oticon miniRITE Alta2 User manual
RITE
Alta2
Nera2
Ria2
Alta
Nera
Ria
Instructions for use
Model overview
This booklet is valid for Oticon RITE in the following hearing aid
families and models:
Inium Sense
Alta2 Pro Nera2 Pro Ria2 Pro
Alta2 Nera2 Ria2
Inium
Alta Pro Nera Pro Ria Pro
Alta Nera Ria
The following speakers are available for the above models:
Speaker 60
Speaker 85
Speaker 100
Power ex mould speaker 100
Power ex mould speaker 105 (only Inium Sense models)
Introduction to this booklet
This booklet guides you in how to use and maintain your new
hearing aid. Please read the booklet carefully including
the Warning section. This will help you to achieve the full benet
of your new hearing aid.
Your hearing care professional has adjusted the hearing
aid to meet your needs. If you have additional questions,
please contact your hearing care professional.
About Start up Handling Options Warnings More Info
For your convenience this booklet contains a navigation bar to help
you navigate easily through the dierent sections.
Intended use
The hearing aid is intended to amplify and transmit sound to the ear
and thereby compensate for impaired hearing within mild to severe-
to-profound hearing loss. The hearing aid is not intended to be used
by infants and children older than 36 months.
IMPORTANT NOTICE
The hearing aid amplication is uniquely adjusted and optimised to your
personal hearing capabilities during the hearing aid tting performed by
your hearing care professional.
Table of content
About
Identify your hearing aid speaker and earpiece 8
Your hearing aid 10
Identify left and right hearing aid 12
Battery 13
Start up
Turn the hearing aid ON and OFF 14
When to replace a battery 15
Replace the battery 16
Handling
Caring for your hearing aid 18
MultiTool for handling batteries and cleaning 19
Put on the hearing aid 20
Standard earpieces: dome or Grip Tip 22
Replace dome or Grip Tip 23
ProWax miniFit filter 24
Replace ProWax miniFit filter 25
Customised earpieces: Micro mould, LiteTip or Power mould 26
Clean Micro mould, LiteTip or Power mould 27
Replace ProWax filter in customised earpieces 28
Options
Optional features and accessories 30
Mute the hearing aid 31
Change programs 32
Change volume 34
Tamper-resistant battery drawer 36
Wireless accessories 38
Other options 40
Warnings
Warnings 42
More info
Troubleshooting guide 48
Water resistant 50
Conditions of use 51
Warranty certificate 52
International warranty 53
Technical information 54
8 9
About Start up Handling Options Warnings More Info
Identify your hearing aid speaker and earpiece
This will make it easier for you to
navigate through this booklet.
Speakers
RITE hearing aids come with
three dierent speakers:.
Earpieces
The speaker uses one of the
following earpieces:
Power ex mould speakers
Speaker
(60 shown)
Ear grip
(optional)
60 85
* Please see details for replacing the dome or Grip Tip in section: Replace dome or GripTip
100
Micro mould or LiteTip
Grip Tip*
Dome (open dome shown)* 100
105
About
10 11
About Start up Handling Options Warnings More Info
Your hearing aid
What it is
Push button Mute, change
volume, and
program
Microphone
openings
Sound in
What it does
Battery drawer Contains the battery.
Battery drawer is also
the on/o switch
Speaker
(60 shown) Sound out
12 13
About Start up Handling Options Warnings More Info
Identify left and right hearing aid
It is important to distinguish between the left and the right hearing
aid, as they might be programmed dierently.
You can nd left/right colour indicators in the battery drawer and on
60 and 85 speakers as shown. Indicators can also be found on 100
speakers and some earpieces.
Battery
Your hearing aid is a miniature electronic device that runs on special
batteries. To activate the hearing aid, you must insert a new battery in
the battery drawer. See how in chapter “Replace the battery”.
A RED indicator marks the
RIGHT hearing aid.
A BLUE indicator marks the
LEFT hearing aid.
Pull out to open
Battery drawer
Your hearing aid
battery size is 312
14 15
About Start up Handling Options Warnings More Info
Turn the hearing aid ON and OFF
The battery drawer is also used to switch the hearing aid on and o. To
preserve the battery, make sure your hearing aid is switched o when
you are not wearing it.
When to replace a battery
When it is time to replace the battery you will hear two beeps
repeated in moderate intervals until the battery runs out.
Two beeps
= The battery is running low
Four beeps
= The battery has run out
Battery maintenance tip
To make sure the hearing aid is always working, bring spare batteries
with you, or replace the battery before you leave home.
Turn ON
Close the
battery
drawer with
the battery
in place.
Turn OFF
Open the
battery drawer.
Start up
16 17
About Start up Handling Options Warnings More Info
Replace the battery
2. Uncover 3. Insert
Fully open the
battery drawer.
Remove the battery.
Remove the sticky
label from the +side
of the new battery.
Tip:
Wait 2 minutes so that the
battery can draw air, to make
sure to function optimally.
Insert the new battery
into the battery
drawer. Make sure the
+side faces up.
1. Remove
Close the battery drawer. The
hearing aid will play a jingle
through the earpiece.
Hold the earpiece close to your
ear to hear the jingle.
The MultiTool can be used for
battery change. Use the magnetic
end to remove and insert batteries.
The MultiTool is provided by
your hearing care professional.
4. Close Tip
MultiTool
18 19
Caring for your hearing aid
When handling your hearing aid, hold it over a soft surface
to avoid damage if you drop it.
Clean the microphone openings
Carefully brush away debris from
the openings. Gently brush the
surface. Make sure the brush is clean
and that it is not pressed into
the openings.
About Start up Handling Options Warnings More Info
IMPORTANT NOTICE
Use a soft, dry cloth to clean the hearing aid. It must never be washed or
immersed in water or other liquids.
Microphone
openings
MultiTool for handling batteries and cleaning
The MultiTool contains a magnet which makes it easier to replace the
battery in the hearing aid. It also contains a brush and a wire loop for
cleaning and removing ear wax. If you need a new MultiTool please
contact your hearing care professional.
Brush
Wire loopMagnet
IMPORTANT NOTICE
The MultiTool has a built-in magnet. Keep the MultiTool 30 cm away from
credit cards and other magnetically sensitive devices.
Handling
Other manuals for miniRITE Alta2
12
This manual suits for next models
5
Table of contents
Other oticon Hearing Aid manuals
oticon
oticon ConnectLine Streamer Pro 1.3A User manual
oticon
oticon miniRITE Alta2 User manual
oticon
oticon Opn S Series User manual
oticon
oticon connectline microphone User manual
oticon
oticon CIC P User manual
oticon
oticon Own 1 User manual
oticon
oticon Intiga Rite User manual
oticon
oticon Aurora miniRITE 312 T Rc User manual
oticon
oticon HIT PRO User manual
oticon
oticon Intent 1 miniRITE User manual
oticon
oticon BTE Alta2 Pro User manual
oticon
oticon STREAMER PRO User manual
oticon
oticon BTE 312 User manual
oticon
oticon Amigo FM/MED-EL User manual
oticon
oticon Alta IIC User manual
oticon
oticon miniRITE R User manual
oticon
oticon CIC P User manual
oticon
oticon Alta2 Pro Ti User manual
oticon
oticon OPN MINIRITE User manual
oticon
oticon Alta2 Pro Ti User manual
