Frigidaire FFRE12C3Q13 User manual

READ BEFORE INSTALLING UNIT

Compact Window Mounting (10,000+12,000 BTU)

The unit isfor window mounting only.

Carefully read the installation manual before beginning.

Follow each step as shown.

Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.

Pay attention to danger and safety notices.

To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may

be exposed:

Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install

the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins offront and rear coils. To

prevent injury or strain, use proper lifting and carrying techniques when moving unit.

Carefully inspect location where air conditioner will be installed. Be sure itwill support the weight of the unit overan extended

period of time.

Handle air conditioner with care.

;_ Make sure air conditioner does not fall during installation.

+ SAVE CARTON and these INSTALLATION

INSTRUCTIONS for future reference. The carton is

the best way to store unit during winter, or when not

in use.

+ DO NOT USE ANY SCREWS OTHER THAN

THOSE SPECIFIED HERE.

• WHERE APPLICABLE, THE TOP RAIL MUST BE

SECURELY FASTENED WITH ALL FOUR (4)

SCREWS FOR SAFETY REASONS.

The top rail on your unit may already be installed. If not,

follow the steps below.

Top Rail Hardware Qty.

3/8" Screw 4

Top Rail I + Drill (If pilot holes are needed)

Before installing, the top rail must be assembled on the unit.

A. Remove the air conditioner from the carton and place on a flat surface.

B. Remove top rail from the rear of the packaging material as shown in Fig. A

C. Align the hole in the top rail with those on the top of the unit as shown in Fig. B

D. Secure the top rail to the unit with the 3/8" Screws as shown in Fig. C

Packaging _ 1

2020215A1255

LEFT + RIGHT FILLER PANEL ASSEMBLY

NOTE= Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear of (5/16").

This is necessary for proper condensed water utilization and drainage, if you are not using the Side Panels

for any reason, this pitch to the rear must be maintained!

Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels - be sure to use the proper

panel for each side. When installed, the flange for securing the panel in place to the window sill will be facing

into the room.

A. Hold the side Panel in one hand and gently pull back the center to free the open end. See FIG. 1.

B. Slide the free end '1" section of the panel directly into the cabinet as shown in FIG. 2. Slide the panel down. Be

sure to leave enough space to slip the top and bottom of the frame into the rails on the cabinet.

C. Once the panel has been installed on the side of the cabinet, make sure it sits securely inside the frame channel by

making slight adjustments. Slide the top and bottom ends of the frame into the top and bottom rails of the cabinet. See

FIG. 3.

D. Slide the panel all the way in and repeat on the other side.

FIG. I FIG. 2 "r' section FIG. 3 Top Rail

i _ [ !i [i

}

is _ i /i ti ii

;irL_ t

Bottom Rail

Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches

(584 mm to 914 mm) (FIG. 4A, FIG. 4B).

Lower sash must open sufficiently to allow a clear vertical opening of t5-1/2 inches (394 mm ). Side louvers and the

rear of the air conditioner must have clear air space to allow enough airflow through the condenser, for heat removal.

The rear of the unit must be outdoors, not inside a building or garage.

Fig. 4A

Wooden Windows

Fig. 4B

/2'

lrr

Vinyl-Clad Windows

Storm Window:

If the air conditoner is blocked by Storm Window, add wood as

shown in FIG. 5, or remove storm window before air conditioner

is installed.

If Storm Window Frame must remain, be sure the drain holes or

slots are not caulked or painted shut. Accumulated Rain Water

or Condensation must be allowed to drain out.

Storm window

frame or other

obstruction.

FIG. 5

Board

thickness as

required, for

proper pitch to

rear, along

entire sill.

Fasten with

nails or screws.

Keepafirmgripontheairconditioner,carefullyplacetheunitintothewindowopeningsothebottomoftheair

conditionerframeisagainstthewindowsill(FIG.6A&FIG.6B).Carefullyclosethewindowbehindthetoprail

oftheunit.

INSI OUTSIDE INSIDEI

WoodenWindows Vinyl-CladWindows

Extendthesidepanelsoutagainstthewindowframe(FIG.7Aforwoodenwindows),(FIG.7BforVinyl*Clad

windows).

FIG.7A FIG.7B

window

frame

Placetheframelockbetweentheframeextensionsandthewindowsillasshown(FIG.8Aforwooden

windows),(FIG.8BforVinyl*Cladwindows).

FIG.8A FIG.8B

wooden windows: Vinyl-Clad windows:

Drive locking screws:

A: For wooden windows:

Drive 112"(12.7mm) lockingscrews through theframe lock and into thesill (FIG.9A). NOTE:To prevent

window sillfrom splitting, drill 1/8"(3mm) pilot holesbefore drivingscrews.Drive 112"(12.7 ram)locking

screwsthroughframe holes intowindow sash (FIG.9B).

