Figure 3: Micro SD card slot and reset button (continued)
Note: Remove the four screws on the camera cover (1) (Figure 1) to
access the buttons. Securely attach the cover when finished.
Table 3: Micro SD card slot and reset button
Camera button description
Reset button (Hold for more than 3 seconds)
Quick reference
Default IP: 192.168.1.168 (DHCP enabled).
Default Username / Password: admin / admin
Power: 12VDC or PoE
Use Internet Explorer 11 web browser.
Mounting the camera to a wall or ceiling
Ensure that the wall or ceiling is strong enough to withstand three times
the weight of the camera.
1. Place the mounting template on the surface that you want to attach
the camera.
2. On the surface drill four Ø 4.6mm holes and cut out a cable hole as
per the markings identified on the mounting template.
3. Securely place the four screw anchors into the four holes.
4. Remove the four screws on the camera cover (2) (Figure 1) to
remove the cover from the camera base (1) (Figure 1).
5. Place the camera cable through the cable hole on the mounting
surface.
OR
Use the cable side entry hole slot on the camera base.
Quick Start Guide
(8200-1994-05_C0)
Tyco Holis JSE Economical 4MP Mini Dome Cameras
(Product Code: JSE04-D10-OI01 and JSE04-D30-OI03)
In the box
1 x Camera
1 x Quick Start Guide
4 x 4x25mm tapping screws
1 x Mounting template
4 x 6x25mm Plastic screw anchors
1 x Silicone plug
1 x L-Key Hexagonal wrench
1 x Regulatory Document
Installation tools
Screwdriver
Drill
L-Key Hexagonal wrench
Figure 1: Camera parts
Figure 1
Table 1: Camera part descriptions
Figure 2: Cable connections
Figure 2
Table 2: Cable connection descriptions
Cable connection description
Ethernet Connector and also supports PoE
Power Connector (12V DC @ 1A)
Figure 3: Micro SD card slot and reset button
Figure 3
Mounting the camera to a wall or ceiling (continued)
Note: If you are not using the cable side entry slot then ensure that
the cable side entry plug is inserted into the slot on the camera
base.
6. Hold the camera base (1) (Figure 1) up to the mounting template
and align the four holes on the camera base with the four holes on
the mounting surface.
7. Insert the four screws into the four holes on the camera base and
securely attach the camera to the mounting surface.
8. Hold the camera base cover up to the camera base and align the
four holes on the camera cover with the four holes on the camera
base.
9. Insert the screws into the four holes and securely attached the
camera cover to the camera base.
10. To power up the camera:
Connect a 12V DC power supply to the power connector on
the camera cable.
OR
Connect a shielded PoE cable to the ethernet / PoE slot on
the camera cable.
