Lightolier 1000LV User manual

/INSTRUCTIONSHEETNO.

INSTALLATION PROCEDURE FOR LOW VOLTAGE

REFLECTOR TRIM IN THE 1000LV FRAME-IN KIT lS:1055LV

0s90 Page 1of 2

READ AND UNDERSTAND THESE lNSTRU~lONS BEFORE INSTALLING FIXTURE.

This fixture is intended for installation in accordance with the National Electrical Code and local regulation.

To assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

~~%~

FIG. AFIG. BFIG. CFIG. D

1. FRAME-IN 2. CLOSE-IN 3. SNAP~N 4. PUSH-UP

WARNING: BEFORE INSTALLING REFLECTOR TRIM TO FRAME-IN KIT, REAO MARKINGS IN REFLECTOR TRIM

AND ‘IN BOCK~ CUP OF FRAME-IN-KIT TO DErERMINE LAMP WAlTAGE AND TYPE APPLICABLE FOR YOUR

lNBTA1.L&TiON. IF I.C. TYPE FRAMING KIT IS USED, IT MAY BE INSTALLED IN DIRECT CONTACT WITN INSULATED

CSIUNGS. IF ANON I.C. TYPE FRAME4N.KfT IS USED, DO NOT INSTALL INSULATION WITHIN 31NCHSB OF FI)MJRE

SIDE OR WIRING COMPARTMENT, NOR ABOVE FIXTURE IN SUCH AMANNER TO ENTRAP HSAT.

1. FRAME-IN (Fig. A)

See Frame-In Kit Instruction Sheet for installation

procedure. FRAMINGKIT

,!;;

2. ROTATE ROTO-CLIPS (Fig. B) MOUNTSFLUSH

ONCEILINGMATERIAL

,..’

As shown in Fig. E. 0“ \

.-.,,:.,--

;’,.’.’.; :.:.-..,

3. SNAP.ON (Fig. C). , ....:.:

-... .’$.’.

Insert SOCKET through RECTANGLE HOLE on top \..,-.... .- CEILING

-,:.-...-:.

of REFLECTOR TRIM. Engage TAB from SOCKET MATERIAL

CUP into one of the SLOTS on top of REFLECTOR ROTO.CLIP ‘““::;~y ;

POSITION

TRIM and push other end of SOCKET CUP with :., ,,

LANCING into the other SLOT (Fig. F), FIG. E

4. PUSH-UP (Fig. D). –SOCKETCUP

Push REFLECTOR TRIM into ceiling until flange

is flueh to ceiling (Fig. D). RECTANGLEHOLE ~

N~E Socket manufacturers have suggested that SLOTa

socket may fail after 3to 6ralampings. If this

occurs, socket can be replaced by disconnecting REFLECTORTRIM

male connectors (attached to socket leads) from

female connectors (attached to fixture leads) and

replacing it with anew socket procured through

Lightolier (Fig. G).

INSULATINGSLEEVING MALECONNECTORa

SEE BACK PAGE FOR LAMP INSTALLATION (ATTACHEDTO SOCKETWIRE)

AND ADJU~MENT.

FEMALECONNECTORS

(ATTACHEDTO FIXTUREWIRES) MR16SOCKET

FIG. G

1- I<51“17<> l-l 1= ,a@ :v:::::i,N:r::::,E:i:T:j

LAMPING INSTRUCTIONS AND ADJUSTMENTILOCKING

INSTALL LAMP

Remove LAMP RING from LAMPIYOKE HOLDER by

pulling straight down (Fig. H).

insert LAMP (MR-16) between LAMP SPRINGS until

face of LAMP sits firmly on GLASS LAMP GUARD

(Fig, l).

Attach SOCKET to hi-in prongs on LAMP (Fig. l).

Insert LAMP RING with LAMP and GLASS LAMP

GUARD attached back into LAMP/YOKE HOLDER

(Fig. J).

WARNING: LAMP MANUFACTURERS REQUIRE THE

GLASS IAMP GUARD BE IN PLACE BEFORE ENERGIZING

LAMP AND THAT GREAT CARE MUST BE TAKEN THAT

LAMP IS FULLY COOLED BEFORE RELAMPING. AVOID

FINGER MARKS WHEN HANDLING FOR THEY MAY CAUSE

SHORT LAMP LIFE AND POSSIBLE BREAKAGE.

VERTICAUANGLE ADJUSTMENT AND LOCK (Figd)

9. krserl ascrewdriver into the LOCKING GUIDE on the

LAMP/YOKE HOLDER, and locate the clot in the

VERTICAL ADJUST/LOCK SCREW, turn the SCREW

counterclockwise, and using the screwdriver as a

lever, tilt the entwe UMPIYOKE HOLDER to the

desired angle. Once the desired angle ie reached,

tighten screw by turning screwdriver clockwise.

