LG MFL71742930 User manual

MFL71742930
OWNER’S MANUAL
Portable Bluetooth
Speaker
2012_Rev02
www.lg.com
Copyright © 2020 LG Electronics Inc. All Rights Reserved.
Please read this manual carefully before operating your set and retain it for future
reference.
MODEL
PN1

1 Getting Started
Getting Started2
Getting Started
1
Safety Information
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
This lightning ash with arrowhead
symbol within an equilateral triangle
is intended to alert the user to the
presence of uninsulated dangerous
voltage within the product’s
enclosure that may be of sufcient
magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an
equilateral triangle is intended
to alert the user to the presence
of important operating and
maintenance (servicing) instructions
in the literature accompanying the
product.
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK
HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN
OR MOISTURE.
CAUTION: The apparatus should not be exposed to
water (dripping or splashing) and no objects lled
with liquids, such as vases, should be placed on the
apparatus.
WARNING: Do not install this equipment in a
conned space such as a book case or similar unit.
CAUTION: Do not use high voltage products around
this product. (ex. Electrical swatter) This product may
malfunction due to electrical shock.
CAUTION: No naked ame sources, such as lighted
candles, should be placed on the apparatus.
CAUTION: Do not block any ventilation openings.
Install in accordance with the manufacturer’s
instructions.
Slots and openings in the cabinet are provided
for ventilation and to ensure reliable operation of
the product and to protect it from over heating.
The openings should never be blocked by placing
the product on a bed, sofa, rug or other similar
surface. This product shall not be placed in a built-
in installation such as a bookcase or rack unless
proper ventilation is provided or the manufacturer’s
instruction has been adhered to.

Getting Started 3
Getting Started
1
CAUTION concerning the Power Cord
The Power Plug is the disconnecting device. In case
of an emergency, the Power Plug must remain readily
accessible.
Check the specication page of this owner’s manual
to be certain of the current requirements.
Do not overload wall outlets. Overloaded wall outlets,
loose or damaged wall outlets, extension cords, frayed
power cords, or damaged or cracked wire insulation
are dangerous. Any of these conditions could result
in electric shock or re. Periodically examine the
cord of your device, and if its appearance indicates
damage or deterioration, unplug it, discontinue use of
the device, and have the cord replaced with an exact
replacement part by an authorized service center.
Protect the power cord from physical or mechanical
abuse, such as being twisted, kinked, pinched, closed
in a door, or walked upon. Pay particular attention to
plugs, wall outlets, and the point where the cord exits
the device.
NOTICE: For safety marking information including
product identication and supply ratings, please refer
to the main label on the bottom or the other surface
of the product.
CAUTION when using this product in environments
of low humidity
yIt may cause static electricity in environments of
low humidity.
yIt is recommended to use this product after
touching any metal object which conducts
electricity.

Getting Started4
Getting Started
1
Symbols
~Refers to alternating current (AC).
0Refers to direct current (DC).
Refers to class II equipment.
1Refers to stand-by.
!Refers to “ON” (power).
Refers to dangerous voltage.

Table of Contents 5
1
2
3
4
1 Getting Started
2 Safety Information
6 Unique features
6 Introduction
7 Front
8 Side
2 Operating
9 Charging the speaker
9 – Charging with the AC adapter
9 – Checking the charging status
10 – Checking Battery status
11 Basic Operations
11 – Using power button
11 – Bluetooth Connection
11 – Bluetooth LED status
12 – Simple Operation Guide
13 Handsfree Function
14 Voice Command
15 Listening to Music from Your External Device
16 Using BLUETOOTH® wireless technology
16 – Listening to music stored on the
BLUETOOTH devices
19 Dual Mode Connection
21 Other Operation
21 – Resetting
21 – Notice for Auto Power Off
3 Troubleshooting
22 Troubleshooting
4 Appendix
23 Trademarks and Licenses
23 Handling the Unit
24 Specifications
Table of Contents

