Philco PTL7145D Manual

ࠌشᎅࣔ஼

ীᇆ ˍ

請仔細閱讀並妥善保存此說明書

Instruction and installation manual

Please read and save these instruction

P T L 7 1 4 5 D

Introduction

Read this manual carefully as it offers practical

advice to help you get the most from your washing

machine.

This «Instruction and Installation Manual» contains

everything you need to know about the everyday

running of your machine.

Please refer to this manual for installation and

maintenance instructions. The manual also contains

information about possible working problems,

advice about sorting clothes for washing, an

explanation of label symbols and hints about how to

remove stubborn stains.

1.- CONTROL PANEL 2.- LID 3.- DRUM

4.- DETERGENT DISPENSER 5.- PLINTH PANEL

6.- FILTER

Table of contents

page

Safety measures 3

Setting up - Installation 5

Preparing the wash. Opening/ closing the drum 7

Detergent load 8

Electronically-controlled variable load- Fuzzy Logic 8

Description of controls 9

Programmes selection 17

General recommendations 18

Troubleshooting 20

Washing hints 21

Safety measures

This appliance meets the European Directives

2004/108/EC, 2006/95/EC which have been substituted

respectively by 89/336/EEC, 73/23/EEC and subsequent

modifications thereof.

This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capabilities,

or lack of experience and knowledge, unless they have been

given supervision or instruction concerning use of the appliance

by a person responsible for their safety.

Children should be supervised to ensure that they do not play

with the appliance.

ATTENTION: FOR ALL CLEANING AND MAINTENANCE

WORK

• Remove the plug.

• Turn off the water inlet tap after each wash.

• The manufacturer fits all the machines with an earth

connection.

Ensure that the electrical installation has an earth connection

and that it is connected; if not, call a qualified Service Center.

The earth connection is essential for user safety as it elimi-

nates the risk of electrical discharge.

• Power sockets should be in easily accessible places so that

the washing machine can be unplugged in case of any

problems.

• If the electric cable is damaged replace with an original set

(cable and plug) supplied by the manufacturer or official after-

sales service.

note:

In the event that it is necessary to replace the power cable,

make sure that you comply with the following colour-code chart

during the wiring:

blue neutral

brown phase

Yellow-green earth

The manufacturer accepts no responsibility for any

damage to people or things resulting from the failure to

comply with the appliance’s installation and safety

regulations.

• Do not touch the appliance with wet hands or feet.

• Do not use the appliance when bare-footed.

• Use extension cords only with extreme care.

• Do not use adapters or multiple plugs.

• Do not allow the appliance to be used by children or the infirm

without due supervision.

• Do not pull on the power cord or the appliance itself to remove

the plug from the socket.

• Do not leave the appliance outdoors or exposed to the

atmospheric elements (rain, sun, etc.).

• Do not cover the appliance with cloth or plastic while it is

working.

• Do not install the appliance in damp places or anywhere

where it could be sprayed by the shower.

• Do not install the appliance on a surface which obstructs the

space between the floor and the base of the machine.

• Keep all packaging out of the reach of children as it could

constitute a health hazard.

ATTENTION:

DURING A WASH CYCLE THE WATER

CAN REACH TEMPERATURES OF 90ºC.

Setting up - Installation

• Unpack the appliance.

• Remove the 4 screws (A) from

both clamps and the 4

screws (B).

• Replace the 4 screws (A) and

fit the trims provided (D).

If your model offers this function:

Position the protection sheet as shown in the

diagram.

1.- Washing machine with wheel trolley.

2.- Washing machine without wheel trolley.

ATTENTION: DO NOT TURN THE TAP ON

• The washing machine should be connected to the

water mains via the new tube supplied with the

appliance (inside the drum). Do not use the old tube for

this purpose.

• Connect one end of the water inlet pipe with the elbow

bend to the electrovalve (top rear part of the machine)

and the other end to a tap or a plumbed-in 3/4" gas

threaded connection.

• Place the washing machine close to the wall, ensuring

that there are no bends or kinks anywhere in the tube.

Hook the outlet pipe to the edge of the sink or preferably

to a fixed drainage outlet of a diameter greater than that

of the outlet pipe and at a height of min. 50 cm. and a

maximum of 75 cm. from the floor.

If necessary, use the curved accessory to attach and

support the outlet pipe more securely.

If your model offers this function:

• To move the washing machine easily, turn the trolley

lever to the right. Once you have finished moving the

machine, return the lever to its original position.

• Level the machine by adjusting the front feet.

a) Turn the nut clockwise to release the screw on the

foot.

b) Raise or lower the foot by rotating it until it stands

firmly on the floor.

c) Lock the foot in position by turning the nut

anticlockwise until it comes up against the bottom of the

washing machine.

Check that the appliance is properly levelled.

Check that the washing machine does not rock by trying

to move two diagonally opposite top corners at the

same time.

• If you move the washing machine from one place to

another, you must level the feet again afterwards.

• Connect the machine.

Preparing the wash. Opening/ closing the drum

ATTENTION:

IT IS IMPORTANT TO MAKE SURE THAT THE

DRUM IS CAREFULLY OPENED AND CLOSED,

OTHERWISE THE MACHINE OR LAUNDRY

COULD GET DAMAGED.

