Record messages
NB! It is important that the unit is within earshot whilst programming, since you have to wait
for a ‘beep’of acknowledgment from the unit when recording messages!!!
1. Call the unit and await one or two tones
2. If one tone is heard, then type password (e.g. 1234). In case of wrong password the unit
disconnects and you have to call again
3. If two tones are heard, the password is correct or the SIM card PIN code is deactivated
4. Enter ’#’and the number of the message you want to record, e.g. #8 (for general message). See
additional codes in the table below
5. Await 1 tone from the telephone and after approx. 3 secs. a ’beep’ from the unit
6. Record message of max. 3 secs. After 6 secs. the unit emits a ’beep’and the message is saved
7. Wait an additional 6 secs. and two tones are heard
8. The message has now been recorded and the call may be ended or a new voice message
recorded, e.g.:
9. Enter #1 (voice message for input 1)
10. Await a tone from the telephone and after approx. 3 secs. a ’beep’ from the unit
11. Record a message of max. 3 secs. After 6 secs. a ’beep’ is heard from the unit and the message
is saved
12. Wait an additional 6 secs. and two tones are heard from the telephone
13. Repeat step 9-12 for more messages
14. Hang up
Programming cable (SubD RS 232 plug) must not be connected whilst recording and/or testing
voice messages!
When a voice message is received, you’ll hear the general message first and after an additional 5
secs. the individual message is heard (from digital input, analog input or a basic alarm). If only
general message has been recorded, this will be played twice.
The receiver can acknowledge a voice message with #. This must be done immediately after
playback of the last message and tone from the telephone. If this isn’t done, the unit will continue to
the next receiver on the list.
