Front Runner TBRA039 User manual
TBRA039_REV_A01 © 2022 FRONT RUNNER VEHICLE OUTFITTERS
front runner
TBRA039
ENG
1
Thank you for purchasing a Front Runner Pro Table Under Rack Bracket.
Before you start, take a moment to familiarize yourself with the Fitting Instructions and the included components.
Refer to Page 2 for a list of all the components, quantities and tools required.
READ ME !
IMPORTANT WARNING!
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD
RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT
RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND
DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO
INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.
Please call us if you have any questions about the installation of this product.
PRO TABLE UNDER RACK BRACKET
1 2 X YES TBRA039_002 -
2 8 X - HBM8X16 -
3 8 X - FWM8X16X1.6 -
4 8 X - NNM8 -
5 8 X - NNC8 -
6 1 X - PLRU64 -
TBRA039_REV_A01 © 2022 FRONT RUNNER VEHICLE OUTFITTERS
2
TOOLS NEEDED
FIGURE 1.1
CHECK ONLINE FOR THE LATEST FITMENT GUIDE WWW.FRONTRUNNEROUTFITTERS.COM
If you wish to mount your table at the rear of your rack, please refer to Section 2.
If your rack is mounted using a foot rail system and you wish to side mount your table, please refer to Section 3.
GET ORGANIZED
1
IN THE BOX
1 2 X Table Rack Bracket 1LH + 1RH
2 8 X M8 x 20 Hex Head Bolt
3 8 X M8 x 16 x 1.6 Flat Washer
4 8 X M8 Nyloc Nut
5 8 X M8 Nut Cap
6 1 X Velcro Tape 25mm Wide (760mm Long)
7 8 X M8 Acetal Retaining Washer
13mm
1 2 X YES TBRA039_002 -
2 8 X - HBM8X16 -
3 8 X - FWM8X16X1.6 -
4 8 X - NNM8 -
5 8 X - NNC8 -
6 1 X - PLRU64 -
2
7
3
4
5
1
1
6
Torque Wrench
TBRA039_REV_A01 © 2022 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE - REAR MOUNT
2
2.1
2.2
2.3
Working underneath and from the rear of the
rack, slide four M8 x 20 Hex Bolts (Item 2)
into the machined slots as shown (A). Press
the M8 Acetal Retaining Washers (Item 7)
onto the M8 x 20 Hex Bolts (Item 2). Loosely
secure the Table Rack Brackets (Item 1) to
the rack using M8 Nyloc Nuts & M8 x 16 x
1.6 Flat Washers (Items 3 & 4).
Space the two table slides 755mm apart
from the center of the rack as shown.
Tighten all the Nyloc Nuts.
Refer to Fitment Guide RRAC249.
Open the latch by pushing on the latch and
slide the table into position. Check that the
table has no forward/backward movement
when the latch is closed. If it does, loosen
the Nyloc Nuts (Item 4) from diagram 2.1
and adjust so that the table as no movement
in the slides when the latch is closed.
A Rack Accessory Lock (RRAC134) can be
used through the hole in the latch should
you wish to lock the table. The Velcro Tape
is not needed for rear fitment.
Place M8 Nut Caps (Item 5) over all Nyloc
Nuts (Item 4).
755mm
Rear of Rack
A
A
A
A
Tightening Torque:
M8 : 15-20Nm / 11.06 ft lb - 14.75 ft lb
Tightening Torque:
M8 : 15-20Nm / 11.06 ft lb - 14.75 ft lb
3
4
1
13mm
13mm
13mm
7
TBRA039_REV_A01 © 2022 FRONT RUNNER VEHICLE OUTFITTERS
4
FIT AND SECURE - SIDE MOUNT
3
3.1
3.2
3.3
Insert four M8 x 20 Bolts (Item 2) into the
slat as shown (B) through the machined
slots. Press the M8 Acetal Retaining Washers
(Item 7) onto the M8 x 20 Hex Bolts (Item
2). Loosely secure the Table Rack Brackets
(Item 1) to the rack using the M8 Nyloc Nuts
and M8 x 19 Flat Washers (Items 3 & 4)as
shown.
Space the two table slides 755mm apart and
center them with resepct to the cut-out in
the foot rail. Tighten all the Nyloc Nuts.
Place the Velcro Strip (Item 6) onto the lip of
the foot rail as indicated by the arrow in Fig
3.2.
Refer to Fitment Guide RRAC249.
Open the latch by pushing on the latch and
slide the table into position. Check that the
table has no forward/backward movement
when the latch is closed. If it does, loosen
the Nyloc Nuts (Item 4) from diagram
2.1 and adjust so that the table has no
movement when the latch is closed.
A Rack Accessory Lock (RRAC134) can be
used through the hole in the latch release
should you wish to lock the table.
Place M8 Nut Caps (Item 5) over all Nyloc
Nuts (Item 4).
Tightening Torque:
M8 : 15-20Nm / 11.06 ft lb - 14.75 ft lb
4
3
1
2
B
B
13mm
13mm
Use the slats appropriate to the opening
in the footrail.
TBRA039_REV _A01 © 2022 FRONT RUNNER VEHICLE OUTFITTERS
5
INSTALL OTHER VEHICLE AND RACK ACCESSORIES
6
Now's the time to visit your favorite Front Runner Dealer in person or online.
Be sure to tag us. We love to see our gear in action! #FrontRunnerOutfitters #BornToRoam
Share your adventures on:
FINISH
5
Congratulations! You did it. Take a step back and admire your work!
TABLE CARE4
Keep your table clean and sparkling with these easy care instructions:
Add a small amount of dish soap to a damp cloth. Wipe the table gently. Dry the excess moisture with a
dry towel.
This manual suits for next models
1
Table of contents
Other Front Runner Automobile Accessories manuals
Front Runner
Front Runner Toyota LAND Cruiser 100 SLIMLINE II User manual
Front Runner
Front Runner SlimSport KSFR002 User manual
Front Runner
Front Runner SSDR002 User manual
Front Runner
Front Runner FAFE001 User manual
Front Runner
Front Runner BRONCO TBRA040 User manual
Front Runner
Front Runner LASJ003 User manual
Front Runner
Front Runner RRAC210 User manual
Front Runner
Front Runner SSDR012 User manual
Front Runner
Front Runner FAJK007 User manual
Front Runner
Front Runner SSDS115 User manual
Front Runner
Front Runner RRAC203 User manual
Front Runner
Front Runner SLIMLINE II User manual
Front Runner
Front Runner SSDS113 User manual
Front Runner
Front Runner RRAC901 User manual
Front Runner
Front Runner LALD007 User manual
Front Runner
Front Runner LADD007 User manual
Front Runner
Front Runner GBHO012 User manual
Front Runner
Front Runner LALD004 User manual
Front Runner
Front Runner FSLI021 User manual
Front Runner
Front Runner RRAC137 User manual