HORIZONTAL ADJUST AND LOCK (Fig. J)

10. The entire IAMPIYOKE HOLDER can be horizontally

rotated to aim the an Ie of light as it leaves the hole

in the APERTURE TRI (Fig. J). This can be done by

backing off the HORIZONTAL ADJUST/LOCK SCREW

one full turn, freeing the SUPPORT PLATE (Fig J).

Grasping the YOKES on either side of the

LAMP/YOKE HOLDER, rotate the SUPPORT PUTE

to the desired angle and lock the position by

tightening the HORIZONTAL ADJUST/LOCK SCREW.

RELAMPING: The locking mechanisms designed within this

fixture allow ralamping without having to readjust and

relock. Follow Steps 5-8.

NOTE 1. LOW VOLTAGE FIXTURES should be

dimmed only with special dimmers Intended

apeclfloslly for that purpose Use Lightoiier

Lytemodej Soenlst, Cresoendo VA, Neptune VA,’

Preolelon VA, Essveet VA, Sunrise VA, Rediant VA or

IS1055LV

0890

Page 2of 2

fs~

==77=.

LAMP

SPRING

I-44:

GL4S&5L~MP FIG. H

FIG. I

equlvelant pfidu6te by others or vsrisbie auto.

transformer’e or eieotmnlo dimmers intended for use

with low voltage flxturee. 2. Low voltsge fixtures msy

produoe audible eound when used with externel

dimmem which may be ob]ectional in acoustically

critical eree% DE

LAMP

GtiG~ARLMP

rLAMP

FIG. J

WARNING: USE ONLY REFLECTOR TRIMS PROVIDED By LIGHTOLIER INC. USE OF ~ER MANUFA~RERS’

RSFLECTDR TRIMS VOIDS THE UNDER~rERS LABORATORIES LISTING AND COULD CONSfTfUTE AFiRE HAZARD.

Table of contents

Other Lightolier Lighting Equipment manuals

Lightolier

Lightolier Lighting Systems F7000-16 User manual

Lightolier

Lightolier EC1-1 User manual

Lightolier

Lightolier Calculite ProSpec PA2P3075 User manual

Lightolier

Lightolier Lytecaster 1145 User manual

Lightolier

Lightolier F7000-18 User manual

Lightolier

Lightolier Calculite ProSpec PB2A7050 User manual

Lightolier

Lightolier Lighting Systems EG2-11 User manual

Lightolier

Lightolier Calculite ProSpec PA2P3810 User manual

Lightolier

Lightolier 1004ICX User manual

Lightolier

Lightolier Xceed 1050SQSLW User manual

Lightolier

Lightolier LFK2 User manual

Lightolier

Lightolier RT6-9 User manual

Lightolier

Lightolier FW01 User manual

Lightolier

Lightolier XP1GVA232 User manual

Lightolier

Lightolier Lytecaster 2000AICV User manual

Lightolier

Lightolier Aleron A-7 User manual

Lightolier

Lightolier ProSpec 37105 User manual

Lightolier

Lightolier Lytecaster 404X User manual

Lightolier

Lightolier LLC2 series User manual

Lightolier

Lightolier EC2-1 User manual

Lightolier

Lightolier Lytespan 8747 User manual

Lightolier

Lightolier Lytecaster 1078 User manual

Lightolier

Lightolier LP-3 User manual

Lightolier

Lightolier Brisa FC14U User manual

Popular Lighting Equipment manuals by other brands

Brizo

Brizo 8SP-MU-4 manual

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 installation instructions

IKEA

IKEA BJÖRKSPIREA manual

Laserworld

Laserworld Evolution Series ES-400RGB manual

Alien

Alien RG STAR user manual

EuroLite

EuroLite LED B-40 user manual

Qazqa

Qazqa Suplux SL 3 Black 103062 instruction manual

Commercial Electric

Commercial Electric 54568141 Use and care guide

CREE LIGHTING

CREE LIGHTING 304 Series installation instructions

Goobay

Goobay 49867 user manual

ECOMAN ITALIA

ECOMAN ITALIA LED T8 instruction manual

Alkalite

Alkalite Krypton KT-81 user manual

Clas Ohlson

Clas Ohlson GU10 manual

DTS

DTS DELTA 10 F user manual

ring

ring Solar Steplight manual

One Stop Gardens

One Stop Gardens 57696 Owner's manual & safety instructions

Chauvet DJ

Chauvet DJ COREpar UV120 ILS user manual

SIREM

SIREM Swimeo A2 instructions