I Features.
II. Function
Main Board Connection
32
1. Cover
2. Screw cover
3. External Screw
(Security for Tamper Switch)
4. PCB Protection Cover
5. Red LED Indicator
6. Backup Battery
(Host line destroyed or cut,Sound an
alarm by the backup battery.)
7.SAB / SCB selector switch
Adjustable S1 encoder (Article 123) to set the alarm output
time.
Alarm output time setting (Table 1)
Delay settings (Table 2)
S1 adjust encoder (the forth code) sets the delay function ON / OFF
When the unit will delay 2 minutes on power before entering
the normal operation.
***
Figure 2
1
2
5
4
6
7
910
11
12
8
13
3
Figure 3
2
134
NO
[ ]
*
S1 Alarm time setting
Factory default: 14 minutes
*
123
OFF
OFFOFF
OFFOFF
OFFOFF
OFF OFF
OFFON ON
Time
14m
8m
6m
2m
30s
5s
ON
ON
ONON
ON
ONONON
20m
Long
ring
OFF ON ON
OFF
（）Table 1
Factory default: ON
*
4Delay Mode
ON
OFF Off Delay
S1 delay settings
（）Table 2
SAB / SCB Mode
Sw2 choose SAB or SCB adjustment mode
SAB mode: When an alarm is triggered, the buzzer is powered by
the security console.
SCB mode: When an alarm is triggered, the buzzer is powered by
the built-in battery.
1. Working indicator : When the normal power supply and internal battery is connected
the red LED lights flashing.
2. Low-voltage alarm function: When the external power supply is lower than DC9.5V
or connect burglar hosts When wiring is cut, the unit automatically alert (from the
built-in battery-powered).
3. Two triggering alarm function, positive or negative trigger to match with different
trigger alarm host
4. A variety of alarm output timing (5-20 seconds, also choose a long ring)
5. The power-on delay function, when the power system latency two minutes before
entering the normal operation
8. Mounting Screw
9. Green LED
Indicator the System is ready
10. Set the alarm time encoder
11. Tamper switch
When moving the unit or unit is
moved from the wall, it will sound
an alarm.)
12. Buzzer
13. The expansion pipe
(
TAMPER tamper (NC), when the unit cover is opened or the chassis will trigger
TAPMER.
The positive power supply 12VDC (12V ~ 13.8V DC).
V - negative power 0V DC.
S - (ALARM) negative trigger.
S + (ALARM) positive trigger .
+ (Green LED) system indicates .
+ (Strobe) Flash positive trigger.
- (Strobe) Flash negative trigger.
V +
alarm
alarm
- (Green LED) system indicates .
2min delay
