Philco PWD 12SN User manual

PWD 12SN

Introduction

Please read these instructions for use carefully and all other information enclosed with the

washing machine.

Keep all documentation in a safe place for future reference or for any future owners.

Note: this machine is solely for domestic use.

Notes on disposal

All packaging material used is environmentally-friendly and recyclable. Please help dispose of

the packaging via environmentally-friendly means.

Your supplier or local council will be able to give you

details of current means of disposal.

Valuable materials can be salvaged from an old appliance via scrap reprocessing.

Note: pull out the mains plug from any old appliance.

Cut the power cable and dispose of it, together with the

plug.

When disposing of an old washing machine, please ensure that the door lock is rendered

inoperable to prevent children shutting themselves in the appliance.

Contents Page

Introduction 2

General delivery notes 4

Safety notes 4

Quick start 5

Description of controls 6

Programme Table 13

Programme selector 15

Detergent drawer 18

Useful advice for the user 19

The main wash 20

Drying 22

Automatic washing/drying cycle 23

Drying cycle 24

Cleaning and routine maintenance 25

Investigating malfunctions 27

Technical data 29

Setting up + installation 30

BEFORE SWITCHING ON THE APPLIANCE MAKE SURE

IT IS CORRECTLY INSTALLED AND THAT THE TRANSIT

BRACKETS ARE REMOVED AS SHOWN IN PAGE 30.

General delivery notes

Please check that the following items are delivered with the appliance:

- Instruction manual

- Certificate of guarantee

- Inlet hose

Check that no damage has occurred during transit, and if so, call your nearest Authorised

Technical Support Service agent.

Safety notes

Note:

for cleaning or maintenance of the washing machine.

A) Pull out the plug

B) Turn off the tap

C) Philco equips all its appliances with earthing. Ensure that the mains supply is earthed,

and if it is not, seek assistance from a qualified person.

D) Do not touch the appliance when hands or feet are wet or damp. Do not use the appliance

with bare feet.

E) The use of adapters, multiple connectors and/or extensions is not recommended.

Note:

water temperature can reach 90°C during the wash cycle.

F) Check there is no water left in the drum before opening the door.

G) This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning use of the appliance by a

person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

H) Do not pull the power cable or the appliance itself to remove the plug from the socket.

I) The appliance must not be exposed to weather conditions (rain, direct sun, etc...)

L) When moving the appliance never lift it by the controls or by the detergent drawer.

When in transit never rest the door against the trolley or transport the appliance without

the polystyrene base.

M) N.B!

If the appliance is installed on a carpeted floor ensure that the ventilation holes on the

base of the appliance are not obstructed.

N) If the appliance is not running properly or breaks down, switch it off, turn off the tap and do

not tamper with the appliance.

Consult only the Authorised Technical Support Service for possible repair and ask them to

use original spare parts.

Failure to comply with the above can compromise the safety of the appliance.

O) If the appliance’s power cable should ever need replacing, consult the Authorised

Technical Support Service

Quick start

Washing

- Open the door by using the button “A” (Fig. 1, page 6)

- Select laundry and put it in the machine

- Close the door

- Put detergent in the compartments as indicated in the programme guide in this instruction

manual

- Select programme

- Wait for the “STOP” indicator light to flash

Press additional function buttons (if required)

- Press the “Start/Pause” button

- After few seconds the appliance starts working.

After washing

- The indicator light “STOP” will go on.

- Wait for the door lock to be released

(about 2 minutes after the programme has finished).

The “Door Security” indicator light will go out.

- Switch off the washing machine by turning the selector

to “OFF” position.

- Open the door and remove the laundry.

Ensure that the machine is correctly installed in line with the instructions found on page 30.

DRYING

If you would like the drying cycle to begin automatically after

washing, select the programme required using the Drying

Programme Selector knob.

Otherwise it is possible to finish the wash and then decide on the

drying programme and load.

Description of controls

Door handle A

Door locked indicator light B

Start button C

Start Delay button D

Prewash button E

Extra Rinse button F

1200/600 button G

Wash Temperature Control Knob H

Timer knob for drying programmes I

Buttons indicator light L

“Processing” indicator light M

Timer knob for wash programmes with OFF position N

Dry indicator light O

Detergent drawer P

Fig. 1

C D E F G

B O

H I N

DOOR SECURITY indicator light

The “Door Security” indicator light is illuminated when the door is fully closed and the machine is ON.

When "Start/Pause" is pressed on the machine with the door closed the indicator will flash

momentarily and then illuminate.

If the door is not closed the indicator will continue to flash.

A special safety device prevents the door from being opened immediately after the end of the cycle.

Wait for 2 minutes after the wash cycle has finished and the “Door Security” light has gone out

before opening the door. At the end of the cycle turn the programme selector to "OFF" .

NOTE: When the "Start/Pause" button has been pressed,

the appliance can take few seconds before it starts

working.

START/PAUSE button

When a programme is selecting, wait for the “STOP” indicator

light to flash before pressing the "Start/Pause" button.

Press to start the selected cycle (according to the selected cycle one indicator lights will go on) .

Changing the settings after the programmes has started (PAUSE)

The programme may be paused at any time during the wash cycle by holding down the

"Start/Pause" button for about two seconds. When the machine is in the paused mode, the

indicator light "processing" and option buttons will flash.

To restart the programme, press the "Start/Pause" button once again.

If you wish to add or remove items during washing, wait 2 minutes until the safety device

unlocks the door.

