GCC Technologies Elite 21DN+ User manual

GCC Elite 21 Series

Getting Started Guide

Elite 21N+

Elite 21DN+

Elite 21N+ A high-resolution, networkable 1200 dpi laser

printer with USB, Parallel and Ethernet ports.

Comes with 64MB of RAM.

Elite 21DN+ Same features as the Elite 21N+ with the pre-

installed Duplex Unit for double-sided printing.

Getting Started Guide

What is this Guide?

This guide provides easy-to-follow instructions for unpacking, setting up and installing your

new GCC printer.

Where is the User’s Manual?

The comprehensive Elite 21 Series User’s Guide is located in Adobe Acrobat .pdf format

on your Elite 21 Series CD.

Can I access information from the GCC web site?

GCC product manuals, software installation instructions, the most current printer drivers,

FAQs, technology updates and a searchable database for technical questions are all located

in the Support Central section of GCC’s web site. Support Central can be accessed

directly at:

http://www.gccprinters.com/support

Which models are covered by this guide?

This Getting Started Guide applies to the following Elite 21 Series models:

Installation Checklist

For proper installation, please complete each section in order:

Step 1 Check Package Contents

Step 2 Prepare Printer Location

Step 3 Locate Printer Parts

Step 4 Remove Tape

Step 5 Install Toner Cartridge

Step 6 Load Paper Tray

Step 7 Connect Printer Cables

Step 8 Attach Power Cord

Step 9 Configure Network Settings

Step 10 Install Printing Software

Step 11 Verify Printer Setup

Note: No printer cables are included with the printer. For information on ordering cables, contact GCC

Direct Sales at 800-422-7777 (North America only, outside of North America refer to the User’s Manual on

the CD-ROM) or visit our web site at: http://www.gccprinters.com

Step 1. Check Package Contents

Elite 21 Laser Printer 550-sheet Universal Paper Tray

Power Cord Toner Cartridge

Customer Kit:

Elite 21 Series CD-ROM

Elite 21 Series Getting Started Guide

Elite 21 Series User’s Manual (On CD-ROM)

GCC Warranty Registration Card

Step 2. Prepare Printer Location

Place the printer on a flat, level surface in a well-ventilated area away from direct

sunlight or areas where the air temperature and humidity can vary widely. Do not

obstruct the fan vent on the left side of the printer.

7.87”(200mm)

23.62”(600mm)

Minimum Recommended Clearances:

23.62”(600mm)

11.81”(300mm)

Top View

19.68”(500mm)

(with all options

installed)

23.62”(600mm)

Side View

Step 3. Locate Printer Parts

Front View

Rear View

Paper Output Tray Paper Exit Slot

Top Cover

Ventilation Slots

Control Panel

Front Cover

Multi-Purpose Feeder

(Tray 1)

Tray Extension

Power Switch

550-sheet Universal Paper

Tray (Tray 2)

Rear Cover

Power Cord Receptacle

Connectivity Ports

(see next page for details)

Connectivity Ports

With the printer’s all ports active

feature, all the interfaces are

simultaneously active. This means you

can connect more than one interface

at a time. You don’t have to select a

port; this feature works automatically.

Ethernet 10/100BaseT

Bi-directional Parallel

Universal Serial Bus (USB)

Step 4. Remove Tape

1. Remove packaging tape from the front

and rear covers of the printer.

Step 5. Install Toner Cartridge

1. Press down on the release button at the

top of the printer to open the front cover.

2. Remove the two orange plastic spacers

inserted in the printer by pulling them out

of the printer as shown.

Note: The toner cartridge contains a microfine plastic powder that is fused to the paper during the

printing process. If toner spills onto your skin or clothing during installation, wipe off with a dry cloth and

rinse with cold water. Hot water can fuse the toner and cause staining.

3. Unwrap the toner cartridge and remove

the protective sheet of paper from under

the front flap of the cartridge. Shake the

cartridge from side to side several times

as shown to distribute the toner.

4. Place the toner cartridge on a flat surface

and hold the cartridge securely with one

hand. Grasp and pull the sealing tape

straight out from the side of the cartridge,

as shown. Pulling the tape out at an angle

may cause it to break.

Do not shake the cartridge or subject it

to shocks once the tape is removed, as

this may result in toner leakage.

5. Position the toner cartridge as shown.

Match up the tabs on the left and right of

the cartridge with the channels within the

printer. Gently slide the cartridge into the

printer as far as it will go.

This manual suits for next models

Table of contents

Other GCC Technologies Printer manuals

GCC Technologies

GCC Technologies LaserPro StellarMark IFII Series User manual

GCC Technologies

GCC Technologies Elite 12/1200N Mounting instructions

GCC Technologies

GCC Technologies Elite XL User manual

GCC Technologies

GCC Technologies Elite XL 40 Installation and operation manual

GCC Technologies

GCC Technologies JV-240UV User manual

GCC Technologies

GCC Technologies Elite Color 16 series Firmware update

GCC Technologies

GCC Technologies Elite 12ppm Series User manual

GCC Technologies

GCC Technologies JF-2418UV User manual

GCC Technologies

GCC Technologies 16 User manual

GCC Technologies

GCC Technologies X500III User manual

GCC Technologies

GCC Technologies JF-240UV User manual

GCC Technologies

GCC Technologies Elite XL-1208S Manual

GCC Technologies

GCC Technologies Elite 12 Series Quick start guide

GCC Technologies

GCC Technologies Elite Color 16DN User manual

GCC Technologies

GCC Technologies Elite XL-1208 Installation and maintenance instructions

GCC Technologies

GCC Technologies T500 User manual

GCC Technologies

GCC Technologies Elite XL-20/1200 Mounting instructions

GCC Technologies

GCC Technologies LaserPro C180II User manual

GCC Technologies

GCC Technologies Expert Pro Series User manual

GCC Technologies

GCC Technologies Jaguar IV Series User manual

GCC Technologies

GCC Technologies 12 User manual

GCC Technologies

GCC Technologies LaserPro Spirit Series User manual

GCC Technologies

GCC Technologies Elite XL-20/600 User manual

GCC Technologies

GCC Technologies Elite XL 20ppm User manual

Popular Printer manuals by other brands

Lexmark

Lexmark 1400 Series Manual

Canon

Canon i70 Series quick start guide

Evolis

Evolis Elypso user guide

Kyocera

Kyocera FS-9530DN specification

Canon

Canon LASER SHOT LBP-1210 Specifications

Samsung

Samsung BIXOLON SRP-350plusF user manual

Canon

Canon PIXMA PRO-1 Series Getting started

Canon

Canon PIXMA G3560 Online manual

Dell

Dell Color Laser Printer 2130cn user guide

Tektronix

Tektronix Phaser 840 user guide

Epson

Epson ET-7750 Programming guide

Canon

Canon CLBR 460ps Service manual

Eltron

Eltron P210 Guide manual

Ricoh

Ricoh MD-P1 Service manual

Epson

Epson SC-F7100 series user guide

Epson

Epson Stylus C40UX Service manual

Canon

Canon imagePASS-A2 Service guide

Canon

Canon S820D user guide