ENSURE THAT THE DOORS FIT TOGETHER

PERFECTLY AND ARE PROPERLY CLOSED.

Open the washing machine lid.

Open the drum by pressing the (A) button with one

hand while pressing down on the opposite door

with the other.

Place clothes in the drum one item at a time, and

without squashing. Do not exceed the load limits

recommended in the “programme table”. An

overloaded washing machine will not wash

properly, and will leave clothing wrinkled.

To close the drum, place the doors so that the one

with the (A) button is below the other and they fit

together perfectly.

Detergent load

II I

Maximum Main wash

washing powder

Maximum Main wash

washing liquid

Maximum pre-wash

washing powder

recommended

Maximum scenting agent

The detergent dispenser is divided into 3 compartments:

.- Compartment I is for the pre-wash detergent.

.- Compartment II is for the main wash detergent.

.- The compartment is for fabric conditioners, scenting agents and special additives such as starch,

blueing, etc.

The detergent dispenser has two reference marks:

.- Recommended (lower reference mark). This indicates the recommended level for the pre-wash and

main wash compartments.

.- Max. This indicates the maximum level, which should never be exceeded.

Important:

- Do not use liquid detergent for programs with a prewash cycle and/or timed start.

- When the clothes present stains that need treatment with bleaches liquids products, you can proceed

to their preliminary cleaning in the washing machine. For that: Introduce the bleach product in the

"compartment II", and set the rinse program . Once finished set the programmer to the OFF position,

add the rest of the laundry, and proceed with a normal was program.

Electronically- controlled Variable Load – Fuzzy Logic

This machine has electronics that automatically process all stages of the wash to ensure exceptional

results and at the same time save you time and money.

Once a programme has been selected, the machine optimises the following elements depending on

the wash load and type of fabric:

- quantity of water and power consumption

- wash time

- rinse efficiency

The washing machine also:

- detects suds and increases the amount of rinse water if necessary

- adjusts spin speed according to load distribution, thus forestalling any imbalance in the mechanism.

Description of controls

A Programme selector with OFF

position

B START/PAUSE button

C SPIN SPEED button

D TEMPERATURE SELECTION

button

E DELAY START button

F WASH TIME button

G EXTRA RINSE button

H OPTIONS button

I EASY IRON button

L Digital display

M DOOR LOCKED indicator light









Press the START/PAUSE button to start

the selected cycle.

Once a programme is selected the

programme selector remains stationary on

the selected programme till cycle ends.

Switch off the washing machine by

turning the selector to OFF.



Press to start the selected cycle.

ADD OR REMOVE ITEMS AFTER THE

PROGRAMMES HAS STARTED (PAUSE)



Press and hold the START/PAUSE

button for about 2 seconds (some

indicator light and the time remaining

indicator will flash, showing that the

machine has been paused).



Wait 2 minutes until the safety device

unlocks the door.



After you have added or removed items,

close the door and press the

START/PAUSE button (the programme

will start from where it left off).

CANCELLING THE PROGRAMME

To cancel the programme, set the

selector to the OFF position.

WARNING:

Don’t touch the display while inserting

the plug because the machines

calibrates the systems during the first

seconds: touching the display, the

machine couldn’t work property. In

this case, remove the plug and repeat

the operation.

Opening the door

A special safety device prevents the

door from being opened immediately

after the end of the cycle.

Wait for 2 minutes after the wash

cycle has finished and the "Door

Security" light has gone out before

opening the door.

PROGRAMME selector with OFF

position

When the programme selector is turned

the display lights up to show the settings

for the programme selected.

For energy saving, at the end of the

cycle or with an inactivity period, the

display level contrast will decrease.

N.B.: To switch the machine off, turn the

programme selector to the OFF

position.

The programme selector must be

returned to the OFF position at the end

of each cycle or when starting a

subsequent wash cycle prior to the next

programme being selected and started.

START/PAUSE button

Close the door BEFORE selecting the

button START/PAUSE.

When the START/PAUSE button has

been pressed, the appliance can take

few seconds before it starts working.

Table of contents

Other Philco Washer manuals

Popular Washer manuals by other brands

Tricity Bendix

Tricity Bendix AW 1000 W Operating & installation instructions

Panasonic

Panasonic NA-F60L5WRB operating instructions

GE WSLP1500 Dimensions and installation information

Electrolux

Electrolux EWF1284EDW Service manual

Bosch

Bosch WAN2829BSN User manual and installation instructions

LG TV2516DV3B owner's manual

LG TH2517DSAV owner's manual

VESTEL

VESTEL CMH-XL 7510 TE user manual

AEG

AEG 74335 User information

Johnson

Johnson JWF721A user manual

Beko

Beko WTE7604XLW0 owner's manual

Danby

Danby DTT100A1WDB Owner's use and care guide

Amica

Amica WA 14 Ex operating instructions

Daewoo

Daewoo DWD-F1222 instruction manual

Bosch

Bosch WAS28461AU instruction manual

Miele

Miele PW 6080 Vario manual

Finlux

Finlux FLX108CF220 user manual

Whirlpool

Whirlpool 3LBR5132AN0 Use and care guide