32 Technical Service 1-800-556-3926
Set the reservoir detection
switch fully to the right to set
it into the left side panel
opening. Then tighten the 2
screws on its bracket.
Insert and tighten one screw
on the left side panel near
the front of the machine,
gently pressing down on the
top cover to ensure correct
alignment.
Place keyhole over screw
then slide L bracket to the
left. Do not tighten screw
yet. Hold the L bracket in
place to align with the
screw hole in the next step.
Insert and tighten one screw
on the left side panel near
the back of the machine,
gently pressing down on the
top cover to ensure correct
alignment. Tighten the
screw on the L bracket from
the previous step.
LITTLE JOE ACCESS INSTRUCTIONS PN 153264 20230519
9
Place front panel flush
against the machine, with
the top of the front panel
about 1/4” above the top
of the machine cover.
Slide front panel down into
place, engaging panel
hooks with slots on the
machine and on the side
panel. Tighten screw.
If power cord was
removed from back panel,
thread it back through the
opening shown above.
Align hooks on the sides
and bottom of the back
panel to slots on the sides
and bottom of the back of
the machine. Slide back
panel up about 1/4” to
engage the hooks into the
slots.
