1
INTRODUCTION
1.1
4
See figure 1.1.
The ILFOLAB 2150RC table-top processing system is designed for
low to medium volume users of paper. Typically, up to 1000
20˙3x25˙4cm (8x10 inch) prints can be processed on one fill of
chemicals. The system is very easy to install, operate and
maintain, and provides black and white prints on resin coated
papers up to a maximum width of 50.8cm (20 inches). The prints
are fully processed and dried to a very high standard.
This manual gives full instructions for installing and operating the
complete system. By disregarding all references to the dryer, this
manual also describes the processor when used alone.
For ease of description, it is assumed the left and right hand sides
of the processor are determined when facing the processor at the
paper feed (front) end. The left and right hand sides of the dryer
module are determined with the dryer module removed from the
processor and the paper feed side facing (ie the side normally
facing away from the operator). Unless otherwise stated, the
50Hz system is shown.
IMPORTANT INFORMATION
Chemicals
For optimum results always use recommended ILFORD chemicals.
Before handling ILFORD chemicals please ensure you are familiar
with the information detailed in the ILFORD Photochemical Safety
Data Sheets supplied as part of the chemicals pack.
Automatic rinsing
This is a feature designed to simplify regular cleaning operations
and, therefore, to keep major strip-down cleaning to a minimum.
Colour coding
Roller racks are colour coded: red for developer, green for fixer
and white for wash water. Do not interchange the roller racks for
any reason. The same colour coding is used on the drain outlets
at the rear of the processor, the standpipes in the working and
front tanks and the covers on the front tanks.
Operation
A wall chart, which summarises the regular operating procedures,
is supplied with this manual.
