Kohler K-706139 Assembly instructions

Installation and Care Guide

Pivot Shower Doors

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de Mcorresponden a México

(Ej. K-12345M)

Français, page “Français-1”

Español, página“ Español-1”

K-706139, K-706141

1280798-2-B

Tools and Materials

Before You Begin

WARNING: Risk of serious injury. Damage prior to installation can result in glass shattering.

Inspect the glass and all parts for damage before installation.

WARNING: Risk of serious injury. Improper installation can result in glass shattering. Follow all

installation instructions.

WARNING: Risk of serious injury. Do not cut tempered glass. Tempered glass will shatter if cut.

WARNING: Risk of serious injury. Shower door and side panels can shatter. Regularly inspect the

glass and all parts for damage, missing, or loose parts.

WARNING: Risk of serious injury. Always wear safety glasses while cutting and drilling.

CAUTION: Risk of personal injury. Tempered glass should not contact hard surfaces or it may

shatter. Do not touch the edge of the tempered glass panel with tools or any hard objects.

IMPORTANT! Leave this manual for the end user. Read these instructions before installing or using this

product.

IMPORTANT! This door is designed to accommodate walls that are less than 3/8″(10 mm) out of plumb.

Verify the area the door will be attached to is within 3/8″(10 mm) of plumb. The door may not function

properly if the wall is more than 3/8″(10 mm) out of plumb.

Before starting the installation, lay out and identify all of the parts. Inspect them for damage.

Place a drop cloth in the bottom of your shower to cover your drain and ease clean-up.

Closely follow the manufacturer’s instructions pertaining to the sealant application on the door.

Sealing areas other than those shown may cause leaking.

Two people should perform this installation.

If your model includes a return panel, follow the return panel instructions and consult these

instructions as needed.

Included:

•6 mm Drill Bit

• 2 mm and 3 mm Hex Wrench

Caulk Gun 100% Silicone Sealant

1280798-2-B 2 Kohler Co.

Parts Identiﬁcation

Anchor

Cap

#8 x 1-1/2"

Screw

Wall Jamb

Filler Strip

Anchor

Filler Strip

Wall Jamb

#8 x 1-1/2"

Screw

Handle

Cap

Long Seal

Seal

Short Seal

Kohler Co. 3 1280798-2-B

1. Determine the Door Conﬁguration

IMPORTANT! Install the pivot side of the door on the side opposite the showerhead for easy access to

shower controls.

Determine whether the door will pivot on the right or left side.

Conﬁrm no accessories will contact the door panel when it is opened or closed.

Make sure the door can swing freely in the chosen conﬁguration.

Top View

Swing open toward left

Swing open toward right

Images are for reference only.

Not actual product.

Top View

Note:

1280798-2-B 4 Kohler Co.

2. Prepare for Installation

IMPORTANT! This door is designed to accommodate walls that are less than 3/8″(10 mm) out of plumb.

Verify the area the door will be attached to is within 3/8″(10 mm) of plumb. The door may not function

properly if the wall is more than 3/8″(10 mm) out of plumb.

NOTE: Cover the drain hole or close the drain to avoid losing parts.

Conﬁrm the shower base is level.

Conﬁrm the walls are within 3/8″(10 mm) of plumb.

Mark the wall 3/8″(10 mm) from the front edge of the shower base. Repeat for the other side.

Cut the zip tie and remove the wall jamb from the door frame.

3/8"

(10 mm)

Kohler Co. 5 1280798-2-B

3. Prepare the Strike Side Wall Jamb

IMPORTANT! Do not install the strike side wall jamb until instructed. The strike side wall jamb is on the

same side as the door handle holes.

Position the strike side wall jamb on the wall 3/8″(10 mm) from the front ledge of the shower

base.

Plumb the wall jamb using a level.

Temporarily secure the wall jamb with masking tape.

Mark the location of the four wall jamb slots on the wall.

Remove the masking tape, then move the wall jamb to a safe area.

IMPORTANT! The supplied 6 mm drill bit is not suitable for drilling through tile. For tile installations,

usea6mmtile bit.

Slowly drill the marked hole location, using the provided 6 mm drill bit for non-tiled walls.

Insert an anchor into each hole. Make sure the anchors are ﬂush with the ﬁnished wall.

3/8"

(10 mm)

6 mm

1280798-2-B 6 Kohler Co.

4. Install the Pivot Side Wall Jamb

Position the pivot side wall jamb on the wall 3/8″(10 mm) from the front ledge of the shower base.

Plumb the wall jamb using a level.

Temporarily secure the wall jamb with masking tape.

