TOS6200/6210 Contents V
Chap. 1Chap. 2Chap. 3Chap. 4Chap. 5Chap. 6Chap. 7Chap. 8Appendix
4.5.1 GPIB Address -----------------------------------4-20
4.5.2 RS-232C Protocol --------------------------------4-21
4.6Panel Memory ---------------------------------------4-22
4.6.1 Storingin the Panel Memory -------------------------4-22
4.6.2 Recallingthe Panel Memory -------------------------4-23
4.7 Program --------------------------------------------4-24
4.7.1 Recallingthe Program -----------------------------4-25
4.7.2 Creatingor Editingthe Program -----------------------4-25
4.7.3 Runningthe Program -----------------------------4-27
4.7.4Suspendingthe Program ----------------------------4-27
4.7.5 PASS/FAIL JudgmentDuringProgram Execution ----------4-27
4.7.6 Endingthe Program -------------------------------4-27
4.8 Key Lock -------------------------------------------4-28
4.9 Checkingthe TestConditions -----------------------------4-28
4.9.1 SettingOutput out of the Operation Range ---------------4-28
4.9.2 UpperReference Value <= LowerReference Value (UP<= LOW) 4-
30
4.10 Protection Fuction -------------------------------------4-31
4.10.1 Time Limitation with Respectto Output (OVER HEAT) ------4-31
4.10.2 OverheatingProtection (OVER HEAT) -----------------4-32
4.10.3 Overload Protection (OVER LOAD) -------------------4-32
4.10.4Output Voltage Limitation (VOLT LIMIT) ---------------4-33
4.10.5 Change in ENABLE Signal (SIGNAL I/O) ---------------4-33
4.11 Initialize -------------------------------------------4-34
Chapter 5 REMOTE and SIGNAL I/O_________________________ 5-1
5.1 REMOTE Terminal -------------------------------------5-2
5.2 SIGNAL I/O Connector ----------------------------------5-3
5.2.1 SIGNAL I/O Connector Specifications ------------------5-4
5.2.2 StartingaTest------------------------------------5-6
5.2.3 RecallingaPanel Memory and Program ------------------5-7
5.2.4Examples of Use ---------------------------------5-8
Chapter 6 GPIB and RS-232C_______________________________ 6-1
6.1 Interface --------------------------------------------6-2
6.1.1 GPIB Interface -----------------------------------6-2
6.1.2 RS-232C Interface ---------------------------------6-2
6.2 Message and Terminator ---------------------------------6-4
6.2.1 Messages ---------------------------------------6-4
6.2.2 Terminator -------------------------------------6-6
6.2.3 Special Symbols and Characters -----------------------6-6
6.3 Device Messages ---------------------------------------6-7
6.3.1 Register-Related and General-Purpose Messages ------------6-7
6.3.2 System-Related Messages --------------------------6-13
6.3.3 Messages Relatingto TestConditions and TestExecution -----6-18
