Lippert Components Jack-It User manual

Jack-It™

Aftermarket Manual

www.lippertcomponents.com (574) 537-8900 Rev: 02.17 - Jack-It™ Aftermarket Manual

Jack-It™

Aftermarket

Manual

Table Of Contents

Introduction � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 1

Safety Requirements � � � � � � � � � � � � � � � � � � � � � � � � � � � � 1

Resources Required � � � � � � � � � � � � � � � � � � � � � � � � � � � � 2

Installation Instructions � � � � � � � � � � � � � � � � � � � � � � � � � 2

Securing Bikes � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 4

Patent protected, trademarked, and produced by Let’s Go Aero, Inc.

Corporate Ofce: 4474 Barnes Road, Colorado Springs, CO 80917 USA.

Made in China.

US Patent Numbers: 8,899,456, D717,716, D717,717, D684,917, D722,289,

patents pending.

Introduction

The Jack-IT™ is a bicycle rack designed to attach to your RV.

Additional information about this product can be obtained from

www.lci1.com/support or by downloading the free myLCI app.

The app is available on iTunes® for iPhone® and iPad® and

also on Google Play™ for Android™ users.

iTunes, iPhone, and iPad are registered trademarks of Apple

Inc. Google Play and Android are trademarks of Google Inc.

Lippert Components, Inc. recommends that the following

inspections, troubleshooting, component replacement and

verications be completed only by certied RV technicians.

Safety Requirements

Failure to follow the instructions provided in this

manual may result in death, serious injury, vehicle

damage or voiding of the component warranty�

Moving parts can pinch, crush or cut� Keep clear and

use caution�

The use of this product while bicycles are loaded may

affect the turning radius on some vehicles� Check the

turning radius before travel�

Jack- It™

Aftermarket Manual

www.lippertcomponents.com (574) 537-8900 Rev: 02.17 - Jack-It™ Aftermarket Manual

Resources Required

9/16” Socket Wrench

3/4” Socket Wrench

Installation Instructions

1� Remove the tongue jack from the coupler. Position the

PowerTower™ (Fig�1G) on the coupler. Place the

tongue jack on the PowerTower (Fig�1G) and secure

both to the coupler using 3 nuts, bolts and washers each

(Fig�1H, 1I and 1J).

Note: If there is no tongue jack, attach the PowerTower

(Fig�1G) to the coupler on the front of the trailer using 3

nuts, bolts and washers each (Fig�1H, 1I and 1J).

2� Attach the stinger (Fig�1F) to the PowerTower

(Fig�1G) using the NoMotion™ pin and washers

(Fig� 1C, 1D and 1A). For safety, insert the cotter pin

(Fig�1B) through the hole at the end of the NoMotion pin

(Fig�1C) after tightening securely.

3� Attach the base (Fig�1E) to stinger (Fig�1F) using the

NoMotion pin and washers (Fig�1C, 1D and 1A). For

safety, insert the cotter pin (Fig�1B) through the hole at the

end of the NoMotion pin (Fig�1C) after tightening securely.

Fig�1

Jack- It™

Aftermarket Manual

www.lippertcomponents.com (574) 537-8900 Rev: 02.17 - Jack-It™ Aftermarket Manual

Note: Several hole positions are provided for

cradles (Fig�2A). Pads (Fig�2D) and

SwayStop™ pins (Fig�2F) slide along the

length of the wings (Fig�2G).

4� Slide one SwayStop pin (Fig�2F) onto each

wing (Fig�2G) from the bottom so that the

SwayStop locates between the snap pin

(Fig�2H) and the pad (Fig�2D).

Note: A 2nd and optional SwayStop pin is

provided to secure both wheels of the bike to

the rack, install at this time if desired.

Note: If not using the 2nd and optional

SwayStop pins then the SwayStop pins

(Fig�2F) should point in opposite directions.

5� Attach wings (Fig�2G) to base (Fig�2E)

using 2 snap pins (Fig�2H).

6� Install 6 rubber straps (Fig�2B): 1 onto

each cradle (Fig�2A) and 1 onto each

SwayStop pin (Fig�2F).

7� Attach 4 cradles (Fig�2A). Attach 2 to each

wing (Fig�2G), securing with cotter pins

(Fig�2C). Attach 1 on each wing facing the

tow vehicle and 1 on each wing facing the

trailer.

