Larson Electronics EPLC2-LB-40LED-RT-CM User manual

EPLC2-LB-40LED-RT-CM

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 3

40W Hazardous Location Low Bay LED Fixture

Paint Spray Booth Approved -5,600 lms - Ceiling Mount - T5

Instruction Manual

The Larson Electronics EPLC2-LB-40LED-RT-CM Hazardous Location Low Bay LED Light Fixture provides operators

with a powerful alternative to traditional hazardous location luminaries. Capable of replacing 250-watt metal halide

lamps, this 40-watt low bay LED unit emits 5,600 lumens, carries an IP67 waterproof rating and features an extended

lifespan of 60,000+ hours. The factory sealed, hazardous location fixture is protected by a copper-free aluminum housing

with an epoxy powder coated finish.

WARNING

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE

REFERENCE. CRITICAL SAFETY INSTRUCTIONS:

•INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY

RELEVANT LOCAL BUILDING CODES.

•RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF LUMINAIRES ELECTRICAL

SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.

•BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.

•MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE RATED LUMINAIRE FIXTURES VOLTAGE.

•TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP

OBJECTS. SUITABLE FOR DAMP LOCATIONS.

IMPORTANT

READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE

REFERENCE. THE EPLC2-LB-40LED-RT-CM MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL

CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.

WE STRONGLY ENCOURAGE ONLY ALICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS

PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,

CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.

WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE

INSTALLATION OR PERFORMING ANY MAINTENANCE.

RISK OF FIRE/ELECTRIC SHOCK –DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.

RISK OF PERSONAL INJURY –FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.

RISK OF BURN –ALLOW FIXTURE TO COOL BEFORE SERVICING.

WIRING

Standard pigtail(flying leads) wiring

We strongly encourage a licensed electrician install this product,in all locations especially in outdoor areas

where weatherproofing may be required. Universal voltage driver permits operation at 100V -277V AC, 50 or 60Hz

except those factory ordered with low voltage 11V to 25V AC/DC.

Warning: Check product label for correct input voltage!

Attach supply line wires to the appropriate light fixture wires as shown

in thediagram 

Secure each pair of wires according to the diagram. Utilize a junction box or

similar device and take precautionary steps for weatherproofing all

connections if installed in a location where water may come in contact with the

unit. Ensure the unit is properly grounded and that wiring is done according to

all local and national electrical/building codes.

EPLC2-LB-40LED-RT-CM

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 2 of 3

VOLTAGE

This light is universal voltage capable and can be operated with 100-277V AC, 50/60Hz. We also offer a low voltage version

of this LED fixture that operates on AC/DC voltages from 11-25 Volts.

MOUNTING

This hazardous location low bay LED light fixture comes standard with a flat surface ceiling mounting system, equipped with

four bolts. The sturdy, square mounting plate can be secured on horizontal or vertical surfaces. Spacing between the

mounting component and LED fixture's fins, which are located at the back of the unit, streamline cool operation. Several

mounting options including pendant mounting and cable mounting can be ordered separately. Compared to high bay lights,

low bay fixtures are recommended for lower mounting heights ranging between 15' to 40'.

WIRING

The hazardous location low bay LED light fixture is equipped with an internal wiring junction box built into the mount of the

fixture. A total of four, 3/4" NPT threaded ports are available for running conduit (located at every corner of the unit).

Additionally, wiring can be passed through the junction box, reducing the need for additional junction boxes. Operators run

wiring directly to the fixture and terminate in the junction box mount. This fixture is factory sealed and does not require a seal

off.

WARNING: CHECK NAMEPLATE

FOR PROPER VOLTAGE. DAMAGE

FROM IMPROPER VOLTAGE WILL

VOID WARRANTY.

MAINTENANCE

Caution: To avoid personal injury, disconnect power to the light and allow the unit to cool down before

performing maintenance.

Warning: No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens will void

the warranty.

1. Perform visual, mechanical and electrical inspections on a regular basis. We recommend routine

checks to be made on a yearly basis. Frequency of use and environment should determine this. It is

recommended to follow an Electrical Preventive Maintenance Program as described in NFPA 70B:

Recommended practice for Electrical Equipment.