Getting Started6
Getting Started
1
Unique features
Auto Power Off
This unit supports to turn off by itself for saving
energy consumption. (Page 21)
AUX (Portable In)
Listen to music from your portable device.
(Smart phone, Notebook, etc.)
BLUETOOTH®
Listen to music stored on your Bluetooth device.
Dual Mode
You can enjoy the sound in stereo by using two
speakers. For enjoying Dual Mode, you need to
purchase another speaker.
Dual mode is only supported with the same model.
(PN1 and PN1)
(Page 19-20)
Introduction
Symbol used in this manual
, Note
Indicates special notes and operating features.
> Caution
Indicates cautions for preventing possible damages
from abuse.
Water-proof (IPX5)
This speaker is water-proof according to IPX5.
IPX5 is “Degrees of protection against ingress of
water” However, this system is not completely
water-tight. Avoid the cases below.
yDo not use unit under water or other liquid.
yWhen battery is charging, do not expose the
unit to water.
yWhen port is exposed to water, wipe off it
with a soft dry cloth. Thoroughly dry it before
using the speaker.
yPorts are not water-proof. Make sure close
the port cover securely. Refer to below image.
- Position port cover onto a and securely
press it in b.
The water resistant performance of the system is
based on our measurements under the conditions
herein described. Note that malfunctions as a
result of water immersion caused by misuse by the
customer are not covered by the warranty.
> Caution

Getting Started 7
Getting Started
1
Front
h
i
j
a b dc e f g
a
1
Turns On / Off: Press it.
* If the power turned on, you can check the
battery status by pressing the
1
button for 2
seconds.
b
j
- Changes to Bluetooth mode in AUX mode.
(Press j)
* When you connect the 3.5 mm stereo cable,
the function is changed to AUX mode.
- Press and hold j for 7 seconds for Bluetooth
Initialization.
- Connects two speakers for Dual Mode. Press
and hold j for 2 seconds to use Dual Mode.
(Page 19-20)
c
Microphone
d
P
Turn down the volume.
e
O
Turn up the volume.
f
N
- Plays, pauses or skips playback on the
Bluetooth mode. (Page 12)
- Receives a call on the Bluetooth device.
(Page 13)
- Mutes the sound on the AUX mode.
g.
- Use Voice Command of your smart device.
Press . button to use voice command.
(Page 14)
- Mutes the sound on the handsfree function.
h
LED 1 (Power / Battery / Dual Mode LED)
i
LED 2 (Bluetooth LED)
jStrap

Getting Started8
Getting Started
1
Side
a
b
c
d
a
RESET button
bDC IN 5V
USB (C type) port for charging
c
AUX
Listens to music from your portable device.
dPort cover

2 Operating
Operating 9
Operating
2
Charging the speaker
Charging with the AC adapter
This speaker uses built-in battery. Before using it,
charge the battery by connecting the AC Adapter.
1. Connect the supplied USB cable to the AC
adapter.
2. Connect the USB cable to DC IN 5V port of the
speaker.
3. Plug the AC power cord into an AC outlet.
(Not
supplied)
Operating time is approx. 5 hours. It is based
on what fully charged the battery, continuous
playback using 50 % volume level.
It may vary depending on the battery status and
operational conditions.
, Note
AC adapter is not supplied. It is recommended
that you use the 5 V AC adapter approved by
LG Electronics Inc. (more than 2 A) with this
speaker because of danger of explosion. If you
do not use the recommended adapter, charging
is unavailable or charging time may differ.
> Caution
Checking the charging status
When speaker's battery is charging, you can check
the charging status by LED 1 (Battery LED).
LED 1 Description
<With the power on>
Green Off
Red
Green White
Battery is fully charged.
<With the power off>
Green Off
Red
Green White
Green Off
Red
Green White
Battery is charging.
yIf you listen to the music while charging, it will
take longer to charge.
yWhen the speaker is not charging by
overheating, LED 1 (Battery LED) blinks red
and amber alternately.
And charging is stopped.
yWhen the speaker’s battery is fully charged,
the LED 1 (Battery LED) turn on green for 15
seconds.
, Note

Operating10
Operating
2
Checking Battery status
If the power turned on, you can check the charging
status by pressing the 1 button for 2 seconds. Then
LED 1 (Battery LED) light will change depending on
battery charging status.
LED 1 Description Status
Green
Amber
Red
LED 1 (Battery
LED) turns on
green.
70 %
10 %
10 %
Green
Amber
Red
LED 1 (Battery
LED) turns on
amber.
70 %
10 %
10 %
Green
Amber
Red
LED 1 (Battery
LED) continuously
blinks in red and
sounds once.
70 %
10 %
10 %
yThe LED 1 (Battery LED) turn on for 3 seconds,
after the 1 button press for 2 seconds.
yChecking Battery status is not checked when
the speaker is charging.
, Note
This manual suits for next models
1
Table of contents
Other LG Speakers manuals









