When you have carried out the manoeuvre, close the door, press "Start/Pause" button and

the appliance will continue working where it left off.

CANCELLING THE PROGRAMME

To cancel the programme the programme selector should be rotated to the "OFF" position.

Door handle

Press the finger-bar inside the door handle to open the door.

IMPORTANT:

A SPECIAL SAFETY DEVICE PREVENTS THE DOOR FROM OPENING AT THE END

OF THE WASH/SPIN CYCLE. AT THE END OF THE SPIN PHASE WAIT UP TO 2

MINUTES BEFORE OPENING THE DOOR.

PRE-WASH BUTTON

This option is particularly useful for heavily soiled loads and can be used only on some

programmes as shown in the programmes table.

Detergent for this programme should be added to the compartment of the soap drawer

labelled “I” (Please refer to Detergent Drawer Section of manual). We recommend you use

only 20% of the recommended quantities shown on the detergent pack and fabric conditioner

should not be used for this programme.

START DELAY BUTTON

Appliance start time can be set with this button, delaying the star by 3, 6 or 9 hours.

Proceed as follow to set a delayed start:

Select a programme (“STOP” indicator light blinks)

Press Start Delay button (each time the button is pressed the start will be delayed by 3, 6 or

9 hours respectively and the corresponding light will blink).

Press START to commence the Start Delay operation (the indicator light associated with the

selected Start Delay time stops blinking and remains ON).

At the end of the required time delay the programme will start.

To cancel the Start Delay function :

press the Start Delay button until the indicator lights will be off (The STOP light blinks) and

the programme can be started manually using the START button or switch off the appliance

by turning the programme selector to off position.

EXTRA RINSE BUTTON

Thanks to the new electronic system, acting on the button is possible to effect a new special

rinse cycle. The addition of a lot of more water and the new action combined of cycles of

rotation of the drum with load and unloading of water, allow to get laundry perfectly rinsed.

This function has been studied for the people with delicate and sensitive skin, for which also a

least residue of detergent can cause irritations or allergies.

It advises to also use this function for the children items and in case of washings of very dirty

items, for which it is due to use a lot of detergent, or in the washing of towelling items whose

fibers mostly have the tendency to hold the detergent.

This button is not available on specials programmes excluding the SPORTS programme.

The option buttons should be selected before pressing

the "Start/Pause" button.

WASH TEMPERATURE CONTROL KNOB

ROTATES IN BOTH DIRECTIONS

With this device it is possible to reduce, but no increase

washing cycle temperature.

The table of programmes indicate the maximum temperature

advised for each type of wash.

WARNING: THIS TEMPERATURE MUST NEVER BE

EXCEEDED

1200/600 button

The machine gradually increases the final spin speed to the maximum possible speed.

The button reduces spin speed to 600 r.p.m.

Note:

This function is not available when the automatic washing/drying cycle is selected.

Note: this model is fitted with an electronic device that

checks the load is balanced correctly. If the load is

slightly unbalanced the machine will re-balance it

automatically to carry out the normal spin.

If, after several attempts, balance is not restored, a

reduced spin speed will be used.

If loads are seriously unbalanced the spin stage will be

cancelled.

This helps limit vibration, reduce noise output and

improve the washing machine’s lifespan.

Table of contents

Other Philco Washer manuals

Philco

Philco PLD 127 D QTL User manual

Philco

Philco PLDI 147 B King User manual

Philco

Philco PLD 1272 User manual

Philco

Philco PLDA 1273 Chiva User manual

Philco

Philco PLD 1261-5TL User manual

Philco

Philco AB600TX User manual

Philco

Philco PLD 1061M User manual

Philco

Philco PWM 15 PL User manual

Philco

Philco PSW 71400 User manual

Philco

Philco PTL6105 Manual

Philco

Philco PSW81400V User manual

Philco

Philco PW3708N User manual

Philco

Philco PLD 106 E User manual

Philco

Philco GJW60P User manual

Philco

Philco PLDS 106 DG User manual

Philco

Philco PLD 14840 User manual

Philco

Philco PTL7120PEX User manual

Philco

Philco PL 1062 CHIVA User manual

Philco

Philco PLD 106 ECZ User manual

Philco

Philco PLDSA 1241 CHIVA User manual

Philco

Philco PLD 1261-5TL User manual

Philco

Philco PLCE06GGPWT User manual

Philco

Philco PLDSI 148 A KING User manual

Philco

Philco PW709L User manual

Popular Washer manuals by other brands

Tricity Bendix

Tricity Bendix AW 1000 W Operating & installation instructions

Panasonic

Panasonic NA-F60L5WRB operating instructions

GE WSLP1500 Dimensions and installation information

Electrolux

Electrolux EWF1284EDW Service manual

Bosch

Bosch WAN2829BSN User manual and installation instructions

LG TV2516DV3B owner's manual

LG TH2517DSAV owner's manual

VESTEL

VESTEL CMH-XL 7510 TE user manual

AEG

AEG 74335 User information

Johnson

Johnson JWF721A user manual

Beko

Beko WTE7604XLW0 owner's manual

Danby

Danby DTT100A1WDB Owner's use and care guide

Amica

Amica WA 14 Ex operating instructions

Daewoo

Daewoo DWD-F1222 instruction manual

Bosch

Bosch WAS28461AU instruction manual

Miele

Miele PW 6080 Vario manual

Finlux

Finlux FLX108CF220 user manual

Whirlpool

Whirlpool 3LBR5132AN0 Use and care guide