B: For Vinyl-Clad windows:

Drive 112"(12.7mm) lockingscrews through theframe lock and into thewindow sash (FIG.9B). NOTE:

Beforedrivingthe screws,use a drillto drill 5 holesthroughthe holesin the frame lock andframe extensions

into thewindows sashas shown ( FIG.9B).

FIG. 9A FIG. 9B /

Tosecurelowersashinplace,attachrightanglesashlockwith1/2"(12.7mm)screwasshown(FIG.10).

NOTE: It is difficult to lock the windows with the sash lock for Vinyl*Clad windows, so you can use lock by

window itself.

Cut foam window seal and insert it into the space between the upper and lower sashes (FIG. 11).

FIG. 10 FIG. 11

SEAL

Check that air conditioner is tilted back about 1/4" to 1/2" (tilted about 2° to 4° downward to the outside, see

FIG. 12A& FIG. 12B). After proper installation, condensate should not drain from the overflow drain hole during

normal use, correct the slope otherwise.

FIG. 12A

INSlDE_" ......................:_"] OUTSIDE

H--'T"-_- ...... I_T'Bottom Rail

about I

1/4"-1/2" I I

Wooden Window

._L_H=H1-H2 about 1/4"_1/2"

HI_[ H2t ] _Bottom Rail

Vinyl_Clad Window

Trim the weather seal (6"X3/4"X1/12") with a proper length,

peel off the protective backing and plug any gaps if needed

as shown FIG.13. FIG. 13

Removing the air conditioner From Window

Turn the air conditioner off, and disconnect power cord.

Remove sash seal from between windows, and unscrew sash lock.

Remove screws installed through frame and framelock.

Close (slide) side panels into frame.

Keeping a firm grip on air conditioner, raise sash and

carefully remove. ..

Be careful not to spill any condensate water while lifting

unit from window. Store parts WITH air conditioner.

This manual suits for next models

Other Frigidaire Air Conditioner manuals

Frigidaire

Frigidaire Gallery FGRQ0833U1E0 User manual

Frigidaire

Frigidaire FRA103KT1 Service manual

Frigidaire

Frigidaire FFRZ0633Q13 Owner's manual

Frigidaire

Frigidaire FAA074S7AB User manual

Frigidaire

Frigidaire FAS155K1A3 User manual

Frigidaire

Frigidaire FAS184P2A User manual

Frigidaire

Frigidaire FAH12EM2T1 User manual

Frigidaire

Frigidaire FRA122CT1 Installation instructions

Frigidaire

Frigidaire FAC083M7A1 User manual

Frigidaire

Frigidaire FFRH1822R2 Owner's manual

Frigidaire

Frigidaire FAA087S7A13 User manual

Frigidaire

Frigidaire Home Comfort FRA082AT7 Installation instructions

Frigidaire

Frigidaire FRP77ETT3R User manual

Frigidaire

Frigidaire FAS255J2A5 User manual

Frigidaire

Frigidaire FAZ08HS1A11 User manual

Frigidaire

Frigidaire ELECTRONIC CONTROL AIR CONDITIONER Owner's manual

Frigidaire

Frigidaire FRA053XT715 Owner's manual

Frigidaire

Frigidaire FAM18HS2AB User manual

Frigidaire

Frigidaire FAA063M7A1 Quick start guide

Frigidaire

Frigidaire FRS093LS1 User manual

Frigidaire

Frigidaire FRA106BU1 Quick start guide

Frigidaire

Frigidaire LRA08PZU1 User manual

Frigidaire

Frigidaire FAC085K7A7 User manual

Frigidaire

Frigidaire FGPC1044U1 User manual

Popular Air Conditioner manuals by other brands

Spheros

Spheros CC 355 instructions

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE owner's manual

Panasonic

Panasonic CS-E12HKEW operating instructions

nedis

nedis ACMB1WT7 quick start guide

Samsung

Samsung AR KV Series User & installation manual

Daikin

Daikin FCFV50A Operation manual

Fujitsu

Fujitsu Inverter ASBA30JFC operating manual

Toshiba

Toshiba RAS-M10SMUV-E installation manual

Daikin

Daikin FXLQ20MAVE Operation manual

Hitachi

Hitachi RAS-E24CAK instruction manual

CIAT

CIAT Magister 2 Series Installation, Operation, Commissioning, Maintenance

Bestron

Bestron AAC6000 instruction manual

Hisense

Hisense 7K Use and Installation Instructions

Samsung

Samsung AS09HM3N user manual

Soleus Air

Soleus Air GB-PAC-08E4 operating instructions

McQuay

McQuay MCK020A Technical manual

Webasto

Webasto Frigo Top 25 DS Instructions for use

Mitsubishi Electric

Mitsubishi Electric MSC-GE20VB operating instructions