Hand Held Products 4600g User manual

4600g, 4600r, 4600rp, 4800i

Quick Start Guide

Note: Refer to your user’s guide for information

about cleaning your device.

For localized language versions of this document,

go to www.handheld.com.

Getting Started

Turn off computer’s power before connecting the

scanner, then power up the computer once the

scanner is fully connected.

USB Connection

Keyboard Wedge Connection

Serial (RS-232) Connection

Reading Techniques

The view finder

projects an aiming

beam that should

be centered over

the barcode, but

can be positioned

in any direction for

a good read.

Hold the scanner

over the barcode,

pull the trigger, and center the aiming beam on the

barcode.

The aiming beam is smaller when the scanner is

closer to the code and larger when it is farther from

the code. Hold the scanner close to smaller

barcodes, and farther away from large barcodes to

get a proper read.

If the barcode is highly reflective (e.g., laminated),

you may need to tilt the scanner at an angle so the

barcode can be scanned.

Standard Product Defaults

The following barcode resets all standard product

default settings.

Standard Product Defaults

Interface

Scan the barcode that describes the PC or interface

you are using.

AT/PS2 Keyboard Wedge

(Default)

RS-232

USB Keyboard (PC)

Emulate External Keyboard

Japan DOS/V

Keyboard Country

Scan the Program Keyboard Country barcode

below, then scan the numeric barcode(s) from

page 10, then the Save barcode to program the

keyboard for your country. As a general rule, the

following characters are not supported by the

scanner for countries other than the United States:

@ | $ # { } [ ] = / ‘ \ < > ~.

Note: For a complete list of country codes, see the

User’s Guide for your product at our website,

www.handheld.com.

Country Code Scan Country Code Scan

Belgium 1 Italy 5

Denmark 8 Norway 9

Finland 2 Spain 10

France 3 Switzerland 6

Germany/Austria 4 USA (Default) 0

Great Britain 7

Program Keyboard Country

Save

Trigger

The following barcodes will allow you to use the

reader in Manual Trigger mode (need to press the

trigger to read) or Presentation mode (the reader is

activated when it “sees” a barcode).

Streaming Presentation™

Note: Streaming Presentation Mode applies only

to units with the Advanced Illumination

feature. Units with the advanced illumination

feature have a software revision of

31205480-118 or newer.

When in Streaming Presentation mode, the imager

leaves the scan illumination on all the time and

continuously searches for barcodes.

Manual Trigger

(Default)

Presentation Mode

Streaming Presentation Mode

Reread Delay

This sets the time period before the scanner can

read the

same

barcode a second time. Setting a

reread delay protects against accidental rereads of

the same barcode.

Suffix

If you want a carriage return after the barcode, scan

the Add CR Suffix barcode. To add a tab after the

barcode, scan the Add Tab Suffix barcode.

Otherwise, scan the Remove Suffix barcode to

remove the suffixes.

Medium Reread Delay

Add CR Suffix

Remove Suffix

Add Tab Suffix

Add Code ID Prefix to all Symbologies

Scan the following barcode if you wish to add a

Code ID prefix to all symbologies at once.

Note: For a complete list of Code IDs, see the

User’s Guide for your product at our website,

www.handheld.com.

Function Code Transmit

When this selection is enabled and function codes

are contained within the scanned data, the imager

transmits the function code to the terminal. Charts

of these function codes are provided in your User’s

Guide. When the imager is in keyboard wedge

mode, the scan code is converted to a key code

before it is transmitted.

Add Code ID Prefix To All Symbologies

(Temporary)

Enable

(Default)

Disable

Data Format Editor Instructions

The following are abbreviated instructions for

entering a data format. For complete instructions

refer to your User’s Guide, available at our website,

www.handheld.com.

1. Scan the Enter Data Format symbol.

2. Primary/Alternate Format: scan 0for Primary

Format

3. Terminal Type: scan 99 for any terminal type

4. Code I.D.: scan 99 for any barcode type

5. Length: scan 9999 for any length barcode.

6. Editor commands: use the Programming Chart

that follows.

7. Scan Save to save your entries.

Enter Data Format

Clear All Data Formats

Save

Other manuals for 4600g

This manual suits for next models

Table of contents

Other Hand Held Products Barcode Reader manuals

Hand Held Products

Hand Held Products IMAGETEAM 3800E User manual

Hand Held Products

Hand Held Products IMAGETEAM 3800E User manual

Hand Held Products

Hand Held Products IMAGETEAM 4620 User manual

Hand Held Products

Hand Held Products QUICK CHECK 890 User manual

Hand Held Products

Hand Held Products 4600g User manual

Hand Held Products

Hand Held Products 4230 User manual

Hand Held Products

Hand Held Products SCANTEAM 2070 User guide

Hand Held Products

Hand Held Products IMAGETEAM 4410 User manual

Hand Held Products

Hand Held Products HANDHELD 3800G User manual

Hand Held Products

Hand Held Products 4820 User manual

Hand Held Products

Hand Held Products IMAGETEAM 4400 User manual

Hand Held Products

Hand Held Products 4600g User manual

Hand Held Products

Hand Held Products 3800PDF User manual

Hand Held Products

Hand Held Products QUICK CHECK 890 User manual

Hand Held Products

Hand Held Products 4X00 User manual

Hand Held Products

Hand Held Products IT4000 Use and care manual

Hand Held Products

Hand Held Products Valueteam 3060 User manual

Hand Held Products

Hand Held Products Quick Check 200 Series User manual

Hand Held Products

Hand Held Products HandHeld 3800 Linear Series User manual

Hand Held Products

Hand Held Products Scanteam 5700 User manual

Hand Held Products

Hand Held Products 3800ESD User manual

Hand Held Products

Hand Held Products Quick Check PC600 User manual

Hand Held Products

Hand Held Products Quick Check Bar Code Verifiers 800 User manual

Hand Held Products

Hand Held Products HandHeld 3800 Linear Series User manual

Hand Held Products 4600g User manual

Popular Barcode Reader manuals by other brands