Mark the location of the four wall jamb slots on the wall.

Remove the masking tape, then move the wall jamb to a safe area.

IMPORTANT! The supplied 6 mm drill bit is not suitable for drilling through tile. For tile installations,

usea6mmtile bit.

Slowly drill the marked hole location, using the provided 6 mm drill bit for non-tiled walls.

Insert an anchor into each hole. Make sure the anchors are ﬂush with the ﬁnished wall.

Secure the wall jamb to the wall using the four #8 x 1-1/2″screws.

3/8"

(10 mm)

6 mm

Kohler Co. 7 1280798-2-B

5. Position the Door Assembly

CAUTION: Risk of injury. Tempered glass should not contact hard surfaces or it may shatter. Do

not touch the edge of the tempered glass panel with tools or any hard objects.

Position the strike side wall jamb on the door frame.

Slide the pivot side of the door frame into the installed pivot side wall jamb.

Adjust the door frame until it is in the ﬁnal installation position.

1280798-2-B 8 Kohler Co.

6. Center the Door Frame

Open the door.

Conﬁrm the strike side wall jamb holes are aligned with the anchors. Adjust if needed.

On the strike side of the frame, insert the supplied guide into one of the screw holes.

Insert a #8 x 1-1/2″into the guide and tighten.

Remove the guide.

Repeat for the other three screw holes.

Center the door frame between the wall jambs. Dimension Xshould be the same on both sides.

NOTE: Leave a small gap at the handle side of the door for clearance from the strike jamb. The door will

not close properly without this gap.

Guide

Kohler Co. 9 1280798-2-B

7. Install the Door Assembly

Conﬁrm the door frame is square. Adjust the frame if needed following the adjustment steps in this

manual.

On one of the wall jambs, using the supplied 3 mm hex wrench, turn each of the three locking

screws clockwise 1/4 turn to lock the door frame in place.

Repeat with the second wall jamb.

1/4 Turn

3 mm

1280798-2-B 10 Kohler Co.

This manual suits for next models

Table of contents

Languages:

Other Kohler Bathroom Fixture manuals

Kohler

Kohler K-24985K Assembly instructions

Kohler

Kohler K-6236 Assembly instructions

Kohler

Kohler K-994 User manual

Kohler

Kohler K-702300 Assembly instructions

Kohler

Kohler K-4636 User manual

Kohler

Kohler Tresham K-2992-8 User manual

Kohler

Kohler K-7435 Assembly instructions

Kohler

Kohler K-792-H2 Assembly instructions

Kohler

Kohler K-3900 User manual

Kohler

Kohler Stillness 954M-4 User manual

Kohler

Kohler K-701799T-FMSW User manual

Kohler

Kohler K-1098 User manual

Kohler

Kohler K-22261T User manual

Kohler

Kohler K-15000 User manual

Kohler

Kohler K-8501 Assembly instructions

Kohler

Kohler K-13056 Assembly instructions

Kohler

Kohler Stillness K-960-4 Assembly instructions

Kohler

Kohler SKYLINE K-22316T-FM-S User manual

Kohler

Kohler K-78202X-L Assembly instructions

Kohler

Kohler Real Rain Showerhead Assembly instructions

Kohler

Kohler K-8052 Assembly instructions

Kohler

Kohler K-28238-GKE User manual

Kohler

Kohler PRESQU ILE K-8745T-U User manual

Kohler

Kohler Elevation 76665T-E User manual

Popular Bathroom Fixture manuals by other brands

DURAVIT

DURAVIT C.1 C15240 0090 Instructions for mounting and use

Heatstore

Heatstore HSTRL500WTN Installation and operating instructions

Sunshower

Sunshower PURE SOLO manual

Delabie

Delabie Delabie Sporting 714700 manual

ESS

ESS Container TCL-11 installation manual

Mustee

Mustee 22C installation instructions

VITRA

VITRA V-Flow manual

baliv

baliv DUK-80.30 T manual

Malmet

Malmet B105BT Operation, maintenance and installation manual

bathstore

bathstore Transition H1690MM Installation, Care & Adjustment Instructions

BELLOSTA

BELLOSTA Edward 0800/M Installation instruction

baliv

baliv DU-5160 manual

Franke

Franke PRTR0006 Installation and operating instructions

Gessi

Gessi RILIEVO 59011 manual

noken

noken VITAE 100188525-N299998810 manual

Allen + Roth

Allen + Roth 1142VA-30-201 manual

Britex

Britex HBDA installation guide

GRE

GRE DSALC32W instruction manual