Note: Adjustment will be necessary depending

on the size and desired position of the

bicycles.

C D E

Fig�2

Jack- It™

Aftermarket Manual

www.lippertcomponents.com (574) 537-8900 Rev: 02.17 - Jack-It™ Aftermarket Manual

Manual information may be distributed as a complete

document only, unless Lippert Components provides explicit

consent to distribute individual parts.

All manual information is subject to change without notice.

Revised editions will be available for free download at www.

lippertcomponents.com. Manual information is considered

factual until made obsolete by a revised version.

Please recycle all obsolete materials and contact Lippert

Components with concerns or questions.

NotesSecuring Bikes

1� For 2 bicycles, the best technique is to position the bicycles

front to back/back to front with the chain ring to the outside.

2� Hang 1 bicycle on the tow vehicle side of the bicycle rack, so

the top of the wheels are each supported by a cradle.

3� Secure by tensioning each rubber strap over the top of each

tire and engaging a strap hole with the end of the cradle.

4� Use 1 SwayStop pin to secure at least 1 wheel below the

frame where the wheel crosses the wing using the same

technique with the stop pin rubber strap (Fig�3). A second

and optional SwayStop pin is provided to secure both wheels

of the bike to the rack if desired.

5� Repeat for a 2nd bicycle on the trailer side of the bicycle rack.

Fig�3

Always make sure all connections between the bicycle

rack and the trailer coupler are secure/tight/ready for

travel� Always make sure the bicycles are securely

attached to the bicycle rack before driving�

Table of contents

Other Lippert Components Automobile Accessories manuals

Lippert Components

Lippert Components Solera Power Awning Regal Head Use and care manual

Lippert Components

Lippert Components Solera Slide Topper User manual

Lippert Components

Lippert Components SolidStep XF User manual

Lippert Components

Lippert Components Ground Control 3.0 Landing Gear User manual

Lippert Components

Lippert Components Levelegs Owner's manual

Lippert Components

Lippert Components Curt Rota-Flex Pin Box User manual

Lippert Components

Lippert Components Sway Command Manual

Lippert Components

Lippert Components Innolight Sliding Installation instructions

Lippert Components

Lippert Components Happijac User manual

Lippert Components

Lippert Components OneControl Hotspot User manual

Lippert Components

Lippert Components Kwikee User manual

Lippert Components

Lippert Components ground control 3.0 User manual

Lippert Components

Lippert Components ground control TT Installation instructions

Lippert Components

Lippert Components Solera Power Awning Use and care manual

Lippert Components

Lippert Components ground control 3.0 Guide

Lippert Components

Lippert Components Solera Classic Installation instructions

Lippert Components

Lippert Components Jack-It User manual

Lippert Components

Lippert Components X-Trek User manual

Lippert Components

Lippert Components ABOVE FLOOR SLIDEOUT SYSTEM User manual

Lippert Components

Lippert Components In-Wall Slide-Out User manual

Lippert Components

Lippert Components Solera User manual

Lippert Components

Lippert Components In-Wall Slide-Out Winnebago Operating instructions

Lippert Components

Lippert Components Tire Linc User manual

Lippert Components

Lippert Components Ground Control 2.0 User manual

Popular Automobile Accessories manuals by other brands

James Baroud

James Baroud Odyssey user guide

Motorola

Motorola i50sx owner's manual

Yakima

Yakima 9MM STANDARD BIKE MOUNT instructions

Feniex

Feniex T3 instruction manual

Renault

Renault 77 11 423 180 Installation instruction

Kia

Kia E8300-4D000 manual

Brink

Brink 756843 installation instructions

Whispbar

Whispbar K085W Fitting instructions

v.link

v.link CI-VL2-PC-HSD manual

Viking

Viking Stack-Rack Assembly and use instructions

Aries

Aries 203015 installation manual

Choetech

Choetech AT0005 user manual

ZZ2

ZZ2 ZZAIR-PRO instruction manual

Holman

Holman 4A80L installation guide

Thule

Thule 2075 parts manual

Motorola

Motorola T325 quick start guide

TAUBENREUTHER

TAUBENREUTHER 16-3950 FITTING INSTRUCTION

DV8

DV8 FBJL-02 Product installation manual