Larson Electronics WAL-TL-3XTL-C-SOL-100C User manual

WAL-TL-3XTL-C-SOL-100C

Solar Powered LED Signal Stack Light

Red, Yellow, Green - 100' 12/4 SOOW Cord

Instruction Manual

Thank you for your purchase of the Larson Electronics WAL-TL-3XTL-C-SOL-100C Solar Powered LED Signal Stack Light.

WARNING:

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

CRITICAL SAFETY INSTRUCTIONS:

•INSTALLATION SHOULD ONLY BECONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY

RELEVANT LOCAL BUILDING CODES.

•RISK OFFIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICAL

SYSTEMS. IFNOTQUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.

•BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.

•MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.

•TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP

OBJECTS. SUITABLE FOR DAMP LOCATIONS.

The WAL-TL-3XTL-C-SOL-100C Solar Powered LED Signal Stack Light from Larson Electronics is designed for routing

traffic in industrial refueling stations and safety notifications. This two-watt unit emits red, amber and green colors,

while operating on 24V AC/DC. The LED stack light is equipped with a waterproof solar panel and 100` of 12/4 SOOW

cable between the panel and the light fixture.

INSTALLATION

MOUNTING SOLAR PANEL

This solar panel includes a permanent mounting system that allows for

mounting to square/round poles or flat surfaces such as a wall or post

shown in figure below.

Position the solar panel in a location that receives the maximum amount of

sunlight throughout the day. This may need adjusted depending on the

season. With pole mounting, loosen the adjustment bolts to fit solar panel

onto pole. Once mounted, tighten bolts snug to secure panel to pole. For

surface mounting, remove additional plate and use the existing mounting

holes to mount directly to surface.

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 1of 2

MOUNTING STACK LIGHT

We strongly encourage a licensed electrician install this product,

in all locations, especially in outdoor areas where weatherproofing

may be required. Follow all applicable building and electrical code

when installing.

The stack light is designed to be mounted to the top of a threaded pipe

using the coupler on the bottom of the light. Feed the wiring through

the pipe you are mounting the light to, and thread the coupler onto the

pipe. Complete wiring connections utilizing the provided connectors,

each wire is labeled with it's corresponding connection. Once

connections are complete, thread the light onto the top of the coupler.

Installation is now complete.

WAL-TL-3XTL-C-SOL-100C

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 2of 2

HOW SOLAR LIGHT WORKS

Solar light must be placed outdoors. The solar panel collects and converts sunlight into DC power while the pre-installed rechargeable

batterystoresthe energy to power the light at night.

Solar light illumination time

It depends on the seasonal sunlight availability in your geographical area under certain weather conditions. Stronger or longer sunlight

hours enable batteries to store more energy which provides more lighting hours. On the contrary, weaker or shorter sunlight hours

reduce the lighting hours and its brightness as well.

Solar panel mounting locations

Solar panel must be placed outdoor at a location with its solar panel receiving direct sunlight at least five hours each day. Shadowed

locations will not allow batteryto be fully charged and will reduce both the brightness of the light and the lighting hours. Precautions

(prior to first time use)

1. To maximize battery capacity, the solar panel should be fully charged by direct sunlight for five hours before initial use.

2. Under extremely cold temperatures, the batteries may not charge fully. In such cases, the Solar Lights may not stay

illuminated as long.

MAINTENANCE

There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the

fixture for proper function.

•Disconnect power running to the lamp and be sure the fixture iscool to the touch.

•Use a non-abrasive glass cleaning solution to clean the lens and panel as needed.

Note: It is not necessary to open the fixture and clean or touch the LED’s.

USE AND CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.

Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of

children when not in use.Inspect for good working condition prior to storage and before re-use.

REPLACEMENT PARTS

The WAL-TL-3XTL-C-SOL-100C is designed to provide years of reliable performance. Should the need for replacement

parts arise, please contact Larson Electronics.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SAL[email protected] OR BY PHONE AT 1-877-348-9680 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Table of contents

Other Larson Electronics Lighting Equipment manuals

Larson Electronics

Larson Electronics SOL240-2XWP50E2X200A-RMBB-DNS-7.63SQ User manual

Larson Electronics

Larson Electronics EPL-AMB-150LED-50-140DB User manual

Larson Electronics

Larson Electronics EPL-TP-2XRUL10 User manual

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-DNS User manual

Larson Electronics

Larson Electronics EPL-HB-100LED-RT-UVA-20C-EPP User manual

Larson Electronics

Larson Electronics MMLP-1MLED-12P User manual

Larson Electronics

Larson Electronics EPL-PM-150LED Manual

Larson Electronics

Larson Electronics TPM-GL20004-12C-1227-10C User manual

Larson Electronics

Larson Electronics EXHL-TRN-LE4-FKWL Series User manual

Larson Electronics

Larson Electronics LEDWL-5-M User manual

Larson Electronics

Larson Electronics EPL-SL-4-50X-50LED-RT-MBC-EPP User manual

Larson Electronics

Larson Electronics HALD-48-1X4-2X50LED-DIMM User manual

Larson Electronics

Larson Electronics LM Multi Stage Series User manual

Larson Electronics

Larson Electronics EMGBALL-LED3 User manual

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-EB User manual

Larson Electronics

Larson Electronics EXP-EMG-EXT-LE6-1L User manual

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-480V-IBSC User manual

Larson Electronics

Larson Electronics HID-35-RC-W User manual

Larson Electronics

Larson Electronics EXP-EMG-2L-LE6 User manual

Larson Electronics

Larson Electronics HAL-PM-185LED-CPR User manual

Larson Electronics

Larson Electronics EPLC2-LED-50W-RT-JB5 User manual

Larson Electronics

Larson Electronics EPL-20W-HID-X12V-347V-GR50 User manual

Larson Electronics

Larson Electronics LED3W-LT-IR User manual

Larson Electronics

Larson Electronics GAU-EMG-2X5W-LED-WP User manual

Popular Lighting Equipment manuals by other brands

Brizo

Brizo 8SP-MU-4 manual

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 installation instructions

IKEA

IKEA BJÖRKSPIREA manual

Laserworld

Laserworld Evolution Series ES-400RGB manual

Alien

Alien RG STAR user manual

EuroLite

EuroLite LED B-40 user manual

Qazqa

Qazqa Suplux SL 3 Black 103062 instruction manual

Commercial Electric

Commercial Electric 54568141 Use and care guide

CREE LIGHTING

CREE LIGHTING 304 Series installation instructions

Goobay

Goobay 49867 user manual

ECOMAN ITALIA

ECOMAN ITALIA LED T8 instruction manual

Alkalite

Alkalite Krypton KT-81 user manual

Clas Ohlson

Clas Ohlson GU10 manual

DTS

DTS DELTA 10 F user manual

ring

ring Solar Steplight manual

One Stop Gardens

One Stop Gardens 57696 Owner's manual & safety instructions

Chauvet DJ

Chauvet DJ COREpar UV120 ILS user manual

SIREM

SIREM Swimeo A2 instructions