6. WALL-MOUNTING
NB! The plugs and screws supplied with the module(s) are suitable for use in concrete
walls. If you want to install the module(s) on a different type of wall, you will need to
use different plugs and screws that match the type of wall and module weight.
a. The wall bracket is narrower than the module. The reason for this is to allow
you to adjust the position of the module sideways after installation. Therefore,
fit the wall bracket in the centre of the module width. You can then adjust the
position of the module to the left or right if required.
b. Position the bottom edge of the wall bracket 14 cm (+ 1 cm if you are using a
top board) below the desired module height.
c. Place the wall bracket in the centre of the module’s horizontal position. Use a
spirit level to make sure that the bracket is perfectly horizontal. Use a sharp
object to mark where to drill.
d. Drill holes in the wall, press in the plugs and secure the wall bracket in place
with the angled top edge facing in towards the wall.
e. Hang the module carefully on the wall bracket. You can then adjust its position
to either side by sliding the module along the bracket.
NB! Don’t forget that the module is not actually secured to the bracket – it is
simply suspended from it with its own weight keeping it in place.
