Geemarc CL60 User manual
CL60
Amplified Classic Phone
Téléphone Vintage Amplifié
Lautverstärktes Retrotelefon
English1~12
Français13~24
Deutsch25~36
1
User manual to be read carefully before use!
CAUTION: this telephone is specifically designed for people with
hearing difficulties and is provided with a handset earpiece volume
control for individual requirements. Due care must be taken by all
users that the handset earpiece volume control is set to the lowest
level acceptable by each respective user. Care should therefore be
exercised to ensure that any naive users are familiar with this
requirement.
2
CONTENTS 2
DESCRIPTION 3
General Description 3
SETTING UP 5
1 - Connecting the telephone 5
2 - Ringer volume setting 5
3 –Ringer Tone / Time Break Recall setting (300/100) 5
4 –Auto Dial Switch 6
5 –Auto On Hook 6
VOLUME AND TONE ADJUSTMENT 7
1 - Receiving volume and tone adjustment 7
2 - Sending volume adjustment 8
USING THE PHONE 9
1 - Answer a call 9
2 - Making a call 9
3 - Last number redial 9
4 - Recall (R), * & # buttons 9
5 - Storing telephone numbers 9
6 - Dialing stored numbers 10
GUARANTEE 11
GENERAL INFORMATION 12
CONTENTS
3
General Description
1
2
3
4
5
6
7890
E
DF
IA
HB
GC
L
K
J
M
N
O
P
Q
R
STUVWXYZ
Battery low LED
Ringer LED &
AMPLIFY On LED
Auto turn off Switch
Auto Dial SOS
Number Switch
Recall/Ringer Selector
100msec UK/100msec EURO/
300msec EURO
Amplify ON/OFF
slide switch
Ringer Loud/High/
Low/Off Switch
Lock the
Battery Door
4XAA Size
Battery
Compartment
Store Button
DESCRIPTION
4
Slide Volume
Control
Send Amplify
-3 / 0 / +3dB
Slide Tone
Control
DESCRIPTION
5
1 - Connecting the telephone
- Connect the handset cord.
- Open the battery door by turning around the locking tab.
Insert 4 alkaline batteries (type AA 1.5V, not supplied) in the
compartment (*). Batteries are required if you wish to
increase the ringer level up to 10 dB and if you wish to use
the “Mechanical Bell” ringer.
Battery door back in place and turn the tab to lock the lid in
place.
- Connect the line cord plug into the line socket into the rear of
the unit (*).
- Connect the other end of the line cord into the wall PTT
socket (*).
2 - Ringer volume setting
A switch located on the right side allows the ringer to be switched to
Hi, Low or Off:
: Off
: Low
: Hi
: LOUD
Note: The ring level will be increased of 10 dB if you insert
batteries.
(*) Classified TNV-3 according to EN60950 standard.
SETTING UP
6
3 –Ringer Tone / Time Break Recall setting
(300/100)
The phone is equipped with “Mechanical Bell” ringers which can be
selected between UK (tring..tring) & European (triiiiiiiiiiiing) style
bells, via the switch located in the battery compartment.
The mechanical bell sound is functional only when the batteries are
inserted and are not run down.
If there are no batteries or the batteries are “low” the Battery low
indicator flashes and the ringer sound will be the normal two tone
electronic ring.
Your phone works with a time break recall for United Kingdom
(R=100msec). It can be switched to 300msec for other locations or
PBXs. Use the same switch as used to select the Ringer tone, to
select the Recall time
4 –Auto Dial Switch
When this switch is in ON position ( ), upon lifting the handset the
phone will automatically dial out the number stored in the SOS
memory if no other dial button is pressed for 4 seconds. Set this
switch as per your requirement.
5 –Auto On Hook
When this switch is in the On position ( ) , the phone will
automatically go On Hook (disconnect the telephone line) when the
person at the other end disconnects the line, even if the handset is
not replaced on the cradle.
In case the handset is removed from the cradle and there is a phone
call, the phone will still ring as usual. To answer the call, pick up the
handset, press and release the hook button once.
SETTING UP
7
1 - Receiving volume and tone adjustment
You can increase the volume and adjust the receiving tone
according to your own hearing requirements.
The button (AMPLIFY ON/OFF switch) allows extra receiving
and tone functions to be activated or not during the conversation.
When the function is activated, the red light of extra receiving and
tone function located near the REDIAL/RECALL buttons is lit.
Adjust the TONE and VOLUME buttons to fit the levels to your own
hearing requirements.
VOLUME AND TONE ADJUSTMENT
8
Note: When the tone (treble), earpiece volume and sending levels
are set to the maximum, whistling may occur. Then the sending
level settings should be decreased with the switch .
When the switch located under the phone is ON ( ), the extra-
receiving and tone functions are automatically activated each time
you use the phone. When this switch is OFF ( ), you will need to
activate the function by switching the button to ON ( ).
Tone and volume (15dB to 30dB) adjustment is only activated when
the button is set to ON ( ). When this button is set to OFF
( ) only the volume can be adjusted from 0dB to 15dB.
2 - Sending volume adjustment
If your voice is quiet or called parties have difficulty hearing you, you
can increase the sending level volume with the switch located on
the hand side. You can also decrease the sending volume if
required.
VOLUME AND TONE ADJUSTMENT
9
If you are using this telephone with a hearing aid, set your
hearing aid to the T setting.
1 -Answer a call
- When an incoming call is received the phone will ring and
flash, to answer the call lift the handset and speak.
- On completion of the call, carefully replace the handset in the
cradle to release the line. See also section on Auto/Manual
switch
2 - Making a call
- Lift the handset.
- Await the dial tone and dial the required number.
- On completion of the call, carefully replace the handset in the
cradle.
See also section on Auto Dial On/Off switch
3 - Last number redial
- Lift the handset.
- Await the dial tone and press button.
- The previously dialled number will be automatically redialled
(not in use for memory numbers).
Note: If Auto Dial On/Off switch is set to ON position ( ), if the
Last Number Redial Button is not pressed within 4 secs of lifting
the handset, the number stored in SOS memory will
automatically dial out.
4 - Recall (R), * & # buttons
These are used with the new services provided on digital
exchanges. For details please contact your network operator.
USING THE PHONE
Table of contents
Languages:
Other Geemarc Telephone manuals
Geemarc
Geemarc CL210A User manual
Geemarc
Geemarc CL10+ User manual
Geemarc
Geemarc DALLAS 100 VM User manual
Geemarc
Geemarc T300 User manual
Geemarc
Geemarc PHOTOPHONE 450 User manual
Geemarc
Geemarc TP38 clip User manual
Geemarc
Geemarc AmpliPHOTO50 User manual
Geemarc
Geemarc Dialatron User manual
Geemarc
Geemarc CL1400 User manual
Geemarc
Geemarc Ampli100VM User manual
Geemarc
Geemarc DALLAS20 User manual
Geemarc
Geemarc CL400 User manual
Geemarc
Geemarc SOLAR4 User manual
Geemarc
Geemarc CLEARSOUND PhotoPHONE User manual
Geemarc
Geemarc Solar 4 CID User manual
Geemarc
Geemarc CL330 User manual
Geemarc
Geemarc AMPLIDECT 280 User manual
Geemarc
Geemarc Jupiter 20 User manual
Geemarc
Geemarc CL555 User manual
Geemarc
Geemarc PhotoPhone User manual
