Phase CI-MM3-II Configuration guide
Grille
Grillesafetyclip
Screws
Speaker
Two-gangjunctionbox(installersupplied)
NOTE: the CI-MM3-II is designed to install
into a standard 2-gang junction box. Phase
Technology recommends you test the t
before installing the junction box.
Box contents
1 Speaker
2 Grilles
4 Mounting screws
2 Wire nuts
©2010PhaseTechnology. Allrights reserved. Rev08.30.10
T E C H N O L O G Y
CI-MM3-II
Install instructions for Spacia models:
8005 W. 110th St. | Suite 208 | Overland Park, KS 66210 | 855.663.5600 | www.phasetech.com | www.mseaudio.com
1. Unpack speaker.
6. Done!
1.
2.
4. Attach grille safety clip by
placing the large end of the
clip over snap-t post (1),
then sliding clip until small
end snaps into place around
post (2).
5. Align tabs on snap-t grille
with slots in bae, gently
press grille into place.
Install instructions for Spacia models, Page 2
2. Connect speaker wires to
signal wires using included
wire nuts.
3. Install the CI-MM3-II into
the installer supplied
junction box using included
fasteners.
8005 W. 110th St. | Suite 208 | Overland Park, KS 66210 | 855.663.5600 | www.phasetech.com | www.mseaudio.com
Other Phase Speakers manuals
Phase
Phase CI120 Original instructions
Phase
Phase PC0.5 User manual
Phase
Phase CI X Series User manual
Phase
Phase CI110 II User manual
Phase
Phase POWER FL-8 User manual
Phase
Phase CS-6R/Micro User manual
Phase
Phase Teatro Soundbar User manual
Phase
Phase Velocity V52 User manual
Phase
Phase CI-10 VIII User manual
Phase
Phase CI140 User manual
