Essence 1200 User manual
maarten@essenceelectrostatic.com
bob@essenceelectrostatic.com
This flash symbol indicates that the
outlet carrying this symbol is carrying
a dangerous voltage. This flash
symbol indicates that the outlet
carrying this symbol is carrying a
dangerous voltage.
The exclamation mark indicates that
special attention has to be given to the
indicated remark. It means pay
attention to the marked connector, be
sure its properly connected.
For Floor Standing Installations: Attach footplate for
floor-standing installations by laying speaker on a flat
surface. Leave poly bag in place except for bottom, this is
where the footplate is attached to the rails with 4 hex
screws. The footplate has small rubber feet to raise the
base off the floor ¼” (.63 cm). For optional Tip-Toes, see
below.
For Wall-Mount Installations, attach
Universal VESA Standard Wall-Mount Plate
with holes pre-drilled for the 100mm or 75mm
hole pattern. The side rails are pre-drilled and
attachment screws are provided in the kit.
There is no on/off switch, plugging them in
turns them on and they are meant to
remain on. Leave them on full time, they
draw less than 2 watts and are safe.
The speaker is safe to touch but don’t stick
tools or other sharp tools into them, there
is high voltage on the inside and you don’t
want to get shocked.
Reminder: keep them dust free with Dust-
Off, sold in spray-cans everywhere. Use
stainless steel polish on the rails and a
lightly damp soft cotton cloth on the acrylic
stators. Do not spray any liquid or polish on
the stators.
Run in time is approx. 72 hours. Thanks for
following these instructions, the full
manual will be posted at our site soon..
link
This manual suits for next models
1
Other Essence Speakers manuals
