Peerless-AV KLR62232 User manual

12019-06-14 #:150-9227-1

ENG

KLR62232, KLR64255

22019-06-14 #:150-9227-1

Symbols

ENG

WARNING

ENG

Skip to step.

ENG

Do not overtighten screws.

ENG

ENG - This product is designed to be installed on wood stud, solid concrete or cinder block walls. Hardware is

included for wood stud, solid concrete and cinder block installation. Do not begin to install product until you have

read and understood the instructions and warnings contained in this user guide. Before installing make sure

the supporting surface will support the combined load of the equipment and hardware. Screws must be tightly

secured. Do not overtighten screws or damage can occur and product may fail. Never exceed the Maximum

Load Capacity. Always use an assistant or mechanical lifting equipment to safely lift and position equipment. This

product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal

injury. Be careful not to pinch ngers when operating the mount. To reduce the risk of electric shock or re, do not

expose product to water or moisture. Be sure power cord is routed so that it will not be tripped on, stepped on,

or pinched by heavy items. Avoid overloading electrical outlets or extension cords. Always disconnect the power

cord from the power outlet when installing, servicing, or not using the product for an extended period of time. Do

not block ventilation slots or fan exhaust on product. Blocking airow could damage product. Arrange product to

allow air to ow freely around product. Keep product away from direct sunlight or any source of heat. For support

please call 800-4-SIGNAGE.

WARNING

32019-06-14 #:150-9227-1

Tools Needed for Assembly.

ENG

ENG To properly tighten screws: Tighten until screw

head makes contact, then tighten another 1/2

turn. Do not overtighten screws.

+1/2

5/32"

(4mm)

5/16"

(8mm)

3/8"

(10mm)

42019-06-14 #:150-9227-1

A (1)

enclosure B (1)

wall mount

G (1)

hook-on

bracket

F (1)

locking bracket

Parts List KLR62232

Part #

KLR64255

Part #Description Qty

Aenclosure 1 152-1544 152-1545

Bwall mount 1 ST635 ST640

C#14 x 2-1/2" wood screw 4 5S1-015-C03 5S1-015-C03

D8mm concete anchor 4 590-0320 590-0320

Epower strip 1 600-0370 600-0370

Flocking bracket 1 152-T1502 152-T1511

Ghook on bracket 1 152-T1508 152-T1520

HM5 x 20mm 3 510-1065 510-1065

Parts (Before beginning, make sure you have all parts shown below).

ENG

E (1)

power strip

52019-06-14 #:150-9227-1

D (4)

8mm concrete anchor

C (4)

#14 x 2-1/2" wood screw

H (3)

M5 x 20mm

Follow and complete instructions for included wall

mount.

ENG

62019-06-14 #:150-9227-1

Hold enclosure over display in desired location,

and make sure that it is level. Mark the top

location of the enclosure.

ENG

Remove display.

ENG

Loosen.

ENG

4mm

72019-06-14 #:150-9227-1

ENG - When installing Peerless wall mounts on a wood stud wall covered with gypsum board (drywall), verify that

the wood studs are a minimum of 2" x 4" nominal size. Do not install over gypsum board thicker than 5/8".

WARNING

Wood stud wall.

ENG Concrete/Cinder block.

ENG

4a-1 Use stud nder to locate and

mark stud center lines.

ENG

82019-06-14 #:150-9227-1

4a-2

⅛"

Mark mounting holes on stud center lines.

Mounting holes should be positioned 1/8" under

the horizontal cover line.

ENG

cover line

ENG

cover line

ENG

92019-06-14 #:150-9227-1

4a-4

3/8"

(10mm)

4a-3

5/32"

(4mm)

C (2)

Mounting hole must center on stud.

ENG

2.5"

(64mm)

5/32"

(4mm)

Drill mounting holes into supporting surface

(2.5" (64mm) minimum depth required).

ENG

Level wallplate. Install using wood screws provided.ENG

Maximum 80 in. • lb (9 N.M.).

