IMPORTANT INSTRUCTIONS
1. Disconnect power supply before wiring connections are made to prevent possible electric
shock and/or damage to equipment.
2. Read and follow instructions carefully. Failure to comply with instructions could result in
fire, electric shock, injury to persons, and/or damage to equipment.
3. To reduce the risk of overheating and possible damage to other equipment, this speed
controller is only intended for use with the iLIVING Variable Speed Shutter Exhaust Fans
(ILG8SF10V, ILG8SF12V, ILG8SF16V, ILG8SF18V, ILG8SF20V, and ILG8SF24V). Do
not install this speed controller on any other fan or appliance.
4. All wiring should conform to the United States National Electrical Code and all applicable
local/state regulations.
5. Do not mount the controller in an area which will likely expose the controller to moisture.
6. Make certain the entire installation is grounded as a precaution against possible electrical
shock.
7. Do not exceed maximum amperage rating of the controller as overloading can result in
damage to the shutter exhaust fan and controller.
8. When wiring an electrical appliance or device follow all electrical and safety codes, as
well as the most recent United States National Electrical Code (NEC) and the
Occupational Safety and Health Act (OSHA).
9. Install controller in a well-ventilated area.
CAUTION: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE
THIS CONTROLLER IN AN INSULALTED WALL
Installation
1. Turn power off at circuit breaker panel or fuse box.
2. Mount controller to standard single gang wall box.
3. Run conduit between the wall box, power source, and the fan units being controlled.
Leave approximately 4 inches of wire in the box for connections.
To Motor
White
Neutral
(White)
Hot
(Black)
Black
To Power Supply