2. The lens should be cleaned periodically as needed to ensure continued photometric performance.

Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use mild soap or a liquid

cleaner.

3. Inspect the cooling fins on the luminaire to ensure that they are free of any obstructions or

contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if needed.

4. Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.

EPLC2-LB-40LED-RT-CM

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

3 of 3

USE AND CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.

Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of

children when not in use.Inspect for good working condition prior to storage and before re-use.

REPLACEMENT PARTS

The EPLC2-LB-40LED-RT-CM is designed to provide years of reliable performance. Should the need for replacement

parts arise, please contact Larson Electronics.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SALES@LARSONELECTRONICS.COM OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Table of contents

Other Larson Electronics Light Fixture manuals

Larson Electronics

Larson Electronics WAL-SBDL-SS-WP60E-24-1227 User manual

Larson Electronics

Larson Electronics EPLC2-AMB-70LED-50 Manual

Larson Electronics

Larson Electronics EPLC2-LB-25LED-RT User manual

Larson Electronics

Larson Electronics EPL-HB-3X150LED-RT User manual

Larson Electronics

Larson Electronics Golight User manual

Larson Electronics

Larson Electronics EPLC2-LB-45LED-RT-WLM User manual

Larson Electronics

Larson Electronics LEDWL-STRB-RED-1227 User manual

Larson Electronics

Larson Electronics EPL-EMG-HB-50LED-RT-WLM User manual

Larson Electronics

Larson Electronics IND-HR-UVC-EXS-R1-24-3L-120V-2X User manual

Larson Electronics

Larson Electronics EPL-LP-48W-LED Manual

Larson Electronics

Larson Electronics HALD-24-1X100LED-DIMM User manual

Larson Electronics

Larson Electronics EPL-HB-5K-LED User manual

Larson Electronics

Larson Electronics LED T Series User manual

Larson Electronics

Larson Electronics GVP-EMG-48-2L-LED User manual

Larson Electronics

Larson Electronics EPL-PM-1X30LED-120XLV-100 Manual

Larson Electronics

Larson Electronics ATEX-EPL-TL-3X10W-C User manual

Larson Electronics

Larson Electronics EPL-16BS-1X150LED-X24I-C1D1-200 Manual

Larson Electronics

Larson Electronics LEDWP-600E-E2E-10C User manual

Larson Electronics

Larson Electronics EPL-MBC-1MLED-2023 Manual

Larson Electronics

Larson Electronics EPLC2-BS-70LED-100 Manual

Larson Electronics

Larson Electronics HAL-PRM-150W-LED-100 User manual

Larson Electronics

Larson Electronics WAL-C-4XM User manual

Larson Electronics

Larson Electronics EPL-AMB-150LED-250 User manual

Larson Electronics

Larson Electronics RCL360-LED-40 User manual

Popular Light Fixture manuals by other brands

Emos

Emos CLASSIC ZY1431T manual

Westinghouse

Westinghouse Outdoor Lighting Fixture owner's manual

Hedler

Hedler C 12 silent Operation manual

Blizzard Lighting

Blizzard Lighting Puck: CSI manual 

Energetic Lighting

Energetic Lighting ELYSL-5004 Series installation instructions

Lightmaxx

Lightmaxx Shaft 5R user manual

Triarch

Triarch 31083 Assembly instructions

Philips

Philips 32614 Series user manual

IKEA

IKEA TIVED Assembly instructions

Lightolier

Lightolier LP200 specification

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH user manual

Martin

Martin MAC 250 Krypton user manual

Cooper Lighting

Cooper Lighting Halo L3232E Specification sheet

Stageline

Stageline ODW-2410RGBW instruction manual

Light Sky

Light Sky Tornado Series user manual

Lightolier

Lightolier Paralyte 2424 PLA2G9LS26U specification

Lightolier

Lightolier Lytespan 83ED17S specification

Lightolier

Lightolier Calculite CS8226 specification