-+ (EU) -250mm 510mm - 1010mm 957mm -
-9 -13/16ths" 20 1/16ths" - 39 3/4ths" 37 11/16ths" -
Fiorino, 5dr Van 08-+ (ZA) -250mm 510mm - 1010mm 957mm -
-9 -13/16ths" 20 1/16ths" - 39 3/4ths" 37 11/16ths" -
Nemo, 5dr Van 08-13 (EU) -250mm 510mm - 1010mm 957mm -
-9 -13/16ths" 20 1/16ths" - 39 3/4ths" 37 11/16ths" -
3
Fitting Kit EN
K947
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
●Use keys to remove covers.
4
Fitting Kit EN
K947
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Set bars to length (revert to rear of these
instructions).
●Please check the front of this manual for
information relating specifically to your
vehicle.
5
Fitting Kit EN
K947
●Tighten adjusting screw to 2 Nm (1.5 ft lb)
hand tight.
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Remove both pins from each leg. Use
tapered end of spanner located inside left
hand cover to assist.
6
Fitting Kit EN
K947
●Detach foot from leg. Store loose parts in a
safe place.
●Repeat for all legs.
●Assemble foot from kit into leg.
●Insert pins through foot into leg.
7
Fitting Kit EN
K947
●Select plastic internal block (from fitting kit)
and insert into foot.
●Repeat for all legs.
Fitment
●Open or remove fixed-point covers.
●Select grubscrews and screw into the
vehicle's fixed points.
●Repeat for all four positions.
8
Fitting Kit EN
K947
●Apply transparent tape next to fixed point.
●Place crossbar foot over grubscrews.
●Ensure the plastic knob is in the position
shown when fully tightened.
●Repeat for all four positions.
9
Fitting Kit EN
K947
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
10
Table of contents
Other Prorack Automobile Accessories manuals
Prorack
Prorack K1234 User manual
Prorack
Prorack K673 User manual
Prorack
Prorack K312 User manual
Prorack
Prorack K1018 User manual
Prorack
Prorack K409 User manual
Prorack
Prorack K165 Operation and installation manual
Prorack
Prorack K405 User manual
Prorack
Prorack K676 Operation and installation manual
Prorack
Prorack K774 User manual
Prorack
Prorack K507 User manual
Prorack
Prorack K888 User manual
Prorack
Prorack K820 User manual
Prorack
Prorack K470 User manual
Prorack
Prorack K419 User manual
Prorack
Prorack K786 User manual
Prorack
Prorack K708 User manual
Prorack
Prorack K087 User manual
Prorack
Prorack K381 User manual
Prorack
Prorack K751 User manual
Prorack
Prorack K411 User manual
