Note
•Make sure that nothing obstructs around the mounting location of the door.
A hole for mounting may already be cut out of the inner panel of the door
•
(front or rear). In this case, you need to modify the board only.
Ensure that the speaker terminals, frame or magnet do not interfere with any
•
inner parts, such as the window mechanism in the door (when you open or close
the window), etc. Also ensure that the speaker grille does not touch any inner
ttings,suchasthewindowcranks,doorhandles,armrestsetc.
1 Turnoffthecarignitionkey.
If the power is on, the click noise generated by the connection•
may damage the speakers.
2Cut out the mounting template from the packing box.
3Paste the template on the location selected for mounting the
speaker.
4Mark the cut-off hole and the 4 bolt holes. b
5Cut out the marked area and drill the bolt holes. c
6Remove the grille net. d
7 Stripthespeakerwiresandconnectthemtotheamplier. e
Black wire: connect to “-“ (negative) terminal•
Black (white lined): connect to “+“ (positive) terminal•
Note
Match the “left”, “right”, “+” and “-” terminals correctly. Revised polarity may
•
degrade sound quality.
Two4-ohmspeakers,wiredinstereo,presenta8ohmloadtoeachchannel
•
oftheamplier.Mosttwochannelampliersworkwellinthisconguration.
However, if two 4-ohm speakers, wired in parallel to a bridged two -channel
amplier,presenta2-ohmmonoloadtotheamplier.Most2-channelampliers
donotsupport2-ohmmonooperation!Amplierdamagemayresult!
8Mount on the speaker as shown below. f
9Press and insert the edges of the grille net. g
