Elmo MX-P3 Use and care manual
1
Nov. 2022
MX-P3 Firmware update
[How to check MX-P3 firmware version]
1. Connect the HDMI and RGB terminals to a monitor, projector, etc., and press the MX-
P3's power button to activate the camera.
2. When the image is displayed on the monitor or projector, press and hold the button
(about 2 seconds). Menu appears on the screen.
Use the and buttons to move the cursor, and use the button to
determine the setting value. The menu is displayed as shown below. The part surrounded
by the blue line is the cursor position.
3. Select the item [FW version] from the menu.
4. Displays the MX-P3 camera firmware version.
2
【How to update firmware using SD card】
1. Unzip the downloaded firmware file to any location on your computer.
2. After unzipping, save the firmware (**.fex and ulmage) in the root of the SD card (top, no folder),
and insert the SD card into the MX-P3
3. Connect the DC cable to MX-P3. Confirm that the status display LED lights red.
4. Press the and buttons at the same time.
LED
5. The LED turns on from red to purple.
6. The firmware will be rewritten (less than 60 seconds), the status display LED will turn off, and
the camera will automatically restart.
7. When the status display LED turns red, the rewrite operation is complete.
8. Please refer to [How to check MX-P3 firmware version] and check the firmware version.
Other manuals for MX-P3
1
Table of contents
Other Elmo Document Camera manuals
Elmo
Elmo Visual Presenter HV-110u User manual
Elmo
Elmo TT-12iD Setup guide
Elmo
Elmo EV-2000AF User manual
Elmo
Elmo P100 User manual
Elmo
Elmo EV-6000AF User manual
Elmo
Elmo TT-12 User manual
Elmo
Elmo TT-12 Setup guide
Elmo
Elmo P10S User manual
Elmo
Elmo HV-5100XG User manual
Elmo
Elmo Visual Presenter EV-200 User manual