ENG

10 2019-06-14 #:150-9227-1

4b-1

4b-2

5/16"

(8mm)

ENG - When installing Peerless wall mounts on a concrete wall, the wall must be at least 8" thick with a minimum

compressive strength of 2000 psi. When installing Peerless wall mounts on a cinder block wall, the cinder blocks

must meet ASTM C-90 specications and have a minimum nominal width of 8". Do not drill into mortar joints!

Be sure to mount in a solid part of the block, generally 1" (25 mm) minimum from the side of the block. It is

suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid

breaking out the back of the hole when entering a void or cavity. Never attach concrete expansion anchors to

concrete or cinder block covered with plaster, drywall or other nishing material.

WARNING

Mark mounting holes on stud center lines.

Mounting holes should be positioned 1/8" under

the horizontal cover line.

ENG

cover line

ENG

2.5"

(64mm)

5/16"

(8mm)

Do not drill into mortar joints.

ENG

Drill mounting holes into supporting surface

(2.5" (64mm) minimum depth required).

ENG

cover line

ENG

⅛"

cover line

ENG

This manual suits for next models

Table of contents

Other peerless-AV Rack & Stand manuals

peerless-AV

peerless-AV DS-S555-4X2 User manual

peerless-AV

peerless-AV SA740P User manual

peerless-AV

peerless-AV SmartMount SA761PU User manual

peerless-AV

peerless-AV MOD-P100-B User manual

peerless-AV

peerless-AV RMI2W User manual

peerless-AV

peerless-AV ACC918 User manual

peerless-AV

peerless-AV SEAMLESS Kitted 27BDL6119L/00 User manual

peerless-AV

peerless-AV SMARTMOUNT ST635 User manual

peerless-AV

peerless-AV HLG440-LG(-Q10) User manual

peerless-AV

peerless-AV PPA User manual

peerless-AV

peerless-AV SF670 User manual

peerless-AV

peerless-AV SMARTMOUNT SP850 User manual

peerless-AV

peerless-AV SA730P User manual

peerless-AV

peerless-AV DSF265L User manual

peerless-AV

peerless-AV MSA-301 Guide

peerless-AV

peerless-AV MOD-CPF2 User manual

peerless-AV

peerless-AV DS-LEDUPS Series User manual

peerless-AV

peerless-AV RMI3-FLIP2 User manual

peerless-AV

peerless-AV B-MIS38426 User manual

peerless-AV

peerless-AV IM760P Guide

peerless-AV

peerless-AV PRG-UNV User manual

peerless-AV

peerless-AV DS-VWS546-2X2 Guide

peerless-AV

peerless-AV KIP542B User manual

peerless-AV

peerless-AV SF660 User manual

Popular Rack & Stand manuals by other brands

Salamander

Salamander Acadia AC/W/L400/WH Assembly instructions

Fohhn

Fohhn VAT-09 Mounting instruction

ricoo

ricoo FS0522 quick start guide

AMSOIL

AMSOIL BMK-22 Installation and service instructions

Kargo Master

Kargo Master 48220 installation guide

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 installation instructions

ricoo

ricoo S1222 installation instructions

Ready-Set-Mount

Ready-Set-Mount RSMCM602 instruction manual

VidaBox

VidaBox VB MNT FFS2 installation guide

Welch Allyn

Welch Allyn 48960 Assembly instructions

Arkon

Arkon CM035-ST-2 installation instructions

PROEL

PROEL PLWIN60C user manual

Agilent Technologies

Agilent Technologies E2609B installation guide

Mustang

Mustang MV-ARM4 installation guide

Mounting Solutions

Mounting Solutions WRM-320 manual

Pyle

Pyle PMKSPAD1 manual

ShelterIt

ShelterIt 21208 installation instructions

SPL

SPL RackPack?4 1040 manual 

peerless-AV KLR62232 User manual

Popular Rack & Stand manuals by other brands